Calculate ia in the circuit

Q: It is a good idea to issue a clear command at the start of each new independent calculation. Select…

A: If calculation is independent then we don't bother about the previous code that we written in MATLAB…

Q: ?Which of the following protects only against over-current (äbäi 2) MCB ELCB O RCCB C Socket C

A: Given, Which of the following protects only against over current

Q: Question 1 A combinational switching network, has four inputs (a,b,c,d) and one output. The output…

A:

Q: Which of the following is not a standard used for paging systems?  IS 95 FLEX POCSAG

A: The given standards are: IS 95 FLEX POCSAG The standard which is not related to the paging systems…

Q: If an analog linear measuring instrument has linear voltage measuring function Vout = Kx + Vo for…

A: The concept of this problem lies in the definition of voltage and ground. The ground is the…

Q: The difference between the desired output and actual output of the system at infinite time is called…

A: The output is does not always meet to its final desire value..   some deviation is present between…

Q: 3) The current passing through a resistor of 50± 0.2 Qis 4 +0.02 A. Determine the limiting errors.…

A:

Q: Calculate the time constant Also Find the calculated voltage Vc

A:

Q: Chapter #3 Oscillators HW # 1 Find R and the frequency of operation [rad/sec] for the circuit below:…

A:

Q: Create a circuit using electret microphone on harvesting sound energy to convert it into electricity

A: Noise and studio signals detected by microphone which gives input to the bridge rectifier  It…

Q: -b: Draw one line ladder diagram to construct 3 input OR gate.

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Please calculate each of the circuit parameters for the provided circuit

A:

Q: 10. When connecting a meter to a circuit, particularly voltage, what is the common name of the…

A:

Q: Calculate the sensitivity

A: Given data Increase in voltage (voltmeter reading) = 10V Increase in pressure = 5.3bar Caluclation…

Q: Determine and sketch the waveform of Vo for the network of Fig 5. Using a silicon diode with V= 0.7…

A: Vo for the following circuit is determined as shown below

Q: convert to product of sums

A: We have to write the even expression in product of sum form

Q: Calculate Vo of the circuit

A: Given circuit

Q: 11/ An LED is an electronic device that converts light energy to electrical energy Select one:…

A: LED IS a light emitting diode.  It emits light using electrical energy.

Q: Mercury filled glass thermometer is used to measure very high temperature. Select one: True False

A:

Q: 5 For Passive Traducer, Requires external electrical energy source Select one: True False

A: Answer:True

Q: A JFET has three terminals, namely Select one: a. emitter, base, collector b. none of the above C.…

A: The Field Effect Transistor (JFET) is a three-terminal voltage-controlled unipolar device. In a JFET…

Q: A pressure measurement instrument is calibrated between 10 bar and 260 bar. The scale span of the…

A:

Q: DIMMs used in servers can provide additional reliability if they use what specific technology.

A:

Q: Use of lead compensator in a system will decrease the overshoot of the system. Select one: O True O…

A: Lead compensator  Improves transient response Increase the margin of stability Increase the…

Q: The standard Voltage and Current values used in practical purposes are root mean square values.…

A: The standard current and voltage are used in rms value  This statement is true or false.

Q: A set of (4 four) measurements are done for single (object length) measurement ,and recorded as (110…

A: Precision means how close a particular value is to each of the values .

Q: 7) Determine the resolution of a voltmeter which has a range readout scale with 100 divisions and a…

A:

Q: 3 smallest change in the quantity that will produce the observable change in the reading is called

A: This question is related to instrumentations. It is based on concept of some terms related to…

Q: The gases which is used to heat the air in the regenerator is called as O Hot gases O Exhaust gases…

A: ->The regenerator uses the heat from the flue or exhaust gases to raise the temperature of the…

Q: alculate : Output - 27 lakhs energy input - 5 % of output material input - 200 % of energy…

A:

Q: A power transistor is specified junction temperature of 150°C.

A: Ambient temperature- It is a atmospheric or environmental temperature of any object or device when…

Q: Electronic Measurements and Instrumentation(EMI) subject. Provide handwritten answer. WRITE THE…

A:

Q: A light detector is an electronic device that converts electrical energy to light energy Select one:…

A: We need to tell about light detector.

Q: 5. Determine the current I for each of the configurations of Fig. 155 using the approximate equiv-…

A:

Q: In a current measuring instrument, the element which converts low range instrument into high range…

A: We need tell about which winding will damage due to short circuit of potential transformer . We need…

Q: es the resistance at the output port absorb maximum power 50 IV

A:

Q: - convert each Gray code to binary:

A: Gray code is special type of code in which one bit changes at one time

Q: R 3kohms V1 R_L 20V D1 10KO 25% Key-A Vz= 8V When the varistor is set to 25%, compute the following…

A:

Q: The total turn ON time of SCR is 34 µs. If the sum of delay and spread time is 17 us time of the…

A:

Q: Calculate the total Yesistor r the cireut shown below 12 RT2

A:

Q: For the attached circuit, calculate how long Sol is energized and at which pulse its energization…

A: We explore the derivative form and integral form of the inductor i-v equation:

Q: Prob. 2 The expected voltage in a part of a circuit is 8.6v. However, the following are the actual…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. The Primary sensing element used in the given figure is

A: Temperature deflection at 40 degree Celcius = 5mm Temperature deflection at 41 degree celcius =…

Q: 1. Define an integrated circuit and classify them. Whot i n ond uuhot

A:

Q: Determine the Iab in figure 2

A: First calculate thevenin thevenin equivalent circuit from RL terminals. Thevenin equivalent circuit…

Q: The carbon and hydrogen atoms plays a major role in determining the type of the fossil fuel. Select…

A: The statement is true .

Q: Assuming the diodes are ON and modified circuit diagram is: 0.65 V R 0.65 V N oVo Ip2 R2 =1 ka 0.65…

A:

Q: Please show all steps

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.