Answered: A wooden plank is 5.00 m long and…

A wooden plank is 5.00 m long and supports a 75.0 kg block 2.00 m from one end. If the plank is uniform with mass of 30.0 kg, how much force is needed to support each end?

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section8.3: Equilibrium

Problem 40PP

See similar textbooks

Related questions

Q: A uniform drawbridge must be held at a 41.0° angle above the horizontal to allow ships to pass…

Q: In the figure, one end of a uniform beam of weight 150 N is hinged to a wall; the other end is…

A: Free body diagram:

Q: In the figure, one end of a uniform beam of weight 390 N is hinged to a wall; the other end is…

A: Given,Weight of the beam, W = 390 Nangle, θ = 32°

Q: Determine the magnitude of force at the pin A and in the cable BC needed to support the 500-lb load.…

Q: The cantilevered beam is supported at the fixed support A as shown in Figure Q3.1. 6 kN 130 1 30°…

Q: Two people carry an 800 N load with a lightweight pole that is 4.0 m long. The load is placed 1.5 m…

Q: A non-uniform bar weighs 400N and is 4m long. When it is supported by a fulcrum at its midpoint, a…

A: The center of gravity of a body is a point where the weight of the body acts and total gravitational…

Q: Answer must be according the correct signifcant numbers.

A: Given that: Length of the strut is 5 m.

Q: The horizontal boom supporting a lamp is of uniform construction and weighs 50 N. If the lamp…

Q: A cable has a diameter of 0.949 mm. The cable stretches 0.658% of its original length, when a mass…

Q: The uniform beam below weighs 572N. If the rope can support 915N, what is the maximum value of w?…

Q: A 30 m long weightless beam has an 82 kg mass resting on one end and a 64 kg mass on the other end.…

Q: A gymnast with mass 46.0 kg stands on the end of a uniform balance beam as shown in the figure. The…

A: Concept Apply the torque concept Torque=Distace*Force

Q: A uniform stick can be balanced on a knife edge 10cm from one end when a load of 200N is hung from…

A: (a)initial condition200×0.1=mg(x-0.1).........(1)next…

Q: A door has a height of 2.2 m along a y axis that extends vertically upward and a width of 0.803 m…

Q: A child with a mass of 46 kg sits at a distance of 2.0 m from the pivot point of a seesaw. Where…

Q: A uniform beam of weight 39 N and length 6.0 m is mounted by a small hinge on a wall at it left end.…

Q: A 16m long bridge weighing 5000N is supported by two pillars, each located 2.0m from each end. If a…

A: Consider the Free Body Diagram of the system. Here two pillars are denoted as A and B with forces F…

Q: An 8-m board of negligible weight is supported at a point 2 m from the right end, where a 50-N…

A: Length of board (L) = 8 m Pivot point = 2 m from right end First weight (w) = 50 N (at right end)…

Q: A horizontal plank 4.64 m long and having mass 23.0 kg rests on two pivots, one at the left end and…

Q: A 60 kg uniform board 2.4 m long is supported by a pivot d%380 cm from the left end. How far from…

Q: You find that it takes a force of 275 N to open a door when you apply that force at a 90°…

A: When we apply force on a hinged door, we set the door into circular motion. The door is set into…

Q: A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin…

A: Given, Length of beam, L=8 m Person's separation from wall, l=2 m Angle b/w beam & cable, θ=53∘…

Q: A 300N child sits on the left side of a see-saw 1.5m from the center. Where should a 375N be placed…

A: Given, F1=300 N r1=1.5m F2=375 N Let r2 be the distance where 375 N is placed.

Q: A uniform plank of length L=2.7m and weight W =735N is supported by three ropes as indicated in the…

A: Given information: The symbols have the same meaning as given in the question.

