Asked Sep 5, 2019

Airframe Electrical System

Question: Name five areas in an aircraft that are considered "EWIS" areas.

(Source: FAA AC 43.13-1B/2B)


Expert Answer

1 Rating

Five areas in an aircraft that are considered "EWIS" areas :

  1. Overhead cockpit area
  2. Fire-detector systems
  3. Cargo compartment fire detection systems
  4. Lavatory fi...

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in


Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by student like you

Show more Q&A add

Q: Examiner lecturer: Hawraa Qasim Date: 16/4/2018 unleridtions&Measurements Division: Electrical Engin...

A: (a) Dynamometer:This is type of measurement device that is used to measure voltage, current, and pow...


Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.39

A: Hi there!! Since there are four parts in the question, I will be answering only the first two parts....


Q: The ABCD constants of a three-phase, 345-kV transmission line are:A = D = 0.98182 + j0.0012447.B = 4...

A: Since, the given ABCD parameters for the 345 kV transmission lines are:A = D = 0.98182 + j0.0012447B...


Q: When you are converting an instantaneous current to a phasor, how does the phase angle being positiv...

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form o...


Q: Airframe Electrical System Question: What is the recommended shield coverage area for wires and cabl...

A: The recommended shield coverage area for wires and cables that are susceptible to EMI is 85% coverag...


Q: The switch in the circuit seen in fig. p7.52 has been in position a for a long time. At t=0, the swi...

A: Figure 1 shows the modified circuit when t < 0.


Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...


Q: Use source transformation to find ix in the circuit below. (circuit displayed in attachment)

A: We can transform the current source into equivalent voltage source. The value of voltage source is c...


Q: .il Verizon LTE 7:42 PM ร์ 100%- Done 3- In the following circuit find vc(t) andi,(t) given; v,(1)-2...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...