Consider the following observations on shear strength (MPa) of a joint bonded in a particular manner. 22.0 40.4 16.4 73.0 36.6 109.6 30.0 4.4 33.1 66.7 81.5 (c) How large or small does an observation have to be to qualify as an outlier? (Round your answers to one decimal place.) MPa MPa below above How large or small does an observation have to be to qualify as an extreme outlier? (Round your answers to one decimal place.) below MPa above MPa (d) By how much could the largest observation be decreased without affecting f?

Consider the following observations on shear strength (MPa) of a joint bonded in a particular manner. 22.0 40.4 16.4 73.0 36.6 109.6 30.0 4.4 33.1 66.7 81.5 (c) How large or small does an observation have to be to qualify as an outlier? (Round your answers to one decimal place.) MPa MPa below above How large or small does an observation have to be to qualify as an extreme outlier? (Round your answers to one decimal place.) below MPa above MPa (d) By how much could the largest observation be decreased without affecting f?

Name: Consider the following observations on shear strength (MPa) of a join
Uploaded: 2024-03-20T07:07:12.000Z
Channel: Bartleby
Description: Consider the following observations on shear strength (MPa) of a joint bonded in a particular manner.22.040.416.473.036.6109.630.04.433.166.781.5(c) How large or small does an observation have to be to qualify as an outlier? (Round your answers to o

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Flexural strength is a measure of a material's ability to resist failure in bending. The accompanying data are on flexural strength of concrete (in MegaPascal, MPa, where 1 Pa (Pascal) = 1.45 ⨯ 10−4 psi): 5.7 7.2 7.3 6.2 8.1 6.8 7.0 7.6 6.8 6.5 7.0 6.3 7.9 9.0 8.2 8.7 7.8 9.7 7.4 7.7 9.7 7.8 7.7 11.6 11.5 11.8 10.6 (a) Construct a stem-and-leaf display of the data. (Enter numbers from smallest to largest separated by spaces. Enter NONE for stems with no values.) What appears to be a representative strength value? Do the observations appear to be highly concentrated about the representative value or rather spread out? highly concentrated around the representative value spread out with a large range (b) Does the display appear to be reasonably symmetric about a representative value, or would you describe its shape in some other way? reasonably symmetric positive skewness negative skewness completely random distribution (c) Do there appear to be any outlying…
Suppose that samples of polythene bags from two manufacturers A and B are tested by a prospective buyer for bursting pressure, with the following results: If the prices are the same, which manufacture’s bags would be preferred by the buyer? Why?
A law enforcement organization claims that their radargun is accurate to within 0.5 miles per hour for a courthearing. An independent organization hired to test theaccuracy of the radar gun conducted 12 tests on a projectilemoving at 60 miles per hour. Given the data inthe following table, determine if the radar gun can beused in court. State the hypothesis and base your commentson an appropriate α level.
Consider the following 10 measurements about the cohesion of a soil: 12 kPa, 14 kPa, 15 kPa, 14.5 kPa, 16.0 kPa, 18 kPa, 15 kPa, 16.2 kPa, 17. 6 kPa, 13 kPa. Work out the solutions of the following two problems, assuming the cohesion follows the normal and lognormal distributions, respectively. (1) Draw the PDF of the cohesion; (2) Evaluate the probability that the cohesion based on the PDF is less than 5 kPa, 10 kPa, and 15 kPa; (3) Assess the effect of the type of distribution on the results.
In the 2015 AFC Championship game, there was a charge that the New England Patriots underinflated their footballs for an advantage. The Patriots' opponents during the championship game were the Indianapolis Colts. Measurements of the Colts' footballs were taken. The balls should be inflated to between 12.5 and 13.5 pounds per square inch (psi). The accompanying data consists of six of the eight measurements on the Colts' footballs. Complete parts (a) and (b) below. 12.75, 12.50, 12.15, 12.35, 12.55, 12.30 The test statistic is = (Round to two decimal places as needed.) The p-value is = (Round to three decimal places as needed.) b. Use the data to construct a 95% confidence interval for the mean psi for the Colts' footballs. How does this confidence interval support your conclusion in part (a)? The 95% confidence interval is ___ psi to ___ psi. (Round to two decimal places as needed. Use ascending order.)
An ecologist hypothesizes that birds with longer wing spans use wider tree branches. The ecologist captured male birds, measured their wing span and other characteristics in millimeters, and then marked and released them. During the ensuing winter, the ecologist repeatedly observed the marked birds as they foraged for food on tree branches. He noted the branch diameter on each occasion, and calculated the average branch diameter for each bird in centimeters. The measurement data are below. What can the ecologist conclude with an α of 0.05 wing span branch diameter 79.380.180.781.579.580.781.180.580.7 1.561.531.391.041.391.021.211.311.21 A) What is the appropriate statistic? Then Compute the statistic B) Compute the appropriate test statistic(s) for H1: ρ > 0 critical value = test statistic= C) Effect Size
Use the following Uniform Density Curve
Two quality control technicians measured the surface finish of a metal part, obtaining the data in the table below. Assume that the measurements are normally distributed.
The sides of a rectangle measure 5 ± 1 (cm) and 8 ± 2 (cm). How much is your area worth?Consider the statistical hypothesis to calculate the propagation of errors
A sample of 56 research cotton samples resulted in asample average percentage elongation of 8.17 and asample standard deviation of 1.42 (“An ApparentRelation Between the Spiral Angle f, the PercentElongation E1, and the Dimensions of the CottonFiber,” Textile Research J., 1978: 407–410). Calculatea 95% large-sample CI for the true average percentageelongation m. What assumptions are you making aboutthe distribution of percentage elongation?
The article “Monte Carlo Simulation—Tool for Better Understanding of LRFD” (J. of Structural Engr., 1993:1586–1599) suggests that yield strength (ksi) for A36 grade steel is normally distributed with a mean of 50.2 ksi and a standard deviation of 3.8 ksi.. What yield strength separates the strongest 5% from the others? (Use 2 decimal places) Show the area of interest in the density curve.
The area beneath the normal density curve is separated into three regions by the values a and b. Set the mean of the normal density curve to 6.4, the standard deviation to 0.7, and the x-value of b to 6.8. First, determine the value of the area to the right of b.