Question

An antenna has a loss resistance of 10 ohm. The gain and directivity of the antenna is 20 and 22 respectively. What will be the radiation resistance of the antenna?

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Mention the difference between Zener and avalanche breakdown.

A: Breakdown takes place in reverse biased p-n junction diodes. During break down, the value of the cur...

Q: See attached. I don't understand how to get important transition points in order to construct the gr...

A: (a)Referring the given figure, the n-p-n amplifier are common emitter.There are three modes for the ...

Q: Find out Z transform of the function x(n)=a--nu(n) where u(n) is the unit step function.

A: For any discrete time signal x(n), the Z transform of x(n) can be defined in the following way:

Q: A circuit comprises of two series resistors, each having a value of 10 kohms, one inductor of induct...

A: Since all the elements are in series, the circuit can be treated as a series resonant circuit.Now, f...

Q: Find vo(t) a) Using convolution integral 4 ww ร 45 2

A: As given in the question

Q: What will be the Laplace transform of x(t)=e--btu(t) with b>0. u(t) is the unit step function.

A: Laplace transform is used to convert any signal from time (t) domain into complex frequency (s) doma...

Q: What will be the Nyquist sampling interval for the following signal: y(t)=sinc(700t)+sinc(500t)

A: According to Nyquist’s sampling theorem, the Nyquist’s sampling frequency (fs) is defined as twice t...

Q: Hey could anyone help with this question? The question is from an old exam, and is already graded (a...

A: While performing a source transformation operation the voltage source with internal resistance is co...

Q: what is the minimum size of multiplexers necessary to implement a boolean function of 5 variables? A...

A: A multiplexer is a combinational circuit that selects binary information from one of many input line...

Q: 3. Find the transfer functions of the two systems on the next page. Bode Diagram 80 60 40 20 40 90 1...

A: Relative order of system It is known that the pole of the transfer function at high frequencies cont...

Q: A Si pn junction diode is operating under forward bias conduction. If the forward current is 4 mA an...

A: Using Shockley’s equation, the current (I) flowing through a p-n junction diode can be expressed as

Q: A half wave dipole antenna is having a length equal to half of the wavelength. If the efficiency of ...

A: For a dipole antenna, the value of the radiation resistance can be evaluated using the following rel...

Q: I just need part d

A: (d):The given circuit diagram is:

Q: What is the Norton equivalent of the circuit if input voltage is a periodic function as shown. Use F...

A: Assuming the given voltage source as a function x(t).Referring the given sawtooth graph with period ...

Q: This is for a parallel rlc resonant circuit 1vpk source 1khz 100 ohm resister .047 uf capacitor 100 ...

A: Parallel R, L and C circuit and its values are –

Q: n an ungrounded electrical systems with conductors installed in grounded metal raceways and enclosur...

A: In an ungrounded electrical system, there is no direct connection with the grounding electrode. Sinc...

Q: question below has been rejected as not in correct form.  This is cut and paste from my homework so ...

A:   The approach will be to convert the "a" into an equivalent rectangular form. then the required pol...

Q: MATLAB code with output- Refer Book Electromagnetic theory by Mathew. N.O. Sadiku-7th edition - Chap...

A: In this case, the group pattern of the array of isotropic elements is given as

Q: Problem 5. Use the differential equation approach to find v,(1) for t>0 in the network in Fig. 5. 20...

A: Referring the given question, the switch is closed initially,Hence, the inductor will behave as shor...

Q: the inverse laplace transform for the following function: X(s) = (5s + 2)/( s2 + (5/2)s + 1 )   i ne...

A: In the given problem. The function is rational, in which the degree of the numerator function is lin...

Q: A silicon pn junction at a temperature of 300 K has a reverse saturation current of 10 pA. What will...

A: The reverse saturation current for a pn junction diode is very small in magnitude and for every 10o ...

Q: A silicon pn junction employs NA = 2 × 1016 cm−3 and ND = 4 × 1016 cm−3. Determine the built-in pote...

