ABC+ABD+ACD+BCD design the circuit using only nand gates

Q: Design BCD to Excess-3 code converter using decoder 4x16.

A:

Q: Consider the two port network as shown. The hybrid parameter h12 is al, R1 R3 12 R2 V2

A: The two port network has two terminals. Circuit currents and voltages on both terminals has to be…

Q: Find the Q-point values for the JFET network

A: JFET- Full form of JFET is  Junction Field Effect Transistor This type of field-effect transistor is…

Q: For the two-port network shown IH 1H 1 ww :2F V, V2 2F obtain the transfer function A. V2(s) / V1(s)…

A:

Q: Q.14: Find the frequency-domain values of the Y-Parameters for the two-port circuit shown? 102 5023…

A: To find the frequency domain values of the y-parameter for the two-port network as shown above in…

Q: The driving-point impedance of a one-port reactive network is given by (s² + 4)(s + 25) Z(s) = 5…

A: Given: The driving point impedance of a one-port reactive network is: Zs=5s2+4s2+25ss2+16 To find:…

Q: 11) Using standard 74xx series TIL gates, design a microprocessor output port mapped to address…

A: Given: A microprocessor output port mapped to address 6000H on an 8085 microprocessor. To find:…

Q: 102 Q.14: Find the frequency-domain values of the Y-Parameters for the two-port circuit shown? 502…

A: From the Y parameters expressions

Q: 1. In a two-port network, the output short-circuit current was measured while the source voltage at…

A: Given The source voltage at the input was 1v.

Q: | äabill (CME 446) 1 The Z matrix for the two-port network shown is j20 jo jo 3+ j2@_ Then Zh in the…

A:

Q: To support upstream and downstream data transmission, ADSL use O WDM O CDMA O TDM O FDM

A:

Q: mplement Z=A+B using NAND implementation by converting it into its SOP form first

A: OR gate is given as, Z=A+B By taking inverse, Z,=A+B,Z,=A,.B, Again taking inverse,…

Q: 0.5 ww 2. SV sv- 20 V 3 Datum ww

A:

Q: For 4-bit R-2R Ladder Network DAC , if the Vref = 5V, and R = 20 Kohm, what is the output current…

A: In this question we need to find a output current for sequence 0001

Q: 7. Minimize the following expression using a K-map F(A, B,C,D)= AB+ĀBCD+CD+ABCD draw a schematic…

A: Given  f(A,B,C,D)= AB+A'B'C'D'+CD'+A'B'C'D

Q: Specify the MCBS required for three (3) ACS, three (3) WHS and 20 (twenty) Socket outlets ? a. 20A…

A:

Q: F-A'B'C'D'+A'BCD'+AB'C'D'+ABC'D It is found that the circuit input combinations A'B'CD', A'BC'D',…

A:

Q: (VSB modulation) Explain DSB and VSB signals. (Similarities and differences). Interpret the…

A: DSB signal is stands for double sideband signal. DSB is a part of amplitude modulation. Which is the…

Q: 22 For the two port network shown below, the value of Z21 is.. * 302 V2 302 Vi 152 15 25 6.67 40 7.5

A: First we will find the z matrix of the circuit then we will find the given parameter.

Q: Implement the 2-bit binary full adder using only NAND gates Submit the ".BRD" file. Submit the…

A: NOTE:- I can only draw the circuit diagram and i'm not able to share you any link or the file, hope…

Q: Use Consensus Theorem to simplify: ad + bc'd + d' + a+bc A ad + bcd + d' B) ad + bc'd + d' (c) ad +…

A: ad'+bc'd +d'+a+bc'   equ 1The consensus X'Z+YZ=X'ZFor of ad'+d'+a+bc'd+bc'ad+d'+a+bc'dad+a.1+bc'd…

Q: For a 2 - port network, if Z11 = 50 Q, Z22 = 100 Q, Z12 = Z21 = 20 Q, find the value of Y1. %3D ㅇ…

A: Given for a two-port network, For Z parameter Z11=50 ΩZ22=100 ΩZ12=Z21=20 Ω

Q: Obtain the Y parameters for the circuit below.

