A worker grabs a 68 kg crate across a floor by Pulling on a rope inclined 17º above the horizontal. The coefficient of static friction is 0.52 and the coefficient of kinetic friction is 0.35. What tension in the rope is required to start the crate moving? OWhat is the initial acceleration of the crate?

A worker grabs a 68 kg crate across a floor by Pulling on a rope inclined 17º above the horizontal. The coefficient of static friction is 0.52 and the coefficient of kinetic friction is 0.35. What tension in the rope is required to start the crate moving? OWhat is the initial acceleration of the crate?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 63PQ: A 75.0-g arrow, fired at a speed of 110 m/s to the left, impacts a tree, which it penetrates to a...

See similar textbooks

Similar questions

At the scene of an accident, two traffic experts appear to determine which of the drivers was at fault considering that it was a highway where the speed limit is 80 km / h. The data collected in the field indicate that the vehicles stuck and skidded together a length of 25 m on the pavement whose dynamic friction coefficient is μk = 0.30. Considering that the masses of vehicles A and B are 2300 kg and 1500 kg, respectively, specify which of the cars was speeding at the moment of impact and by how much it exceeded the speed limit. Express your result in km / h for the purposes of the expertise.
A 4.45 x 104N truck is travelling at 100 km/h. If the coefficient of friction between the tires and the roadway is 0.50, whatis the minimum distance the truck will go before stopping?
How long will it take a m = 4.7 kg object traveling with an initial speed vi = 8.3 m/s to come to rest after encountering a rough surface with coefficient of kinetic friction of μk = 0.54?
A 1500 N block is in contact with a level plane whose coefficient of kinetic friction is 0.12. If the block is acted upon by a horizontal force of 250 N, what time, in seconds, will elapse before the block reaches a velocity of 14.5 m/s, starting from rest?
In the very Dutch sport of Fierljeppen, athletes run up to a long pole and then use it to vault across a canal. At the very top of his arc, a 55 kg vaulter is moving at 2.5 m/s and is 5.1 m from the bottom end of the pole. What vertical force does the pole exert on the vaulter?
A 75.0-g arrow, fired at a speed of 110 m/s to the left, impacts a tree, which it penetrates to a depth of 12.5 cm before coming to a stop. Assuming the force of friction exerted by the tree is constant, what are the magnitude and direction of the friction force acting on the arrow?
We know from studying friction forces that static friction increases with increasing normal force between the surfaces, which becomes important for vehicles traveling on icy or snowy roads that have coefficients of static friction much smaller than those of dry pavement. In particular, the greater the normal force on the drive wheels (those coupled to the engine), the better the traction. The horizontal position of the center of mass of a typical compact automobile is located 1.1 m toward the rear as measured from the front wheel axle. The wheelbase (distance from the front wheel axle to the rear wheel axle) is 2.7 m. Assume the car is stationary on level ground and has a weight of 12,000 N. Determine the total normal force on the two front tires and on the two rear tires. Which do you suppose are the drive wheels in this case?
A ball of mass m1 and a block of mass m2 are attached by a lightweight cordthat passes over a frictionless pulley of negligible mass as in 5.16a.The block lies on a frictionless incline of angle θ. Find the magnitude of theacceleration of the two objects and the tension in the cord.
In about 1915, Henry Sincosky of Philadelphia suspended himself from a rafter by gripping the rafter with the thumb of each hand on one side and the fingers on the opposite side. Sincosky’s mass was 79 kg. If the coefficient of static friction between hand and rafter was 0.70, what was the least magnitude of the normal force on the rafter from each thumb or opposite fingers? (After suspending himself, Sincosky chinned himself on the rafter and then moved hand-over-hand along the rafter. If you do not think Sincosky’s grip was remarkable, try to repeat his stunt.)
A block of mass 4.20 kg is pushed up against a wall by a force P that makes an angle of θ = 50.0°angle with the horizontal as shown below. The coefficient of static friction between the block and the wall is 0.270.
A small vochito of mass 607 kg breaks down as it climbs a hill with an angle of inclination of 17° hel. coefficient of friction between the car and the surface is 0.75. What is the magnitude of its acceleration as it moves down the ramp?
a 55 kg rock climber is in a lie-back climb along a fissure, with hands pulling on one side of the fissure and feet pressed against the opposite side. The fissure has width w = 0.20 m, and the center of mass of the climber is a horizontal distance d = 0.40 m from the fissure. The coefficient of static friction between hands and rock is m1 = 0.40, and between boots and rock it is m2 = 1.2. (a) What is the least horizontal pull by the hands and push by the feet that will keep the climber stable? (b) For the horizontal pull of (a), what must be the vertical distance h between hands and feet? If the climber encounters wet rock, so that m1 and m2 are reduced, what happens to (c) the answer to (a) and (d) the answer to (b)?