Question

A signal is sampled at Nyquist's rate. This will ensure that the analog signal can be recovered from the samples version. If the signal before sampling is x(t)= 50cos(300t), then find out what will be sampling period or sampling interval provided sampling is done at Nyquist's rate.

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle....

A: The conductors are at the corners of right-angled isosceles triangle. So, the distance between the c...

Q: A  Horn antenna is radiating at a frequency of 5 GHz and is having an area of cross section of 90 cm...

A: Directive gain of a horn antenna can be expressed as

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and receiv...

A: The resistance and reactance of each conductors are,

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: Please see both images attatched.

A: Given parameters are,

Q: 3.40 Find Vi and V in the circuit shown in Figure P340. FIGURE P3.40 2 kn R2 V2 4 kn 2000 i 5 V 3 kn...

A: Consider the given circuit,

Q: 1-What phrase is used when a substitution is permitted for a specific item? 2-The specifications sta...

A: 1.The phrase is “Or equivalent”.

Q: Find the charge q(t) flowing through an device if the current is:(c) i(t)= 20 cos(10t + π/6)10^-6A, ...

A: Charge is defined as integral of current over a certain interval of time. The mathematical expressio...

Q: 4.12 Use the superposition principle to find voltuges V, and V in the cireuit shown in Figure P4.12 ...

A: While using the superposition theorem, take one source active for a time and replace the dependent s...

Q: 1.21 The voltage and current at the terminals of the cir- Scuit element in Fig. 1.5 are zero for t 0...

A: Part (a):Write the expression for instantaneous Power as follows:

Q: Airframe Electrical System Question: What happens to the resistance of a wire if its temperature inc...

A: Resistance – at normal temperature material opposes the flow of electric charge through them, the op...

Q: Airframe Electrical System Question: Why should solid, round conductor wire be avoided in aircraft? ...

A: Solid, round conductor wire should be avoided in aircraft because, due to flight vibration and flexi...

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

Q: For the circuit below, use superposition to find i. Calculate the power delivered to the 3-Ω resisto...

A: According to superposition theorem, the total current across any element due to all the sources is e...

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive- a...

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and f...

Q: If a 100-Ω resistor is connected across the terminals of a 12-V battery, how much is the current, I?

A: To find the value of current in resistor with the value of resistance 100Ω and a voltage of 12V appl...

Q: Electrical Engineering Question

A: (a)Any system is BIBO stable if its poles lie in left side of s-plane or its pole having negative re...

Q: perform addition  -18+j23  and 30-j15              subtraction (8-j4)-3<25             multiplica...

A: There are two ways to represent complex numbers-(1) Polar form(2) Rectangular form(1) Polar form: It...

Q: 4. If the waveform diagramed in Exercise 5.2.6 is the voltage across a 15 H inductor determine and d...

A: The voltage across an inductor is expressed as:

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: Please help with B,C, and D. Also, please make it legiable sometimes it's too small so it's blurry.

A: The internal circuit diagram for an inverting OP-amp (pratical OP-amp) is  drawn in the figure.

Q: The transfer function H(f) = Vout/Vin of a filter is shown in Figure P3. The input signalis given by...

A: For steady-state output of the filter for an any sinusoidal input signal having a filter transfer fu...

Q: Determine the impulse response of the series system S 1(t)y2(t) shown below consisting of two subsys...

A: The given cascade system consists of two linear systems.  Firstly, the convolution of each system is...

Q: I am having trouble with a Differential Amplifier problem that I attached a photo of. I must "Design...

A: For a single input single output BJT amplifier for the gain of +150 we have to make some changes in ...

Q: Please answer this exrcise with equations

A: General formula for 3-phase transformer:

Q: please help me with the question 8M

A: We can start with the truth table for input. The ASCII code corresponding to each letter from A to J...

Q: What will be the electric field associated with an electromagnetic wave having a magnetic field of H...

A: Consider that the given magnetic field as 0.25 A/m.

Q: Electrical Engineering Question

A: Given circuit is shown below –

Q: Airframe Electrical System Question: Define wire group. (Source: FAA AC 43.13-1B/2B)

A: Wire Group:  When two or more wires are installed in bundles, so that the installation is better org...

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

Q: Branch-circuit overcurrent protection devces are not required to be accessible to occupants of guest...

A: According to Article 240 (Overcurrent Protection) of National Electrical Code (NEC), each occupant r...

Q: table 1 resistor value R1 8kohms R2 8kohms R3 6kohms

A: To calculate the Rth, short circuit the voltage source.Now, Draw the circuit diagram,

Q: In the given circuit, VS is a constant voltage source and IL is a constant load current. Find the va...

A: The resistance R draws the current of  IL. Calculate the voltage drop across the resistance R,

Q: 4.8 Use the superposition principle to find voltages V V and V, in the eircuit shown in Figure P48. ...

A: Apply superposition principle to the given circuit.Step 1: Open-circuit the current source 2 mA and ...

Q: Assume that even though the supply voltages are not shown, the op-amp remains in the linear region o...

A: This is a diagram of voltage follower circuit, where output voltage will follow the input voltage pr...

Q: 8) TO give you an idea of when to use the LR and RC filters, consider the design of a first order hi...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: help

A: Given that,

Q: What will be the velocity of a TEM wave travelling through free space? Show detailed calculation.

A: The velocity of Transverse Electromagnetic (TEM) wave travelling through free space is dependent on ...

Q: (s)/V(s) Derive the transfer function, armature resistance (Rm), inductance (Lm), motor torque const...

A: Equation of Electrical circuit :

Q: what will be the output of the following meters, if the input signal is the waveform show in fig

A: The output reading of each meter should be determined.

Q: Excercise 4: Stability The Nyquist plot for some control system resembles the one shown in figure (a...

A: (a)Given that the open-loop system is stable that is open-loop pole will lie on the left half of the...

Q: Can someone help me with question 2 please? Derive  Vout(t) expression for the circuit in figure 1 a...

A: Part (A) (For circuit in Figure 1):Notice that, the value of resistance and input frequency are chan...

Q: For the circuit below: (a) Determine the value of RL to which a maximum power can be delivered. (b) ...

A: (a)  Thevenin resistance across RL can be calculated as,

Q: What is the radiation resistance of an antenna transmitting 10 kW of power and drawing a current of ...

A: The power in any dc circuit is given by the general equation of power. Hence  the antenna circuit wi...

Q: what is the maximum cover requirement in inches for direct burial UF cable installed outdoors that s...

A: Refer to “Table 300.5 Minimum Cover Requirements, 0 to 100 Volts, Nominal, Burial in Millimeters (In...

Q: Use source transformation to find vo in the circuit below. (Circuit is displayed in attached picture...

A: Consider the circuit diagram given, we can transform the voltage source with series resistor into an...

Q: 7- In the following circuit find i,o) 7- . 16 6 V 12 0

A: We need to calculate i0(t), in the following circuit:

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

Q: 1 . For input S+3 3. A linear, time invariant system has a transfer function H(s) and H(s)= xt)(ee)u...

A: The input of the given  L.T.I system is:

Q: Please help with A,B and C. Also, please make it legible sometimes it's too small so it's blurry.

A: As referenced, Gain should be in term of input and output resistance also.In this way, drawing an in...