A: The expression of built-in potential for a pn junction diode can be written as

Q: The radiation pattern of an antenna is given by F(x)= cos4 x with 0<x<pi/2. What will be the d...

A: Directivity is a very important antenna parameter and it can be used to determine how concentrated t...

Q: Grounding Lighting Fixtures. There are specific requirements for grounding lighting fixtures.  How m...

A: The electrical lighting fixtures need to be grounded to limit the voltage to ground on these materia...

Q: What will be the Laplace transform of the function x(t)=10u(t)? Please show me step by step solution...

A: The unit step function is defined as follows.

Q: Find Z transform of x(n)= (-0.5)nu(n)

A: For any function x(n), the Z transform is defined in the following way:

Q: Directivity of antenna radiating at 15 MHz is 2.5 dB. What will be effective aperture of the antenna...

A: Write the expression for effective aperture of the antenna.

Q: Show that when the value of the modulation index is 1, the value of the efficiency of modulation wil...

A: The efficiency of an amplitude modulated system is the ratio of the signal power (Ps) to the total p...

Q: A plane electromagnetic wave is travelling through a medium with relative permittivity of 16 and rel...

A: The velocity of an electromagnetic wave in a medium is given by

Q: The connection method from the equipment grounding conductor to the box is carefully controlled. Thr...

A: Referring the NEC code 250.148 (C), it concludes that a connection should be made between some equip...

Q: What will be the value of thermal voltage for 47oC temperature?

A: Given temperature is –

Q: 5. The switch in the circuit has been in position 'a' for a long time. At t = 0, the switch moves in...

A: Under steady state condition, the initial values of the capacitor and the inductor can be calculated...

Q: At a distance of 10 m the maximum radiated power measured is 160 mW/cm2. If the antenna is radiating...

A: If PT is the transmitted power by an antenna with a gain of GT, then the power density (Pr) received...

Q: Design a controller for a plant that has the transfer function shown below. The resulting system sho...

A: Write the transfer function,

Q: If the FNBW of a parabolic reflector antenna is 15o at 1.5 GHz then estimate the diameter of the ant...

A: For a parabolic reflector type antenna, the expression of First Null Beamwidth (FNBW) in degree can ...

Q: List the items that contribute to Earth Resistance for your grounding system and what can be done to...

A: List of the items which contribute to the earth resistance for the grounding system are named below:...

Q: Find out the Fourier Transform of the following function   x(t)=cos(4t)

A: Given function is –

Q: Explain why the voltage increases less rapidly as the DC current increases.

A: Frequency of AC voltages generated by alternators are depends upon the speed of rotation, DC field e...

Q: Solve the following problem:   Consider the system to be of LTI type.

A: Click to see the answer

Q: A telephone line having a bandwidth of 3 kHz is assigned for data communication. The SNR is 3150. Wh...

A: In practical life, all data communication channels are noisy channels and it is impossible to establ...

Q: A parabolic reflector antenna has a diameter of 2.7 m. The antenna operates at 700 MHz. Calculate th...

A: If frequency of operation of an antenna is provided, then the corresponding wavelength can be calcul...

Q: 1. For the circuit shown, the voltage У() source x(t) is the input and the current y(t) is the outpu...

A: Draw a schematic circuit diagram,

Q: What will be the value of thermal voltage for semiconductors? Estimate its value at 400 K.

A: The thermal voltage (VT) is a very important quantity and it is required to calculate the current fl...

Q: Design a class A power amplifier using an IRF530. Set Esupply = 18 Vdc, Rload = 2 Ω, ein max = 5 Vp

A: Class A power amplifier is a simplest form of power amplifier. It used a transistor only for the swi...

Q: Can anyone help? Thanks!

A: The given circuit diagram is:

Q: A 2.7 m diameter parabolic reflector is used in terrestrial low link at 7.375 GHZ. What will be the ...

A: The half power beamwidth (HPBW) and the first null beamwidth (FNBW) of a parabolic reflector antenna...

Q: What will be the region of convergence of the Z transform of the discrete time sequence x(n)=(1/3)n ...

A: Region of convergence: It is defined as the region in complex plane where z-transform of any discret...