a. Identify the electrodes as Anode or Cathode. Write the correct metal for each assuming the reactions are spontaneous p. Show the direction of the electron flow. c. Show the movement of Fe3+, Ag*, K and NO3 ions d. Write the correct half reaction under each cell and label them as reduction or oxidation half

a. Identify the electrodes as Anode or Cathode. Write the correct metal for each assuming the reactions are spontaneous p. Show the direction of the electron flow. c. Show the movement of Fe3+, Ag*, K and NO3 ions d. Write the correct half reaction under each cell and label them as reduction or oxidation half

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter20: Electrochemistry

Section20.1: Voltaic Cells

Problem 8PP

See similar textbooks

Similar questions

If the cell potential is proportional to work and the standard reduction potential for the hydrogen ion is zero, does this mean that the reduction of the hydrogen ion requires no work?
For the cell: Cr|Cr3+Co2+|Co E° is 0.46 V. The same cell was prepared in the laboratory at standard conditions. The voltage obtained was 0.40 V. A possible explanation for the difference is (a) the surface area of the chromium electrode was smaller than the cobalt electrode. (b) the mass of the chromium electrode was larger than the mass of the cobalt electrode. (c) the concentration of Cr(NO3)2 solution used was less than 1.0 M. (d) the concentration of Cr(NO3)2 solution used was less than 1.0 M. (e) the volume of Cr(NO3)2 solution used was larger than the volume of Cr(NO3)2 solution used.
Consider a battery with the overall reaction: Cu(s)+2Ag+(aq)2Ag(s)+Cu2+(aq). (a) What is the reaction at the anode and cathode?. (b) A battery is dead" when it has no cell potential. What is the value of Q when this battery is dead?. (c) If a particular dead battery was found to have [Cu2+]=0.11M, what was the concentration of silver ion?
Consider a galvanic cell based on the following half-reactions: a. What is the expected cell potential with all components in their standard states? b. What is the oxidizing agent in the overall cell reaction? c. What substances make up the anode compartment? d. In the standard cell, in which direction do the electrons flow? e. How many electrons are transferred per unit of cell reaction? f. If this cell is set up at 25C with [Fe2+] = 2.00 104 M and [La3+] = 3.00 103 M, what is the expected cell potential?
An aqueous solution of an unknown salt of gold is electrolyzed by a current of 2.75 amps for 3.39 hours. The electroplating is carried out with an efficiency of 93.0%, resulting in a deposit of 21.221 g of gold. a How many faradays are required to deposit the gold? b What is the charge on the gold ions (based on your calculations)?
Consider the concentration cell in Fig. 17-10. If the Fe2+ concentration in the right compartment is changed from 0.1 M to 1 107 M Fe2+, predict the direction of electron flow, and designate the anode and cathode compartments.
If alkaline batteries were not alkaline but rather acidic (as in the older dry cell batteries), what extra difficulties could you envision with corrosion, based on reactions that are part of the table of standard reduction potentials?
A magnesium bar with a mass of 6.0 kg is attached to a buried iron pipe to serve as a sacrificial anode. An average current of 0.020 A flows between the bar and the pipe. (a) What reaction takes place at the surface of the magnesium bar? (b) What reaction takes place at the surface of the iron pipe? (C) In which direction do electrons flow between the two surfaces? (d) How many years would it take for the entire magnesium bar to be consumed?
Consider a battery made from one half-cell that consists of a capper electrode in 1 M CuSO4 solution and another half—cell that consists of a lead electrode in 1 M Pb(NO3)2 solution. (a) What are the reactions at the anode, cathode, and the overall reaction? (b) What is the standard cell potential for the battery? (c) Most devices designed to use dry-cell batteries can operate between 1.0 and 1.5 V. Could this tell he used to make a battery that could replace a dry-cell battery? Why or why not. (d) Suppose sulfuric acid is added to the half—cell with the lead electrode and some PbSO4(s) forms. Would the cell potential increase, decrease, or remain the same?
A mercury battery, used for hearing aids and electric watches, delivers a constant voltage (1.35 V) for long periods. The half-reactions are HgO(s)+H2O(l)+2eHg(l)+2OH(aq)Zn(s)+2OH(aq)Zn(OH)2(s)+2e Which half-reaction occurs at the anode and which occurs at the cathode? What is the overall cell reaction?
Consider the following standard reduction potentials: Tl+(aq)+eTl(s)Ered=0.34VTl3+(aq)+3eTl(s)Ered=0.74VTl3+(aq)+2eTl+(aq)Ered=1.28V and the following abbreviated cell notations: (1) Tl|Tl+Tl3+,Tl+|Pt (2) Tl|Tl3+Tl3+,Tl+|Pt (3) Tl|Tl+Tl3+|Tl (a) Write the overall equation for each cell. (b) Calculate E° for each cell. (c) Calculate G° for each overall equation. (d) Comment on whether G° and/or E° are state properties. (Hint: A state property is path-independent.)