Based on the TLC plate shown below, what was the error made? O The eluent used was too polar The sample spotted in lane 3 was too concentrated Multiple compounds were spotted in lane 3 O There is no error in this plate

Based on the TLC plate shown below, what was the error made? O The eluent used was too polar The sample spotted in lane 3 was too concentrated Multiple compounds were spotted in lane 3 O There is no error in this plate

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter89: Thin-layer Chromatography

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: What is the wavelength (in nm) of a photon if the energy is 7.41 x 10-19 J? (h= 6.626 x 10-34 J•s)

Q: Starting from the wedge-and-dash structure below, rotate the back carbon to provide the Newman…

A: Dihedral angle in Eclipsed conformation is zero degree and so this conformation have large steric…

Q: hy is it inappropriate to report yields with decimal-place accuracy (as opposed to whole numbers)?

A: Percent Yield of a reaction is always rounded of as a whole number and not with decimal place their…

Q: 16. Which of the following bases is the third strongest one? Which of the following bases is the…

Q: ЕНО N N. N р-аз РАЗРА N. OH

A: Functional group is atom or group of atom which gives special characteristics and identity to that…

Q: Balance each redox reaction in basic solution using the half reaction method. Cr₂O72- + Hg →→ Hg2+ +…

A: A question based on redox reaction that is to be accomplished.

Q: Naturally occurring chlorine is composed of two stable isotopes namely Cl 35 (75.76 %) and Cl 37…

Q: Is alcohol an acid or base?

Q: What is the mass of a cube of iron metal with sides that are 1.50 in in leagth if the density is…

Q: Please show how to calculate the J values for the proton NMR data provided.

A: In the given question we have to calculate the coupling constant (J value) of the following NMR…

Q: . Which of the compounds shown in the figure are amphoteric? I only Ill only C. I and II only d. II…

A: Amphoteric compounds are those which behave as acid as well as base, that is show dual behavior. For…

Q: When Neils Bohr created his famous model of the atom, what part of the scientific method was he…

Q: A d orbital essentially resembles: four p orbitals within the same atom two forbitals within the…

A: There are various orbitals such as p p orbital, s orbital, d orbital.s orbital is spherical in…

Q: What property of water causes pipes to break when they freeze? density of water high specific heat…

A: Here, we have to find the property of water that causes pipes to break when they freeze.

Q: KOH (concentration = 0.2205 M) is used in a titration to determine the amount of acetic acid…

A: Given : Initial volume of vinegar sample = 50 ml Volume of vinegar sample after dilution = 500 ml…

Q: Identify the oxidizing and reducing agent of the given equation: Answers should be the symbol of the…

Q: solution, find the volume (mL) of 0.9% NaCl solution. In 80 mL 5% dextrose in 0.9% Nach

Q: The concentration of oxygen at z=δ is 21 mole percent. The reaction at the surface may be assumed to…

Q: For what products is MinuteClinic a substitute?

A: We have to tell that for what products minuteClinic is a substitute .

Q: N O

A: Resonance structure is a collective representation of more than one lewis structure.It is also known…

Q: ol B HO 00 Of the compounds shown, which of the following would have the largest Rf value? O C A A…

A: Rf value I.e. retardation factor is distance traveled by solute divided by distance traveled by…

Q: The vapor pressure of water in a 1.00 mol/kg aqueous solution of urea at 20 degrees Celsius is 2.29…

A: This is a problem based on relative lowering of vapour pressure. The solution is given below.

Q: In redox reaction CIO is converted to CI in a basic solution. The balance have reaction for this…

A: The unbalanced redox equation is as follows: ClO- -----> Cl- O atoms are balanced by…

Q: A solution of permanganate contains 2.608 grams of KMnO4 per 750 mL. What is the normality of the…

Q: and D) have been discovered. These new elements undergo chemical reactions like the one shown below.…

Q: What is the solvent that is used to elute the TLC plate called? O Stationary Phase O Solvent Front O…

A: An eluting solvent seperates and moves component of mixture in column chromatography. Here we have…

Q: Why is sodium hydroxide used to test the solubility of phenol?

A: A question based on solutions that is to be accomplished.

Q: Calculate the temperature when ΔS(universe) equals to 0 for the following reaction: 2H2(g) + O2(g) →…

A: Given, ∆U = -564 kJ/mol I (work) = 7.5 kJ ∆S= 0 Reaction : 2H2(g) + O2(g) → 2H2O(l)

Q: 2 Predict the formula of the compound that form when lithium atoms react with nitrogen atoms.…

A: We know that, Atomic number of Li= 3 Atomic number of N=7 then,

Q: please show the mathematical workings for the solution

A: To determine the greatest volume, all the volume values will be converted to litres so that they can…

Q: A rigid 1 m³ tank contains nitrogen gas, initially at 10 bar, 27 °C. Heat transfer to the gas until…

A: The answer to the following question is-

Q: Provide the most stable(lowest energy) chair conformation of chlorocylohexane

A: We can draw the substituted cyclohexane in chair form which is stable form. There are axial and…

Q: 4.6 Precipitation Reactions: Exercise 4.6.2 Using the information in Table 4.6.1, predict what will…

Q: Need the following questions answered The reaction of interest:…

Q: A reaction catalyzed by a human enzyme was carried out at 20°c. If there is excess of substrate…

A: In this question, we have to choose the correct option regarding which would cause the greatest…

Q: A student reported the density for ten glass beads as d = 2.507 g / 1.22 mL = 2.054918033 g/mL…

Q: 2. Write down the electrode reactions is the following reference electrode, discuss under what…

A: The potential of an individual half-cell cannot be directly measured. But the difference between the…

Q: Consider the hypothetical reaction A+B+ 2C 2D + 3E where the rate law is A[A] At Rate == = k[A][B]²…

A: A question based on kinetics of solution that is to be accomplished.

