Question
Asked Nov 26, 2019
2 views

A transmission line of 50 ohm characteristic impedance is terminated with a load of 200 ohm resistance. What will be the value of the minimum impedance measured on the line?

check_circle

Expert Answer

star
star
star
star
star
1 Rating
Step 1

The theory of transmission line states that if the value of the load impedance (ZL) is having a higher value then the characteristic impedance (Z0) of the transmission line, then the value of the minimum impedance measure at any point on the line will be

help_outline

Image Transcriptionclose

> (1) ZL

fullscreen
Step 2

In this case, the values of the load impedance (ZL) and the characteristic impedance (Z0) of the transmission line are given as

...
help_outline

Image Transcriptionclose

Z 200 Zo =50 2

fullscreen

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by student like you
Show more Q&A
add
question_answer

Q: explain in detail aplease

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

question_answer

Q: Excercise 1: Controller design. The block diagram for an aircraft's attitude control system is shown...

A: As per the BNED guidelines, first three sub-parts only solved in below steps. Kindly repost the ques...

question_answer

Q: About Exercise 4.5.1 Rf ww а R2 R4 b In the circuit of the figure above, a bridge circuit is connect...

A: (a)Consider that the current flowing through the upper loop is i1 and the current through the lower ...

question_answer

Q: 4. Describe with the help of a diagram how differential pressure transmitter can be used to measure ...

A: Hey, since there are multiple questions posted, we will answer first question. If you want any speci...

question_answer

Q: Two complex numbers are given as   E=3+j4 and F=4+j3   Express E*F in polar form.

A: Any complex number having a rectangular form x=a+jb can be expressed in polar form with the magnitud...

question_answer

Q: Q.1 [Fourier Transform] Find the Fourier trans form, X(w), of each of the following signals x(t): Hi...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

question_answer

Q: What will be the value of thermal voltage for Ge at 400 K? Show detailed calculation please.

A: The thermal voltage (Vt) for any semiconductor is defined in the following way:

question_answer

Q: Exercise: For the circuit of Figure 3 with the parameters of Table 3, what is the time constant asso...

A: The given circuit is series RL circuit, the time constant of this circuit is given by:-

question_answer

Q: Define and explain CMRR of an operational amplifier.

A: An operational amplifier (op-amp) has two input terminals: the inverting and the non-inverting termi...