Asll k₁=10_22 2₂ - 10/23 Rs=15123 Ry=2502 w R5=15-221 R4 = 2012 Ки Find I, RT, 13, 14, 15, V7, V2, V5 and Ptotal =15-22

Q: Which of the following is an installation requirement for the grounding electrode conductor in a…

A: ANSWER - (A,C,D) is correct                    EXPLANATION-            Option (A)- Grounding…

Q: e = v2 40 sin (10*t + 20°) %3D (i) Determine the currents i1 and iz. (ii) Calculate the current is.…

A: The given circuit diagram is shown below: It is given that: e=2×40 sin104t+20° Vor, e=56.568 ∠20° V

Q: 7. To represent a varying DC voltage from 0 to 8 volts on LED display, one of the main components…

A: ANSWER - OPTION (B) EXPLANATION =>                   Option(a) D/A…

Q: Three resistors each having a value of 100 ohms are connected in star and delta to a 440 volt three…

A:

Q: A charge q1= -2 microC is placed at the origin. Another charge q2= +4 microC is placed at x=0.35 m.…

A: Given parameters: Charge at origin, q1 = -2 uC Charge at x = 0.35 m, q2 = +4 uC Observation point…

Q: A numeric system (e.g. a numeric keypad) generates numbers 0 to 9 in binary. You are asked to design…

A: To approach for the given problem first assume some inputs to the above numeric system.Since result…

Q: The values in the schematic are: VIN = 3.5 V, R1 = R2 = 6.6 k0, R3 = R4 = 660 kn, and R5 = R6 = 6.6…

A: We need to find out output voltage for given circuit

Q: 2. For a 0.5μm process technology, for which tox= 15 nm & n = 550 cm²/s- Find Cox, Kn and over drive…

A: Solution !!

Q: Use the concept of Nodal Analysis to find the Current Vo in the circuit of Figure 6.

A:

Q: A current of 3.4 A passes a 70 mH inductor. How much energy is stored in the inductor in W? Answer:

A: Given data, Current through inductor, I=3.4 A Inductance, L=70 mH

Q: A 0 0 1 1 A B 0 1 0 1 NAND B C 1 1 1 0 C Using negative logic, convert the data in Table into 1's…

A: Logic Gates:- Logic gates, which carry out the many logical operations needed by every digital…

Q: Find the boolean expression for the logic circuit shown below.

A:

Q: 11a) Give 5 different examples of field devices can provide digital input signals to a PLC. b)…

A: a). An input device is a piece of computer hardware equipment used to provide data, and control…

Q: 3. The current through an element is shown in the figure below. Determine the total charge that…

A: A graph is shown as below. Find total charge at t= 5s.

Q: The magnetic field due to an infinitely long wire at a certain point is 'B'. If the distance of the…

A: Given: Magnetic field due to infinity long wire ,B1=B Distance between point and wire, d1=d If the…

Q: The voltage across a 81 mF capacitor is 15.4 V. How much energy is stored in the capacitor in W?…

A: Given: Capacitance, C=81 mF Voltage across capacitor, V=15.4 V

Q: 763. (NEW) This is about two points, (x1,y1) and (x2,y2), on a straight line whose slope is given in…

A:

Q: Find the energy stored in the capacitor: 20 20V (a) + Vc T

A: Given data, Given circuit diagram is,

Q: Having found a value for /2, calculate V using Ohm's law. VA VB Vs R₁ I R3 [² R₂ 1₂ RA

A: We need to find out the value of  V

Q: For the network shown in Fig. determine the following a) IB b) Icoc) VCE, d) Vc e) VB 20 V 510 k 190…

A:

Q: If an 8-bit binary number is used to represent an analog value in the range from 200 ounces to 700…

A: Step 1-->We have, analog range 200 ounces to 700 ounces Binary number(n)=8

Q: 120 v Find: 24 = 20-2 R₁ =10_22 · R3 =15_12 {R₂=15_12² 11, 12, 13, 14, 15, 16, 17 and TOTAL POWER…

A:

Q: V1 R1 www www R3 R4 R2 ww www R5 Given: V1-5 volts. R1-502, R2-3000, R3-100062, R4-5500, R5-4400 d)…

A: Solution !!

Q: Compute the Thevenin impedance and voltage for the equivalent circuit shown given that the…

A:

Q: V₁ and V₂ have been calculated so the circuit can be simplified and arranged as a potential divider.…

A: The question is calculated potential V using potential divider.

