C2. A circular pipe 1 of 480 mm diameter branches into two pipes (pipe 2 and pipe 3) of diameters 300 mm and 185 mm respectively as shown in figure below. If the average velocity of pipe 1 and pipe 3 are 5.45 m/s and 3.7 m/s and the flow rate of pipe 2 is 1/4th of water flow in pipe 1. V2 Pipe 2 D2 Pipe 1 D, Pipe 3 (3 V3 Find the following: (3 Marks) (i) Flow rate of water through pipe 1 in m3/s (ii) Velocity (V2) of pipe 2 in m/s (iii) Flow rate of water (Q3) through pipe 3 in m³/s

C2. A circular pipe 1 of 480 mm diameter branches into two pipes (pipe 2 and pipe 3) of diameters 300 mm and 185 mm respectively as shown in figure below. If the average velocity of pipe 1 and pipe 3 are 5.45 m/s and 3.7 m/s and the flow rate of pipe 2 is 1/4th of water flow in pipe 1. V2 Pipe 2 D2 Pipe 1 D, Pipe 3 (3 V3 Find the following: (3 Marks) (i) Flow rate of water through pipe 1 in m3/s (ii) Velocity (V2) of pipe 2 in m/s (iii) Flow rate of water (Q3) through pipe 3 in m³/s

Name: C2. A circular pipe 1 of 480 mm diameter branchesinto two pipes (pipe
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: C2. A circular pipe 1 of 480 mm diameter branchesinto two pipes (pipe 2 and pipe 3) of diameters300 mm and 185 mm respectively as shown infigure below.If the average velocity of pipe 1 and pipe 3 are 5.45m/s and 3.7 m/s and the flow rate of pipe 2is

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two new cast-iron pipes (ε = 0.26 mm) in series connect two reservoirs. Both pipesare 300 m long and have diameters of 0.6 m and 0.4 m, respectively. There is a valvein the 0.6 m diameter line with K = 10. The elevation of water surface in reservoir A is80 m. The discharge of 10°C water from reservoir A to reservoir B is 0.5 m3/s. Find theelevation of the surface of reservoir B. Assume a sudden contraction at the junctionand the entrance and exit is sharp.
Water at 10°C flows from a large reservoir to a smaller one through a 5-cm-diameter cast iron piping system, as shown in Fig. Determine the elevation z1 for a flow rate of 6 L/s.
A horizontal water pipe of diameter 15cm converges to7.5 cm diameter. If the pressure at the two sections are 400KPa and 150KPa respectively, calculate the flow rate of water.
The penstock of hydroelectric turbine is 0.5m x 0.5m with velocity of 5.5m/s and head of 20m. What is the output of the turbine if the turbine efficiency is 92%?
Water flows through an 8-in (ID=7.981 in) steel pipe at an average velocity of 6 ft/s. Downstream the pipe splits into an 8-in main and a 2 in(ID=2.067 in) bypass pipes. If the velocity in the bypass is twice the velocity of the main pipe, the volumetric flow rate (ft³/s) in the main pipe isA. 10.58B. 5.29C. 1.84D. 0.25
(i)Determine the equivalent pipe corresponding to three (3) pipes in series with lengths and diameters l1, l2, l3, d1, d2, d3 respectively. (ii)A jet strikes tangentially a smooth curved vane moving in the same direction as the jet, and the jet gets reversed in the direction. Show that the maximum efficiency is slightly less than 60 per cent
Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe at an average velocity of 12 ft/s. The pipe discharges into the atmosphere at a level 3000 ft above the level in the reservoir. The pipeline itself is 4500 ft. long. If the overall efficiency of the pump and the motor driving it is 70% and the cost of electric energy to the motor is 4 cents per kilowatt-hour, 5. what is the volumetric flow rate in cubic feet / sec? 2.348.193.241.989.81none of the given4.32
A reservoir supplies water through 100 m of 30-cm-diameter cast iron pipe to a turbine that extracts 80 hp from the flow. Given that Δz = 30 m. The water then exhausts to the atmosphere. Neglect minor losses. For water at 20°C, take ρ = 998 kg/m3 and μ = 0.001 kg/m-s. Take π = 22/7. In determining the flow rate of the given flow, two solutions are obtained. Are both the solutions valid? Yes or no?
A hydroelectric power generating system is shown in the figure. Water flows from an upper reservoir to a lower one passing through a turbine at the rate of 286 liters per second. The total length of pipe connecting the two reservoirs is 186 m. The pipe diameter is 346 mm and the Hazen-Williams coefficient is 129. The water surface elevations of reservoirs 1 and 2 are 194 m and 69 m, respectively. Determine the power in kW required by the turbine if it is 63% efficient? Neglect minor losses. Round your answer to 3 decimal places.
Water is flowing in a conical tube. the inlet conditions are D=100mm, v=1m/s & density = 1000kg/m3. determine the velocity of the water at the discharge point. The outlet diameter is 200mm. a. 0.18b. 0.1c. 0.5d. 0.25
A pump is being utilized to deliver a flow rate of 500 li/sec from a reservoir of surface elevation of 65 m to another reservoir of surface elevation 95 m.The total length and diameter of the suction and discharge pipes are 500 mm, 1500 m and 30 mm, 1000 m respectively. Assume a head lose of 2 meters per 100 m length of the suction pipe and 3 m per 100 m length of the discharge pipe. What is the required horsepower of the pump? **provide complete solution using bernoullis equation..provide illustration with labels like datum line and such** Show all formula derivation
For the system-Water at 20°C flows by gravity through a smooth pipe fromone reservoir to a lower one. The elevation difference is 60 m.The pipe is 360 m long, with a diameter of 12 cm. A pump, which delivers15,000 W to the water, is used at night to refill the upper reservoir. The pipe diameter is increased from 12 cm toprovide more flow. If the resultant flow rate is 90 m3/h, estimatethe new pipe size.