A tea bag containing 15 grams of tea leaves with 0.7% of caffeine was used in solid-liquid extraction with 200ml of distilled water followed by liquid-liquid extraction using DCM. If 50.0mg of caffeine requires 10 ml of water and 3.0ml of DCM to be dissolved, how much caffeine can be extracted using 70.0ml of DCM? a. 4.8 x 10^-2 b. 5.7 x 10^-2 c. 3.8 x 10^-3 d. 5.8 x 10^-3

A tea bag containing 15 grams of tea leaves with 0.7% of caffeine was used in solid-liquid extraction with 200ml of distilled water followed by liquid-liquid extraction using DCM. If 50.0mg of caffeine requires 10 ml of water and 3.0ml of DCM to be dissolved, how much caffeine can be extracted using 70.0ml of DCM? a. 4.8 x 10^-2 b. 5.7 x 10^-2 c. 3.8 x 10^-3 d. 5.8 x 10^-3

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 109AE: Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray...

See similar textbooks

Similar questions

11. How much caffeine can be extracted using 50.0ml of DCM if a tea bag contains 15 grams of tea leaves with 0.9% of caffeine? And has undergone solid-liquid extraction with 100ml of distilled water followed by liquid-liquid extraction using DCM. The solubility of caffeine requires 15 ml of water and 2.0ml of DCM for 40.0mg. a 6.1 x 10^-5 b 6.0 x 10^-5 c 7.0 x 10^-5 d 7.1 x 10^-5
From a 10-mL sample, a 1-mL aliquot was taken and diluted to 100mL. From this, a 5-mL aliquot was taken and diluted to 20mL.The final 20mL was found to have a concentration of 0.004M analyte X.What is the concentration of analyte X in the 10-mL sample?
When a solution of 1.00 g of ‘X’ in 100 ml of water was shaken with 10 ml of diethyl ether, 0.60 g of X was transferred to the solvent (ether) layer. When another solution of 0.5 g of ‘X’ in 100 ml of water was shaken with 5 ml of petroleum ether, 0.3 g of X was extracted by the solvent. Which of these ethers is a better solvent? Justify your answer using calculations.
1 gram of a substance is soluble in 100 mL of cold acetone and in 25.0 mL of boiling acetone. A student performed recrystallization starting with 0.220g of the same crude substance dissolving it in 5.0 mL of acetone. What is the maximum percent recovery of the substance?
How can you prepare a set of solutions with concentrations spanning several orders of magnitudes? a. serial dilution b. crystallization c. dehydration d. high-performance liquid chromatography
To quantify the amount of ethanol in a beverage, a technician prepared the first solution which contained 4.90 grams unknown, 1.00 grams acetonitrile, and 4.10 grams water. After the GC analysis which reported the peak areas of 5,742 for ethanol and 3,829 for acetonitrile, the technician added 0.20 grams ethanol to the first solution and ran the GC analysis again. This time, the peak areas of 6,382 for ethanol and 3,709 for acetonitrile for solution 2 were obtained. What was the percent by mass ethanol in the original beverage?
4g 5 g 2 g 100 g 49." R Lactic acid Salicylic acid Trichloroacetic acid Flexible collodion qs ad Sig: wart remover. Use as directed. (a) Flexible collodion contains 20% w/w camphor and 30% w/w castor oil. How many grams of each would be contained in 30 g of the mixture? (b) The specific gravity of castor oil is 0.955. How many milliliters of the oil is contained in 30 g of the mixture? (c) If the specific gravity of the mixture is 0.781, what are the percent w/v con- centrations of lactic acid, salicylic acid, and trichloroacetic acid in the mixture?
19 g of unknown organic sample was dissolve in 640 mL of Dicloromethane (DCM). The boiling point of benzene was increased by 3.78oC. Determine the molecular weight of the unknown sample? Kb of DCM = 2.42oC/m Bb of benzene = 39.6 oC density of benzene = 1.33 g/mL at 25 °C Round your answer to the nearest whole number, no units required.
4 litres of water obtained from a borewell in Vellore contains FeSO4 = 30.4 mg; CaSO4 = 13.6 mg; MgCl2 = 38 mg; Ca(HCO3)2 = 32.4 mg; Mg(HCO3)2 = 14.6 mg and NaCl = 11.7 mg. Calculate temporary, permanent and total hardness of the water sample in ppm. (Atomic masses of Fe = 56; Ca = 40; Mg = 24 and Na = 23)
Below are the gas chromatography results of two separate distillations of the same 1:1 mixture of ethanol and 1-butanol. One sample was obtained from the first fraction of a simple distillation and one sample was obtained from the first fraction of a fractional distillation. Identify the peaks in the chromatographs. Discuss the conclusions you can make regarding simple distillation compared with fractional distillation. Which method was more successful?
1. What is the MW of the analyte?2. What is the meq of the analyte?3. What will be the weight (in grams) of the analyte if the standardization is to be quartered?4. What will be Normality of the solution if 7.5ml of the titrant was consumed in the standardization?5. What is the average Normality if two or more trials were conducted with the values of 0.102N and 0.105N?
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample. The stated should be 104.5, how??