Application of Kirchfoff's Laws 3.00 k2 d. 1 ko = 10 Q & 70.0 V 60.0 V 80.0 V R4.00 ka 2.00 ka R 1. Calculate all currents in the circuit shown. 2. Calculate the voltage drops in each of the resistors Note: It must show all the algebraic procedure in the solution of the generated equations, as well as the direction of the currents that you assumed.

Application of Kirchfoff's Laws 3.00 k2 d. 1 ko = 10 Q & 70.0 V 60.0 V 80.0 V R4.00 ka 2.00 ka R 1. Calculate all currents in the circuit shown. 2. Calculate the voltage drops in each of the resistors Note: It must show all the algebraic procedure in the solution of the generated equations, as well as the direction of the currents that you assumed.

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 34Q

See similar textbooks

Similar questions

Two batteries with emf’s of 1.5 V and 1.2 V and internal resistances of 0.50 : and 0.80 :, respectively, are connected in parallel with + terminals together. (a) Determine the current they would deliver to an external resistance of 2.0 :. Hint, this circuit is equivalent to the two loop circuit you just investigated above! Would more current be delivered if only one battery were used? If so, which one? Explain
Suppose we have 9 pieces of very fine wire made of tungsten, 0.05 mm in diameter and each 2 meters long. That's approximately the distance between your fingertips when your arms are outstretched in both directions. If the resistivity of tungsten is 5.6×10−85.6×10−8 ohm•m answer these questions. 1. What is the resistance of one of the wires, how much current will it carry if a voltage of 9 V is applied to it, and how much power will that be?
1. What happened to the voltage across the resistance box as the current through it was increased? What is the relationship between voltage and current when resistance is fixed? 2.What is the current in a 10 ohms resistor due to a potential difference of 40 V? Explain.
In your estimation would VT =IR1 + IR2 +IR3 +….. be true for all series resistive strings? Explain. Do you believe that the measured current is the same at all points of a series resistive string when a potential difference is present acrossthe circuit? Explain. Could you always expect that RT = R1 + R2 + R3 +…… in a series resistive circuit? Explain.
1. What current does a stereo receiver draw if used for 2 minutes and goes through 10 coulombs of charge? 2. How long can a flashlight run for if it draws 0.11 amps and its battery contains 10 coulombs of charge?
What is an electric current? What is the difference between conventional current and electron current? What is the difference between electromotive force and terminal voltage? How is the equivalent resistance for resistors in series computed? in parallel?
Describe how the current flowing through the resistor varied as the voltage was increased? Based on the graph, What do the slopes of the best fit lines represent? Explain Do you consider the resistor as ohmic? Why or why not?
Hi! Could you please answer the following questions? ThANKS! Q14; What does Kirchhoff's second law show? a. conservation of charge b. conservation of energy c. The sum of the currents entering a junction is the sum of the current leaving the junction d. In any closed loop, the sum of the e.m.f. is equal to the sum of the products of the current and the resistance (potential difference) Q15: For the circuit shown, the resistances are R1 > R2 > R3. What is true about the current through each resistor? a. I1 = I2 = I3 b. I1 > I3 > I2 c. I1 > I2 > I3 d. I1 < I3 < I2
The diagram below shows a circuit where R1=4 Ω, R2=6 Ω, R3=5 Ω, V1=6 Volts, V2=10 Volts, and V3=7 Volts. What is the value of I1? In solving this problem, initially pick the current directions as shown. If the actual current turns out to be in the opposite direction, then your answer will be negative. If you get a negative number, enter it as negative. I can get the equations of: I1R1+V1-I2R2+V2= 0 -V2+I2R2-V1-I3R3+V3=0 I1+I2+I3 = 0 But I dont understand how to take these equations and solve for I1. Can you please do it step by step?
Q1: Upton Chuck is riding the Giant Drop at Great America. If Upton free falls for 2.60 seconds, what will be his final velocity and how far will he fall? Q2: A wire of length 3 m and area of cross-section 1.7 × 10-6 m2 has a resistance 3 × 10-2 ohm.a. What is the formula for resistivity of the wire and what is the unit of it?b. Calculate the resistivity of the wire.Q3: A point charge of −2 μC is located at the center of a cube with sides L=5 cm. What is the net electric flux through the surface?
1.How could the elements be arranged to create a circuit with the minimum electrical resistance (to make the battery use as much energy as possible?) 2.How could the elements be arranged to create a circuit with the maximum electrical resistance (to keep the battery from using any energy?) 3.a.Which object do you think should be selected to create circuits with more resistance? b.What do you think is the relationship between the length of an object and its resistance?
What is the equivalent resistor, in units of Ohm, between the terminals a and b if you replace R1 by 4 Ohm, R2 by 1 Ohm and R3 by 5 Ohm resistor? Your result must contain two decimal places. Maximum of 5% of error is accepted in your answer.