Q: To achieve 75 percent modulation of a carrier of V, 190 V, what amplitude of the modulating signal V…

A: Modulation index is given, m=75 %=0.75 Amplitude of carrier signal Vc=190 V

Q: 1. Construct a Routh table to analyze the stability of the following system, D(s) = s² + s² + 2s +24

A: Given system characteristics equation, Ds=s3+s2+2s+24

Q: Question 2 View the chart on the characteristics of electromagnetic and mechanical waves and answer…

A: The given chart is shown below:

Q: In the figure shown below, determine the power of the voltage source. 352 6A (↑) 252 ww wit 201

A: Given circuit,

Q: What logic function is being performed? Logic function:

A: The given circuit is as shown below,

Q: Find the boolean expression for the logic circuit shown below.

A: The given logic circuit is shown below:

Q: Find the y parameters for the circuit shown in (Figure 1). Take R₁ =20, R₂ =70, R = 12 , and R₂ =…

A:

Q: The neutral point of a 11 kV alternator is earthed through a resistance of 12 ohm. the relay is set…

A: We have an alternator which earthed through a resistance and we have been asked to find, Percentage…

Q: State and explain Carson's Bandwidth Frmula. Need urgently help.

A: Carson's bandwidth formula has been explained in the following section.

Q: What is the change in the bandwidth of the signal in FM when the modulating frequency increases from…

A: Given information: The modulating frequency corresponding to an FM signal changes from 12 kHz to 24…

Q: Two resistors R1=1000 Ohm and R2= 500 Ohm are connected in parallel. The total current is 10 A. The…

A:

Q: 1) A coil composed of 100 turns has an inductance of 5 mH. If the number of turns is doubled without…

A:

Q: A moving coil instrument requires 20mA and 100mV for full-scale deflection. What is the value of the…

A: Given data, Full scale deflection current Im=20 mA Full scale deflection voltage Vm=100 mV Current…

Q: Determine i, to is. i1 = Blank 1 A 12 = Blank 2 A 13 = Blank 3 A i4 = Blank 4 A i5 = Blank 5 A Blank…

A: We need to find out current for given circuit

Q: Minimise the logic function F(A,B,C,D)=IIM (1,2,3,8,9,10,11,14)-d (7,15) Use Kamaugh map. Draw the…

A:

Q: Find Norton equivalent circuit: 4Ω Μ 2 Ω t Μ + 6V ον Ξ ΦΩ Μ 4Ω Μ 300 (2 Ω Με x2V

A: Norton and Thevenin Theorems are used to convert a complex electrical circuit into a simple…

Q: The schematic below shows 3 potential dividers. You have assembled the 3 dividers on a breadboard…

A: Given: Three schematics of potential dividers with VIN=3.5 V, R1=R2=6.6 kΩ, R3=R4=660kΩ, R5=R6=6.6MΩ…

Q: Calculate the torque in newton-metre developed by a 440-V d.c. motor having an armature resistance…

A: Given data, Terminal voltage V = 440 V Armature resistance, Ra=0.25 Ω Speed N =750 RPM Armature…

Q: 1. The instantaneous value of current in an a.c.circuit at any time t seconds is given by: i-50…

A: Given data, Current equation is given as, i=50sin100πt-0.45 mA

Q: What is the required bandwidth according to the Carson's rule, when a 100 MHz carrier is modulated…

A: Given information: The carrier frequency is fc=100 MHz The modulating frequency is fm=1 kHz The…

Q: x(t)= C0 + C1*cos(w*t+phi1) + C2*cos(2*w*t+phi2) x(t)= A0 + A1*cos(w*t) + B1*sin(w*t) +…

A:

Q: 120 v Find: R₁ = 10-22 {R₂=15_2} R4 = 2012 W R3=152 11, 12, 13, 14, 15, 16, 17 and TOTAL POWER V₁,…

A: Given a circuit Asked to find Current in all elements Total power Voltage across all elements

Q: 400 V 3 phase through a 3 phase 4 wire distributor, delta connected 5 horse power is supplied to the…

A:

Q: How many different numbers can be obtained using five binary bits? 63 31 32 63

A: Given data, Number of bits n = 5

Q: 120 v FR₂=15_12² Find the V1, V2, V3, V4, V5, V6, V7 24 = 20-2 W R₁ = 10-22 · R3 =1512 R5-=25/12 R6…

A: A circuit with one dc voltage source, 7 resistances in variety combinations. we have to find out…