Q: Jack and Rose are carrying a uniform rod that is 3.00m long and weighs 160.N. If Rose lifts at one…

A: Given:- The jack and rose are carrying a uniform rod of length L = 3 m The weight of the rod is…

Q: A uniform plank of length L=2.7m and weight W =735N is supported by three ropes as indicated in the…

Q: A slightly simplified view of the arm has the hinge at the elbow, the bicep attaching to the bone…

A: Given Data: The distance of bicep from hinge is x = 2.5 cm. The distance between weight and hinge…

Q: A person with a mass 55.0 kg stands d = 1.90 m away from the wall on a x = 5.70 m beam, as shown in…

A: First draw the FBD of the rod and resolve the tension in X and Y direction and also take the…

Q: A slightly simplified view of the arm has the hinge at the elbow, the bicep attaching to the bone…

Q: A uniform 400 N beam of length L = 4 m is supporting a 2000 N box as shown. Find the tension in the…

A: Given

Q: A 60-kg object is attached to one end of a steel tube 2.40 m long whose mass is 40 kg. The distance…

A: Given data The mass of the object is P = 60 kg The length of the steel tube is l = 2.40 m The mass…

Q: B 15. 25 KN 30

Q: Two people are carrying a uniform wooden board that is 3m long and weighs 160N. If one person…

Q: A worker of weight 772.7 kg stands on the end of a beam of weight 1693 N and length L= 119.7 m,…

Q: A unitorm 400 N beam of length L = 4 m is supporting a 2000 N box as shown. Find the tension in the…

A: Given: L=4m W_beam = 400 N W_box=2000 N

Q: A uniform beam has a length of 17.7 m and a mass of 39.6 kg. The beam is horizontal and resting (in…

Q: A 60 kg uniform board 2.4 m long is supported by a pivot d=80 cm from the left end. How far from the…

A: mass of board = 60 kg Length of board = 2.4 m d = 80 cm = 0.8 m mass of child = 38 kg

Q: A uniform wooden plank weighs 5.0 kg/m is 12.0 m long. If a 50.0 kg load is hang 2.2 m from the left…

Q: the uniform beam has a mass of 65 kg and a total length of 3 cm the beam is supported by a pivot…

A: given: m=65 Kg r=2.45 m g=9.8 ms2 In this system torque will be acting because moment of force…

Q: In the figure, a 10.0-m long bar is attached by a frictionless hinge to a wall and held horizont by…

Concept explainers

Center of Gravity of a system

The centre of gravity is a property that is based on the geometry of a rigid body or any particle. It is described as an equilibrium point or a hypothetical location where the total weight of the body is concentrated.

Question

A wooden plank is 5.00 m long and supports a 75.0 kg block 2.00 m from one end. If the plank is uniform with mass of 30.0 kg, how much force is needed to support each end?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
The uniform seesaw shown below is balanced on a fulcrum located 3.0 m from the left end. The smaller boy on the right has a mass of mass of 40 kg and the bigger boy on the left has a mass 80 kg. What is the mass of the board?
A 750-N person stands on a uniform board of weight 300 N and length 15 metres. The board is supported at each end. If the support force at the right end is 3 times that at the left end, how far is the person from the left end of the board?
A 9 kg weight is hanging from one end of a uniform rod of 12 m length. If the rod rests horizontally on a pole at 5.25 m from that end, what is the weight of the rod?
The 3 m long uniform plank is supported by a fulcrum at the midpoint. Where should a 45 kg student must be from the midpoint to be able to balance the plank?
The 3m long uniform plank is supported by a fulcrum at the midpoint. Where a 45kg student should must be from the midpoint to be able to balance the plank?
A uniform plank of length 5.0 m and weight 225 N rests horizontally on two supports, with 1.1m of the plank hanging over the right support. To what distance x can a person who weighs 377 N walk on the overhanging part of the plank before it just begins to tip?
A uniform horizontal board of mass 34 kg and length 4.7 m is supported at each end by vertical posts. A 62 kg man stands on the board 1.3 m from the left end. What are the forces applied to the board by the posts?
Jack and Rose are carrying a uniform rod that is 3.00m long and weighs 160.N. If Rose lifts at one end with an upward force equal to 60.0N, how far from Rose should Jack lift so that the rod will be horizontal and in equilibrium?
a steel beam of uniform cross section weighs 2.50 x 10^5 N. if it is 5.00m long. what force is neededto lift one end of it
A 3.0kg uniform pole 1.8m long is held horizontal by a hinge to a wall and supported by a cable attached to its center which forms a 45° angle with the pole. A large bird house with a mass of 6.6kg is at the end of tge pole. Find the force that the hinge exerts on the pole.