Connect the centre tapped full wave rectifier with resistive load (RL=1KΩ) and set the parameters value of peak amplitude equal (220) volt, frequency equal (50) HZ . 2-Connect the capacitor filter of 0.5 μf across the load 3- Draw the output waveform for the DC output and the r.m.s value of the output voltages. 4- Calculate ripple factor value of the output voltage.

Question

1- Connect the centre tapped full wave rectifier with resistive load
(RL=1KΩ) and set the parameters value of peak amplitude equal (220) volt,
frequency equal (50) HZ .
2-Connect the capacitor filter of 0.5 μf across the load
3- Draw the output waveform for the DC output and the r.m.s value of the
output voltages.
4- Calculate ripple factor value of the output voltage.

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Analog Electronics

Communication System

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: 1. In order to have sparkless commutation, the brushes should be placed along... 2. D.C. series moto...

A: Sparkless commutation means that there is no energy waste in spark at the contacting surface of movi...

Q: Convert the point (3,4,5) from Cartesian to spherical coordinates O (0.707,54°,63º) O (7.07,45°,53º)...

A: Click to see the answer

Q: Q2: A 4 pole ,d.c. shunt generator with a shunt field resistance of 50 ohm ,and armature resistance ...

A: Given data: ϕ=Flux per pole = 20 mWbP=4N=900 rpmZ=400A=4 Calculate the voltage generated by the DC s...

Q: A rod of length L=0.65m is placed along the x-axis from x=0 to x=L. The rod carries a uniform linear...

A: The distribution is shown below:  A.  The expression for the infinitesimal charge along the rod in ...

Q: Fill in the following blanks 3.The self-induction of acoil undergoing commutation causes..........at...

A: 3. .The self-induction of a coil undergoing commutation causes produce reactance voltage at the brus...

Q: Q2: A 4 pole ,d.c. shunt generator with a shunt field resistance of 50 ohm ,and armature resistance ...

A: GIVEN: POLE=4 , LAP CONNECTED A=P, RSH=50 OHM,RA=1 OHM, CONDUCTORS Z=400, FLUXPER POLE =20 mWB, N=90...

Q: 1- Connect the Diode Characteristics circuit with a 800 resistor and anvariable AC input voltage sou...

A: Click to see the answer

Q: 1- Connect the centre tapped full wave rectifier with resistive load(RL=2KΩ ) and set the parameters...

A: Click to see the answer

Q: Please show the steps

A: The given system is a combination of gear trains. The equivalent value of θL at armature side can be...