Question
Asked Nov 26, 2019
4 views

I need help solving these 3 simple parts, if you can not answer all 3 parts then please leave it for another tutor, thank you.

Although not necessary, adding modifiers to datum features allows more parts to
pass inspection.
True
)False
The term drawing revision refers to any change made to a drawing after the final
approval has been given to the drawing.
True
False
help_outline

Image Transcriptionclose

Although not necessary, adding modifiers to datum features allows more parts to pass inspection. True )False The term drawing revision refers to any change made to a drawing after the final approval has been given to the drawing. True False

fullscreen
check_circle

Expert Answer

Step 1

Since there is only two question given so we are answering above two. There is no 3rd question to be answered.

(1)

A modifier shows the condition of a part or feature whenever the maximum amount of material or minimum amount of material exists within its ...

ø10.0 ±0.1
IØ0.05 MA
Modifier
help_outline

Image Transcriptionclose

ø10.0 ±0.1 IØ0.05 MA Modifier

fullscreen

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Mechanical Engineering

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you

Show more Q&A add
question_answer

Q: 6. The ventilating fan of the bathroom of a building has a volume flow rate of 30 L/s and runs conti...

A: Given:

question_answer

Q: 3.6 Determine the phase or phases in a system consisting of H.O at the following conditions and sket...

A: Note: We will answer the first 3 subparts of first question (3.6) since the exact question is not sp...

question_answer

Q: Consider three reservoirs that are TH = 473.2 K, TL = 293.2 K and TI = 277.2 K.  A Carnot heat engin...

A: Click to see the answer

question_answer

Q: I need answers to parts 10, 11, and 12, pertaining to the print provided.

A: Hii,thanks for the question but there is only 10th  question so we are answeering only 10th question...

question_answer

Q: Steam enters a nozzle operating at steady state at 20 bar, 263°C, with a velocity of 52 m/s. The exi...

A: Given data,

question_answer

Q: I need answers for problems 10, 11, and 12 pertaining to the print provided.

A: 10.In general, the reference dimension is used for information purpose only. It doesn’t have any tol...

question_answer

Q: please solve the question. i need it. atleast solve the top one.

A: The PV and TS diagram for Ericsson Cycle is shown below,

question_answer

Q: Hot water at 50 °C is routed from one building in which it is generated to an adjoining building in ...

A: Given:

question_answer

Q: I need answers to questions 1, 2, and 3 pertaining to the print provided. Note: A tutor keeps puttin...

A: If any changes in the part feature are made, the changes are recorded in the specified format in the...