Q: A. Supply the necessary arrows in the following equations. DON'T FORGET: a. b. C. d. H- HICI H H…

A: Here we are required to show the movement of electron from one atom to another atom.

Q: An oceanographer creates a model of a wave tank with a sand table to simulate beach erosion. What…

A: Here, the oceanographer creates the model to simulate beach erosion.

Q: Determine the ionic strength of a minimal growth medium that has the following composition: 0.150 M…

Q: 26 mg of sodium. How many atoms of sodium are found per mL of the solution? 1 oz. = 29.57 mL…

A: 1 oz = 29.57 mL

Q: the angular momentum the electron number the electron configuration the electron spin

A: There are four types of quantum numbers first is principal Quantum number (n) second is as a angular…

Q: The periodic table is the most important organizing principle in chemistry. There is a regular…

A: A question based on periodic table that is to be accomplished.

Q: Assume that all solutions are prepared at 25 degrees celsius and the solutes arr completely…

A: A beer contains about 5.50% (v/v) of ethanol that is 100 ml of beer contain 5.50 ml ethanol. So,…

Q: Use stoichiometric methods to analyze a mixture. A mixture of CaCl₂ and inert material is analyzed…

A: Here we are required to find the percentage of calcium present in the sample.

Q: what is the product after these compumds undergo a diels-alder reaction

A: Diels-Alder reaction is [4+2] cycloaddition reaction. In this reaction diene and dienophile reacts…

Q: H3C. C H2 H3C | CH HU H2C H2 C C OI CH2 CH3

A: A compound is a substance formed when two or more chemical element are chemically bonded together.

Q: Ammonium carbamate, NH4OCONH2, decomposes to produce ammonia and carbon dioxide. At 31.00 °C the…

Q: Give the name and the symbol for the amino acid H₂N-CH- CH-CH₂ CH₂ OH name: three-letter symbol:

A: Note : According to our guidelines we are supposed to answer only one question. Kindly repost other…

Question

Based on the TLC plate shown below, what was the error made?
The eluent used was too polar
The sample spotted in lane 3 was too concentrated
Multiple compounds were spotted in lane 3
O There is no error in this plate

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

i need to caluclate a rf value for the tlc plate and i really need help with showing the steps please! Reduction of 4-Nitrobenzaldehyde to 4-Nitrobenzyl Alcohol and Thin Layer Chromatography
Thin Layer Chromatography why the non-polar compounds move up the plate most rapidly (higher Rf value), whereas polar substances travel up the TLC plate slowly or not at all (lower Rf value)? Please help me explain this question! Thank you so much!
Two compounds A and B from GC on two open tubular columns contains a XY-1 (100% methyl) and a XY-2 (50% methyl, 50% phenyl), with the same diameter, thickness and length under the same experimental conditions. The retention times and peak widths are show in the Table 1.Hint: phenyl groups interact more strongly with polar groups than methyl groups. Which compound is more polar? Explain your answer
You and another student were each given an unknown compound. Both samples contained colorless material. You each used the same brand of commercially prepared TLC plate and developed the plates using the same solvent. Each of you obtained a single spot of Rf = 0.75. Were the two samples necessarily the same substance? How could you prove unambiguously that they were ily identical using TLC?
The three TLC plates below show the analysis of the same mixture of two compounds. One plate was developed in 100% DCM, one in 90:10 DCM/MeOH, and one in 80:20 DCM/MeOH. Determine which plate was developed in which solvent.
The following Rf values were computed from a normal phase chromatography experiment. Arrange them from most polar to least polar. I - 0.25 II - 0.84 III - 0.56 IV- 0.67
An unknown mixture was analyzed with TLC on a silica gel plate. Development gave two spots with Rf values of 1.0 and 0.0 respectively.a) Can you say for sure how many compounds are present in the mixture? If so, how many are there? Explain. b) If not, what additional TLC experiment(s) might be performed to determine how many components are present? Explain.
A student spots an unknown sample on a TLC plate and develops it in pentane solvent. Only one spot, for which the Rf value is 0.05, is observed. Is the un-known material a pure compound? What can be done to verify the purity of the sample?
A student spots an unknown sample on a TLC plate and develops it in dichloromethane solvent. Only one spot, for which the Rf value is 0.95, is observed. Does this indicate that the unknown material is a pure compound? What can be done to verify the purity of the sample?
How does increasing the polarity of the developing solvent affect the Rf of a compound on a silica gel TLC plate?
You spotted a mixture of three compounds, labeled A-C, on a silica plate. The resulting thin layer chromatography (TLC) plate with a mobile solvent mixture of 95 % hexanes and 5 % ethyl acetate is shown below. Which of the spots traveled the furthest up the TLC plate corresponding to spot 3?
In TLC, why does the developing solvent 3:1:1 n-butanol/acetic acid/water climb up the TLC plate so slowly?