A:

Q: For each of the second-order systems that follow, find 5, wn, Ts, Tp, T, and %OS.

A:

Q: 1: Choose appropriate letter a, b, c or 1. In a two-port network, the output short-circuit current…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In the two-port network shown below, y12 = y21 = 0, y11 = 2 mS, and y22 = 10 mS. Find Vo/Vs. Hint:…

A:

Q: Find the BCD sum of 370+(−250)

A: The BCD subtraction can be done by using the binary subtraction and if the result is greater than…

Q: Short Circuit forwed current gain is h21 O h11 h22 O h12 O *h21 121 1A2 O Iz O If the output port is…

A:

Q: Signals and Systems; In an LTI system, the relationship between input and output signals is as in…

A:

Q: b) Draw the FDM and TDM system. 3: Explain with aid of fir

A: For the above given question we need to draw the block diagram of FDM and TDM systems.

Q: Consider the one-port network shown below. 4202 16μF 280mH If the frequency of operation is 50HZ,…

A:

Q: Implement Z=A+Busing NAND implementation by converting it into its SOP from first.

A:

Q: * Find H parameters for the circuit 3Ω ww 82 ww 42 C42

A: From the H parameters

Q: 5 Simplify the expression f(A, B, C, D) = ABC +ACD+BCD

A: The given function is a 4 variable and it can be shown in K-map as

Q: x(1) = 3+ cos " is input to an LTI The signal system given by n y(n) = ay(n-1)+bx(n) where a<1 for…

A:

Q: for the given circuit , VDD= 50v, RD=16 k), RG=56k0, ID=1.03mA. VGS=-0.051v. Find RS.VDS +VDp

A:

Q: Design Excess 3 to BCD converter using NAND gate

A: The truth table of Excess 3 and BCD code is drawn below, Excess 3 no BCD no W X Y Z A B C D 0…

Q: Design a combinational circuit that takes a 4-bit ABCD number as input and produces the sum of the…

A: INPUT = 4-bit number (A, B, C, D) OUTPUT, Y = (AB + CD)

Q: Find the Thévenin's equivalent for the network in

A: For finding the thevinins we find the Zth and Vth across the terminals consider the loop currents I1…

Q: For the NMO circuit below, assuming the NMOS has Vt=1V, A= 0 (no channel-length modulation), and…

A: For DC analysis ground AC source and open circuit the  capacitors. Then, the required current will…

Q: Simplify the following and design a circuit using NAND gates. AB'CD+AB+ABC+ABD+ABCD

A:

Q: 12 Deduce the cross-Correlation. theorem for nonperiodic wweforms.

A:

Q: Find the frequency-domain values of the Y-Parameters for the two-port circuit shown? V2 502 10Ω -J20…

A: Solve the problem

Q: Solve for Ip and V.

A:

Q: b) In the following table state which is (are) the generation (or generations) of the cellular…

A: Given  We need to fill the table with suitable cellular generation. Find the below attachment.

Q: The leased lines are used by LAN to transfer data in a high speed O True False The IP is a…

A: Leased lines are used to transfer data more securely at high speed Leased lines are rented by some…

Q: For the following function, design a minimum 2-level NOR-NOR circuit. Draw the network. F (A, B, C,…

A: Consider the following function, design a minimum two-level NOR - NOR circuit  The NOR (NOT -OR )…

Q: Find the frequency-domain values of the Y-Parameters for the two-port circuit + shown? 11000 1 552…

A: TWO-PORT NETWORK : A two-port network is a type of electrical network (circuit) or device that has…

Q: 802 802 Find Z parameter of given 502 circuit. RL 1002 1002 100v

A: A two port network is shown below The Z parameters are also known as impedance parameters The given…

Q: QUESTION 3 For this 2-port circult, find the value of R2 if the 2-port circuit in described by the…

A: Explanation: Given that h11 = 20 ohm, h12 = 1, h21 = -1, and h22 = 25 mS = 25*10-3 S The general…

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.