Fluid Mechanics 6.Calculate the pressure inerease that must be applied to water to reduce its volume by 2%.7.A drop of water at 20°C is forming under a solid surface. The configuration just before separating andfalling as a drop is shown in the figure. Assume the forming drop has the volume of a hemisphere. What isthe diameter of the hemisphere just before separating?

given Change in volume = 2 % we have to find change in volume

Answered: 5. Calculate the pressure increase that…

Engineering

Civil Engineering

5. Calculate the pressure increase that must be applied to water to reduce its volume by 2%.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.26CTP

See similar textbooks

Related questions

Q: The diameter of a pipe carrying water changes gradually from 6 inches at a lower point to 18 inches…

Q: Calculate the pressure increase that must be applied to water to reduce its volume by 2%.

A: We have to Calculate the pressure increased that must be applied to water to reduce its volume by 2%

Q: A rectangular tank is 6 meters long, 1.2 meters ide and 2.4 meters deep is completely open at the…

Q: ) FIGURE 1a shows a water storage tank. If the pressure at point A is 100 kPa, what are the…

Q: If the atmospheric pressure at sea level is 10.144 N/cm2, what will be the absolute pressure at the…

A: given- atmospheric pressure Patm=10.144 N/cm2height h=3 km=3000 mdensity of air ρair=1.2 kg/m3

Q: In the figure, the pipe exit losses (1.5)v2/2g, where v is the exit velocity. What is the exit…

Q: By what percent is the volume of water decreased if its pressure is increased to an equivalent to…

A: To determine the percent decrease in volume of water for given increase in pressure and Bulk…

Q: If 150 L/s of water flows through the system shown in the figure below, calculate the pressure at 2.…

A: For the point 1 - P1 = 0, V1 = 0, Z1 = 35m For the point 2 - Z2 = 0

Q: The highest point in Australia is the top of Mount Kosciuszko in New South Wales, 7,310 ft above sea…

A: Consider the given figure.

Q: For water, starting with 1 m3 of water in a container, what is the pressure required to decrease the…

A: Given: The volume of water is 1 m3. The decrease in volume of water is 1%.

Q: Example 1: A flow of water from a reservoir to a pipe of different diameters shown in Figure below.…

Q: 18 A cylindrical tank 1.5m in diameter and 3m in height contains water to a depth of 2.5m. Find the…

A: Radius of tank (r) =0.75m

Q: A closed tank contains 0.610 m of mercury, 1.524 m of water, 2.438 m of oil of specific gravity…

A: Given data in question Height of water column 1.524 m Height of oil column 2.438 m Height of…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 3.3 meter has water on…

Q: The figure shows the water pressure acting on the sides of a dam that is 20-ft long. Determine the…

A: We will calculate the answer by using the conditions of equilibrium. Since, the given loads are the…

Q: If a vessel that contains 9.2 ft3 of water at 50°F and atmospheric pressure is heated to 160°F, What…

Q: Glycerin flows through a system composed of pipes at a rate of 7.735 m3/s, calculate the velocity…

A: WE will use bernoulli equation.

Q: Problem #1. The pressure on a closed tank reads 58.86 kPa. a. What is the equivalent height in…

Q: 6. Determine the specific gravity (s.g.) of a 2.5 m. column of liquid if its pressure in its column…

Q: What is the value of the surface tension of a small droplet of water 0.4mm in diameter which is in…

Q: Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will…

A: Solution; Given Data; For water, D=25 mm =25*10-3m V=6 m/s ρ=1000 kg/m3μ=1.3*10-3 kg/m.s

Q: 6. Calculate the pressure increase that must be applied to water to reduce its volume by 2%.

Q: Given a pressure at point A equivalent to 67 N/m^2, calculate the pressure at point B if d1=37 cm,…

A: To determine the pressure at point B. The pressure at point B can be determined by equating the…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 4.6 meter has water on…

Q: A hollow cylinder 1.22-m in diameter and 5-m long weighs 3,125 N. How many cubic meters (m) of metal…

Q: A vertical cylindrical tank with a diameter of 6 m and a depth of 2 m is filled with water to the…

A: given data : Diameter =6 mheight = 2 mγw20∘c=9.79 KN/m3γw50∘c=9.69 KN/m3

Q: Find the loss of head when a pipe of diameter 200 mm is suddenly enlarged to a diameter of 400 mm.…

Q: Calculate the energy liberated when 125 identical water drops combine together to form a big drop.…

A: given 125 identical water dropsradius of single water drop-r=0.1 mmsurface tension=0.072 N/m

Q: 1. A car ferry is essentially rectangular with dimensions of 8 m wide and 100 m long. If 60 cars,…

Q: Two chambers with the same fluid at their base are separated by a piston whose weight is 25 N, as…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 4.4 meter has water on…

Q: 11. If the pressure at a point is 1m of water, what will be it's value in terms of m of oil? (Take,…

Q: Open to atmosphere, pa hi= 38cm -Mercury (13,593 kg/m³) Water h,=76 cm B and C are at the same…

A: Atmospheric pressure- It is the pressure exerted by the atmosphere and it is measured by Barometer.…

Q: 1)estimate the resulting pressure at the bottom of the tank in kilo pascals 2)estimate the resulting…

Q: Water is flowing into a vertical cylindrical tank at the rate of 24 cu. ft. per min. If the radius…

A: solution water flowing in the vertical cylindrical tank at rate of Q = 24cu.ft /min radius of the…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 3.9 meter has water on…

A: Given Data:a=2.5md=3.9mTo find:Location of center of pressure along with the inclination.

