Please, make you you review your answer carefully before you send it. I only have one chance for a correct answer. No second chance. Consider the given circuit, where is = 3e-mA. The voltage vo(t) is equal to 1.6 *et microV. What is L in H?is+Voeqi₁Lellmelliz4 mH6 mH

We need to find out the value of unknown inductance for given circuit .

Answered: Consider the given circuit, where is =…

Consider the given circuit, where is = 3e mA. The voltage vo(t) is equal to 1.6 *et microV. What is L in H? is L m ell iz 4 mH 6 mH

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 1PP: Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time...

See similar textbooks

Related questions

Q: For what value(s) of the gain K does the closed-loop system have two real repeated poles?

A: Given: Required: K value for which two poles are repeated.

Q: 3.5 Obtain v, in the circuit of Fig. 3.54. 60 V 30 ΚΩ + 120 ΚΩ www 120 V (+-) 120 ΚΩ + Vo

A: Given: The given circuit diagram is, To find the voltage value of v0 in Volts.

Q: QUESTION 8. Find the piecewise-linear equivalent circuit for the diode of Fig. 1.15. Use a…

A: Diode A diode is a two-terminal electronic component that primarily conducts current in one…

Q: 6. Refer again to Figure 9-19. If R1 were shorted, the a. circuit current would increase. b current…

A: To answer the questions

Q: The single transistor in the circuit behaves as a +Vcc HII OUT

A: It is asked to state the behavior of transistor

Q: The amplifier below is biased to operate at gm = 3 mA/V and has Rs = 5.2 k, Cs = 3.2 μ F. Neglect…

A: We need to find out the lower cut off frequency .

Q: TRUE OR FALSE: The Z-transform of x(n)= 0.25nu(n)+0.5nu(-n-1) is 0.25 < |z| < 0.5

A: Note: Z-Transform of anu(n)=11-az-1 , ROC Z>aZ-Transform of anu(-n-1)=11-az-1 , ROC Z<a

Q: Determine the reactance offered by a diode described by the characteristics of Fig. 1.33 at a for-…

A: Given

Q: A redundant part or component increases reliability because it is connected in parallel, not in…

A: Q 40. System reliability: Components and otherwise elements are organised parallely in parallel…

Q: The full-scale deflecting torque of a 20 A moving-iron ammeter is 6 × 10³5 N-m. What is the rate of…

Q: Table 2: Measured Voltage Gain versus Frequency with Vs(p-p) = 0.2 V Frequency (Hz) Voutp-p) (V) Ay=…

A: Given that, we have Vs(p-p)=0.2 V, various frequency & Vout(p-p) We have to find gain Av &…

Q: Problem 3 Find the expression for the v(t) and current i(t) of the capacitor as function of time for…

A: The capacitor is passive element. It store energy in form of electric energy. In steady state…

Q: 1. A serios/parallel resistive circut appears as what kind of load to a power source? a multiple b.…

A: Given:

Q: The following information is given for the RC circuit below: (a) = 60" (b) R = 10052 (c) Ic 1.04 A…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: For the circuit shown, answer the following questions: (3 decimal points) 10/0° A 1 1. 8Ω Calculate…

Q: A unity negative feedback system has an open loop transfer function k G₂ s(s+10) for the system to…

A: Given data, Open loop transfer function Gs=kss+10, Unity feedback system Hs=1. Damping factor…

Q: A positive zero crossing detector is a comparator whose reference is -Vref + Vref Zero O Depends on…

Q: Problem 03.037 - Mesh analysis: Independent and dependent voltage sources In the circuit given…

A: The circuit is shown below: In the above circuit, the voltage drop across the 4-ohm resistor is,…

Q: 6- Got out the internal charact. From the external charact. 7- Explain the effect of speed on the…

A: Types of DC Machine Seperetely excited machine Self excited machine Shunt DC Machine Series DC…

Q: Question Overall transfer function of a system is given as G(s) = (2s+1) (s²+2s+5) The system is…

Q: 1) For the circuit shown, find the current through resistance using Superposition thearem. each 50…

A: Since you have posted multiple questions, we will provide the solution only to the first five…

Q: Q3 A transmission line of 50 2 operating at 120 MHz is terminated by (80 j20) 2 load impedance. Is…

A: The transmission line problem is solved as shown below.

Q: A balanced twelve-phase mesh connected load has a line current of magnitude 10.3 A. What is the…

A: Given Line current IL = 10.3 Amp, To find Phase current

Q: Problem 03.007 - Nodal analysis: Independent current source and dependent current source In the…

Q: 4. An LRC circuit is shown with an alternating source with a current given by i(t)- Icos(cot), with…

A: Given: In this question, the given details are, The LRC circuit with an alternating source with a…

Q: A synchronous sequential circuit is given with a one-bit input m and a three-bit output Y. When m =…

A: The given problem is from sequential circuits. The detailed solution is given in the next step

Q: Given the impulse response of a DT-LTI system h(n) = -3(0.8)"u(n) a.) Find the magnitude and phase…

Q: 主 | Z = 0.01 pa

A: Given: fig 1.19 1) Determine Forward Voltage Drop across the diode at the given different…

Q: Ve 25 mH 625 nF 1=0 Vo Black box io (t)=1.5e-16.0001 -0.5e-4.000. The voltage across the capcitor at…

A: The current in the circuit is, iot=1.5e-16,000t-0.5e-4,000t The voltage across the capacitor is…

Q: Required information Consider the given circuit where = 6 mA. An ammeter with internal resistance R¡…

Q: Determine V₁, V2, and the power dissipated in all the resistors in the circuit of Fig. 3.50. 6 A "…

A: We need to find out node voltage and power dissipation in each resistor for given circuit .

