Question

Airframe Electrical

What are the two requirements for a properly formed contact/conductor crimp?

Step 1

A good quality of crimp is always desired in an electrical system. Good Crimping is always gas- tight thus it will prevent the metal from getting corroded due to moisture. The two requirements for the properly formed contact/ conductor crimps are given below:

Step 2

1- Use of a good crimping tool

Good crimper is always preferred for making perfect crimp joint. Instead of using hammers and pliers because good crimper will always create cold weld between the wire and the barrel of the c...

Tagged in

Q: For the circuit below: (a) Determine the Thevenin equivalent. (b) Find the maximum power that can be...

A: (a) According to the Thevenin’s theorem any linear complex circuit can be simplified in the form of ...

Q: How to convert the following decimal number to numbers with metric prefixes in following below?29) 5...

A: We need to convert the given numbers to numbers with metric prefixes.

Q: I need Vx, and I am supposed to use nodal analysis. I cannot seem to figure out the correct way to ...

A: To find the value of voltage (Vx) in the given circuit by using nodal analysis.

Q: At which times will Q be high? clk A) T1, T2, T3, T4 B) T2, T5 C)ll times C) D) T1 , T3, T4 Ti T23T4...

A: 1) JK flip flop truth table is given as:JKQ+00Q(no change)01010111Q’

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: i1 = 9 A, i2 = -3 A, and v1 = -4 V I need to find Vx using nodal analysis.

A: To find the voltage (Vx) in the given circuit by using nodal analysis.

Q: .il Verizon LTE 7:42 PM ร์ 100%- Done 3- In the following circuit find vc(t) andi,(t) given; v,(1)-2...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: Problem 2 (a) Apply nodal analysis to evaluate the voltages at A and B. (b) Evaluate the power deliv...

A: (a)Evaluating the value of voltages at node A and B.Applying nodal analysis at node A-

Q: i1 = -1 A, i2 = -10 A, and v1 = 15 V. I need to find Vx and iy, using nodal analysis

A: The values of current and voltage are-i1 = -1 A, i2 = -10 A, and v1 = 15 V.Mark all the node in the ...

Sorry about that. What wasn’t helpful?