Question
Asked Nov 18, 2019
34 views

I need these 2 parts answered.

Although not necessary, adding modifiers to datum features allows more parts to
pass inspection.
True
)False
The term drawing revision refers to any change made to a drawing after the final
approval has been given to the drawing.
True
False
help_outline

Image Transcriptionclose

Although not necessary, adding modifiers to datum features allows more parts to pass inspection. True )False The term drawing revision refers to any change made to a drawing after the final approval has been given to the drawing. True False

fullscreen
check_circle

Expert Answer

Step 1

Since you have posted multiple questions together and have not specified for any specific problem, we will solve the second question for you out of the two asked. To get the remaining solution, ple...

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Mechanical Engineering

Manufacturing Engineering

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you

Show more Q&A add
question_answer

Q: M4.17 Asteel shaft has a starting diameter= 15.00 mm. It is to be inserted into a hole in an expansi...

A: Refer Table, “Volumetric properties in U.S. customary units for selected engineering materials”, sel...

question_answer

Q: consider the beam shown in . EI is constant.   determine the maximum deflection of the beam. determi...

A: Show the free body diagram of the moment function of the beam’s cut segments as in Figure 1.

question_answer

Q: Ammonia enters the expansion valve of a refrigeration system at a pressure of 10 bar and a temperatu...

A: Given data:Pressure at inlet P1 = 10 barTemeprature at inlet T1 =24°CPressure at outlet P2 = 3.0 bar

question_answer

Q: Fluid A has a dynamic viscosity of 2.7 centipoise and a specific gravity of 1.73 What is the dynamic...

A: Given data as per question

question_answer

Q: Air expands through a turbine operating at steady state. At the inlet, p1 = 150 lbf/in.2, T1 = 1400°...

A: Given:At state 1

question_answer

Q: solveQ6 asap make sure the answer matches with the given answer

A: Given data as per question

question_answer

Q: A piston-cylinder device initially contains 0.07 m3 of nitrogen gas at 130 kPa and 120oC. The nitrog...

A: (a)The initial and final conditions of the process is given as:

question_answer

Q: I asked for problems 6 and 7 to be answered, but I did not get a properly structured answered as the...

A: Chamfer the edge at  45o  with 0.250” leg distance.

question_answer

Q: I need help answering problems 13, 14, and 15 pertaining to the print attatched below.

A: The print sheets attached shows the manufacturing or material part drawing of a mechanical part (her...