Q: Question 1: d. State the superposition theorem Determine the current in each branch of the network…

Q: A five-bit DAC covers a voltage range of 0 to 2 V. Calculate how much voltage each bit is worth.…

A: The DAC problem is solved as shown below. The basic problem on resolution

Q: Specifications: (a) VDD = 9 V (b) The DC voltages at Vout1 and Vout2 are VDD/2. (c) IR,=10 μA. (d)…

A: The current mirror circuit is given as Given…

Q: Question Overall transfer function of a system is given as G(s) = (28+1) (s²+28+5) .The system is…

A: Given- The overall transfer function of a system, Gs=2s+1s2+2s+5 To find- System characteristics.

Q: The unit vectors, a, b and ê are mutually perpendicular and are related by âxô = ĉ. If the…

A: The given problem is from wave propagation. The detailed solution is given in the next step

Q: 11. The variation of generated voltage of AC Generator can be varied through a) the speed of the…

Q: Calculate for the low cut-off frequency of the bandpass filter given below. 1.5k vi-M 0.047u O 225…

Q: 2.) Draw the schematic diagram and derive of an E. (3) the transfer function G(s)…

Q: Question 3 The generator in the Fig. 2 is delivering 1.0 pu active power under pre-fault conditions…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: The circuit has an RMS secondary voltage of 22.16 volts. One of the diodes is broken. Considering…

A: Given data Primary voltage, VpRMS=120 V Secondary voltage, VsRMS=22.16 V Supply frequency, f=60 Hz…

Q: Draw polar plot for the following open loop ?

A: The given open-loop transfer function is written below. Gs=20s2+s+0.5ss+1s+10. We need to draw the…

Q: An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is…

A: Given- 1st case: An air filled parallel plate capacitor is connected to Battery, V = 12 volts The…

Q: Consider the circuit shown below. Assuming that the switch is closed at t= 0, calculate v(t) for t >…

A: given circuit problem. we have to calculate voltage

Q: a. b. Calculate the Fourier Series coefficients of the following signal x(t) = cos(w₁t) + cos(2wot)…

Q: a. Prove that sin (nwot) and sin(mwot) are orthogonal over a period.

Q: 2.) An AC circuit is shown below. The AC power supply has Vrms = 120 V, frequency = 60 Hz. AC power…

Q: Use the circuit below for questions 1-5. Exact answers will vary based on rounding during…

Q: Problem 4 Sinusoidal Steady State (SSS) via H(s) I. 125(5+400) 5(5²+2005 +10") Ig i(t) = 80 cos…

Q: Q3: Determine the currents I1, I2, and ID2 for the network of figure. the diodes are assumed to be…

A: We need to find out the current for given circuit.

Question

Please, make you you review your answer carefully before you send it. I only have one chance for a correct answer. No second chance.

Consider the given circuit, where is = 3e-mA. The voltage vo(t) is equal to 1.6 *et microV. What is L in H?
is
+
Vo
eq
i₁
L
ell
m
ell
iz
4 mH
6 mH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
if the given circuit does not work correctly state the reason. ( IDSS= 10 mA, VP=-6V)
A series connection of a 30-ohm resistor and a 100-mH inductor is connected across 240-V, 60-Hz supply. What will be the resulting equation of the current? a. i(t) = 7.04 sin(377t + 51.49°) b. i(t) = 7.04 sin(377t - 51.49°) c. i(t) = 4.98 sin(377t - 51.49°) d. i(t) = 4.98 sin(377t + 51.49°)
5.A RL circuit has no applied emf, a resistance of Rohms, an inductance of 2 henries, and an initial current of 10 amperes. Find the current in the circuit at any time t. Use R = 50
An LR circuit includes a resistor of resistance R, an inductor of inductance L and a battery of emf E = 10 V. At time t = 0 the current in the circuit is I = 0. At time t = 6.1 ms the current is I = 0.66 A. What are the values of L and R?
Problem 5.5 Reduce the network to the fewest elements. 6.2 mH 10 uF ll 12 mH 36 mH 9.1 µF 91 µF 24 mH 3.3 µF
9. What will be the impedance of a LR-C circuit if it has a circuit current of 3A and a supply voltage of 120V? A. 45ohm B. 50 ohm C. 40 ohm D. 35 ohm 10. A pure inductance of 100mH is connected in parallel to a 25microfarad capacitor. The network is connected to a 200V, 60Hz supply. Determine the circuits current. A. 2A B. 3.42A C. 4A D. 10A
given circuit, Vk = 12 V, R = 240 Ω, C = 1 μF, L = 40 mH. Theswitch, is closed for a long time for t < 0– . Determine vL(t) for t > 0.
10 resistance in parallel with 50 uF capacitance and the current through the capacitance is: ic (t) = 2sin100t + 1.5sin200t + 1.2 sin400t A, find the total dissipated power by the circuit.
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the real power of the circuit?
The current in the 50 mag inductor in the circuit attached is known to be 100mA for t0 is given by the expression Vl = 2e^-100tV for 0+ < t < 100 ms Vl = -2e^-100(t-0.1)V for 100 ms < t < infinity Calculate and sketch Vl(t) and il(t) for 0 < t < infinity
Given the following circuit, find i(t) at t>0. (R=3 ohm, L=1H, C=0.5F, is=2e^-3t)