AvapH° (CO2) (assumed to be temperature independent): 25.12 kJ mol Using the data, calculate the saturated vapor pressure of CO2 at 0°C. To do this, the equation P = f(T) will be established using a relationship that will be recalled and integrated in detail. IV 73.8 (a) Vaporisation 5.1 1 Sublimation II -78.5 -56.4 31.1 Température (°C) Pression (bars) Fusion

AvapH° (CO2) (assumed to be temperature independent): 25.12 kJ mol Using the data, calculate the saturated vapor pressure of CO2 at 0°C. To do this, the equation P = f(T) will be established using a relationship that will be recalled and integrated in detail. IV 73.8 (a) Vaporisation 5.1 1 Sublimation II -78.5 -56.4 31.1 Température (°C) Pression (bars) Fusion

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Liquid nitrogen is stored in 0.5-m3 metal tanks that are thoroughly insulated. Consider the process of filling an evacuated tank, initially at 295 K. It is attached to a line containing liquid nitrogen at its normal boiling point of 77.3 K and at a pressure of several bars. At this condition, its enthalpy is -120.8 kJ kg-1. When a valve in the line is opened, the nitrogen flowing into the tank at first evaporates in the process of cooling the tank. If the tank has a mass of 30 kg and the metal has a specific heat capacity of0.43 kJ kg-1 K-1, what mass of nitrogen must flow into the tank just to cool it to a temperature such that liquid nitrogen begins to accumulate in the tank? Assume that the nitrogen and the tank are always at the same temperature. The properties of saturated nitrogen vapor at several temperatures are given as follows:
A hydrocarbon stream composed of 40 mol% n-butane and 60 mol% n-octane is fed at 100 kmol/h to a flash vessel operating at 5 bar and 145°C. The liquid outlet stream of the flash vessel is then sent to a distillation column with a partial condenser to further separate the components. 90% of the butane in the feed to the column is recovered in the overhead vapor product (distillate), along with small amounts of octane. The bottoms product contains octane which accounts for 75% of the octane in the fresh hydrocarbon feed (to the flash vessel). The condenser and reboiler operating temperatures are 136.7°C and 165.7°C, respectively. Determine the compositions of the liquid outlet stream of the condenser and the vapor outlet stream of the reboiler.
A vessel of capacity 0.3 m3 is insulated and divided into two sections by a partition. One section is 0.2 m3in volume and initially contains H2at 2 bar and 127°C. The remaining section initially holds N2at 4 bar and27°C. The adiabatic partition is then removed, and the gases are allowed to mix. Determine : (i) The temperature of the equilibrium mixture,(ii) The pressure of the mixture, and(iii) The change in entropy for each component and total value.cv(N ) 2 = 0.744 kJ/kg K, cv(H ) 2 = 10.352 kJ/kg Kcp(N ) 2 = 1.041 kJ/kg K, cp(N ) 2 = 14.476 kJ/kg K.
Liquid benzene is contained at 298K in a 2 cm diameter glass tube and maintained at a level 5 cm below the top of the tube, which is open to atmosphere. The following properties of benzene are given: 1) Boiling temperature is 353K at 1 atm. 2) MW of benzene is 78.108 kg/kmol. 3) hfg is 393 kJ/kg at 353K. 4) Density is 879 kg/m^3 5) Diffusivity rate (D) is 0.88x10^-5 m^2/s at 298K. Determine the following: A) The mass evaporation rate of benzene knowing that Psat is 0.145 atm and Yf at infinity is zero B) How long does it take to evaporate 0.5 cm^3 of benzene
: One mole of liquid isopropanol at 10oC is heated to isopropanol vapor at 300oC at constant pressure. Molar mass = 60.1 g/mol; Boiling point = 180.5oC; Cp (liquid) = 2.68 J/g K; Cp(vapor) = 1.54 J/mol K; ΔHvap = 44.0 kJ/mol Calculate ΔH of this process.
A mixture of 87.3 mole % methanol and 12.7 mole % isopropyl alcohol is vaporized at 101.325 kPa (absolute) until 900 moles of vapor and 100 moles of liquid in equilibrium with each other are produced. This occurs in a single-stage system and the vapor and liquid are kept in contact until equilibrium is achieved. Calculate the composition of the vapor and liquid. Note: Assume the system exhibits ideal behavior (which it mostly does), e.g. Raoult’s Law applies and an Antoine’s Vapor Pressure correlation is a sufficiently accurate model of component vapor pressure.
. A 2.50 mole sample of a perfect gas for which Cv,m = 3R/2 (assume constant over T-range) undergoes the following two-step process: (1) from an initial state of the gas described by T = 13 ºC and P = 1.75 x 105 Pa, the gas undergoes an isothermal expansion against a constant pressure of 3.75 x 104 Pa until the volume has doubled. (2) subsequently, the gas is cooled at constant volume. The temperature falls to -24ºC. Calculate q, w, ∆U, and ∆H for each step and for the overall process.
Nitrogen is to be liquefied in a simple Linde process. The feed and recycle are mixed. compressed to 64 bar, and precooled to 135K. The vapor then passes through a heat exchanger for additional cooling before beinng throttled to 1 bar. The unliquefied fraction leaves the seperator at the saturation temperature and passes through the heat exchanger, then exits at 120 K. a. What fraction of the gas is liquefied in the process? b. What is the temperature of the high pressure gas entering the throttle valve?
A system comprised of chloroform, 1,4-dioxane, and ethanol exists as a two-phase vapor/liquid system at 50°C and 55 kPa. After the addition of some pure ethanol, the system can be returned to two-phase equilibrium at the initial T and P. In what respect has the system changed, and in what respect has it not changed?
. Compatible Polymers A and B are to be blended to achieve a glass-transition temperatureof 60 oC. Tg’s of Polymers A and B are 30 and 85 oC, respectively, using an appropriateequation determine the composition of the blend.
Predict the output of energy as heat from the combustion of 1.0 dm3 of octane at 298 K and 1 bar. Its mass density is 0.703 g cm−3.
Meztiza, a beer cocktail, is prepared by mixing rum, beer, and cola. Compute the finalconcentration(%w/v) of ethanol in meztiza if 100.0 mL of beer was first mixed with 5.0 mL rum andbefore finally diluting it with cola to produce 200.0 mL of the beer cocktail. ( a beer contains about 4.50% (v/v) of ethanolfermented by yeast from sugars while rum contains about 40.0% (v/v) ethanol. Meanwhile, arubbing alcohol is also an alcohol solution which contains 70.0 %(v/v) isopropyl alcohol fermentedby a bacterium instead of a yeast)