Q: Please provide an explanation for every solution. Problem: A bottle consist of a cylinder 35 cm in…

Q: What is the absolute pressure inside the tank after it was submerged in a liquid if the volume of…

A: Given data Percentage volume change Atmospheric pressure To find Absolute pressure

Q: *if the surface tension at air-water interface is 0.069 N/m, what is the pressure difference between…

A: Given data : Surface tension (σ)=0.069 N/mdiameter (d)=0.009 mm

Q: Calculate the pressure difference between the centers of tanks A and B. If the entire system is…

A: The dimensions of a tube are given . The relative density of fluid are given . The density of fluid…

Q: A vertical cylindrical tank has an orifice for its outlet. When the water surface in the tank is 5 m…

A: Initial height of water = z1 = 5m Initial pressure = P1 = 1 atm = 1.01x105 N/m2 Initial time = t1 =…

Q: Calculate the hydraulic power of a pump (kW) that transfers water at 300 m3/hr to a tank at an…

A: Given values for the numerical are: Discharge of the pump, q= 300 m3/hr Elevation of the tank= 11m…

Q: A pressure gage 10.52 m. above the bottom of a tank containing a liquid reads 58.5 kPa; another gage…

A: Using pressure variation equation the value of density can be easily determined. Knowing the…

Q: Suppose that a fluid with a density of 1000kg/m3 flowing through a horizontal pipe at a speed of…

Q: As illustrated in the figure, an inclined circular gate with a diameter of 3.9 meter has water on…

Q: A water pipe having a 2.33 cm inside diameter carries water into the basement of a house at a speed…

Question

Fluid Mechanics

6.
Calculate the pressure inerease that must be applied to water to reduce its volume by 2%.
7.
A drop of water at 20°C is forming under a solid surface. The configuration just before separating and
falling as a drop is shown in the figure. Assume the forming drop has the volume of a hemisphere. What is
the diameter of the hemisphere just before separating?

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Heating, ventilation and air-conditioning

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a triangle of height d and base b is vertical and submerged in liquid with its vertex at the liquid surface (see Fig. 2), derive an expression for the depth of its center of pressure. a) ?/2 b) 4?/3 c) ?/4 d) 3?/4 e) ?/3
the hemispherical dome ABC is submerged to a fluid with specific gravity of 0.88 as shown in the figure. How far from A, in m, is the location of the vertical component of the resultant hydrostatic force acting on the dome?
A spherical wooden ball S ft. Diameter is used as a float for a boat. If the ball sinks to a depth of (7+S) in. Find the area of the wetted surface. S=10
A slurry behaving as a pseudoplastic fluid is flowing through a smooth round tube having an inside diameter of 5 cm at an average velocity of 8.5 m/s. The density of the slurry is 900 kg/m3 and its flow index and consistency index are n=0.3 and k=3.0Ns0.3/m2. Calculate the pressure drop for 50 m length of vertical pipe with the flow moving against gravity.
X = 8 m, Y= 6 m, and Z = 3 m, what is the pore water pressure at point C to the nearest decimal? (assume hydrostatic water and the unit weight of water is exactly 9.8 kN/m3).
A block (unit weight = 19.5 kn/m^3) 0.50m square and 382mm deep floats on a stratified liquid composed of 200mm layer of water above a layer of mercury (s.g. = 13.6) If a downward force of 1200 N is applied to the center of mass of this block, what is the new position of the bottom of the block relative to the mercury surface in mm?
2.A vertical triangular surface has a horizontal base of 3 m and an altitude of 4.5 m, the vertex being below the base. If the center of pressure is 15 cm. below the center of gravity, how far is the base below the liquid surface?
A tank shaped in a frustum of a cone has a lower base radius 1 m, upper base radius 0.50 m and an altitude of 10 m. It is filled with water to a depth of 4 m. The water is then transferred to a spherical tank with radius 5 m. What is the depth of the water in the second tank in meter?
A uniform body of size 4 m long x 2 m wide and 1 m deep floats in water. Determine the metacentric height in meters. a.0.355 m b.0.1017 m c.0.534 m d.0.316 m
1. If the body starts from rest at A and slides 200 ft down the 30° incline, how far will it then move along the other incline? What will be the velocity when it returns to B? Coeff fr= 0.20. show complete solution and free body diagram.
4. A reservoir supplies water to a horizontal 6′′ pipe 800 ft long. The pipe flows full and discharges into the atmosphere at the rate of 2.23 cfs. What is the pressure in psi midway in the pipe, assuming the only lost head is 6.20 ft in each 100 ft of length? indicaye free body diagram
An open tank 3m by 3m in horizontal section weighs 4 kN and contains water to a depth of 1m. It is acted by an unbalanced force of 18 kN parallel to the pair of sides. a) Determine the acceleration of the tank. b) What must be the height of the tank so that no water will spill out? c) If the acceleration is increase by 4m/s2 , how much water will spill out?