Consider the same 470 ohm resistor with 9.4 volts across it. What is the power consumed through that resistor? Express in engineering notation. 188 mW 188 W 470W 41.5kW

Q: Using nodal analysis, what is the power absorbed by the 2-ohms resistor?

A: Given circuit is,

Q: The bill of commercial load based on Iragi electricity tariff of 1600 kWh costs

A:

Q: Hydro power plant costs Tk. 45×101º with maximum capacity of (x+6) MW.

A:

Q: 100 89 27 47

A:

Q: For the circuit shown find (a) the current i (in micro-amperes), (b) the voltage v in volts, (c) the…

A: The circuit diagram is: a). Applying Kirchhoff’s current law at node A: The modified circuit is:…

Q: 23. In the circuit shown, the voltmeter, ammeter, and wattmeter read as follows: 230V, 1.9A, 345W.…

A: Given data, Input current = 1.9 A. Input voltage = 230 V. Input power = 345 W.

Q: A 60 W bulb is on for 10h. a. What is the energy used in watt-seconds? b. What is the energy…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: The metering of a power customer was read and gave the following data: KW-hr = 200,000  KVAR- hr.=…

A: Given, KW- hr = 200,000 KVAR- hr.= 180,000 power factor=?

Q: Calculate the total electrical energy consumed for a load usage of 4 lamps (13 W each) for 8 hours a…

A: The product of electrical power and time gives the electrical energy. Electrical energy is measured…

Q: Load 2390 tums 710 turrs 28 VAC 350 2

A: Given circuit, Where, Primary number of turns, N1=2390 turns Secondary number of turns, N2=710…

Q: Find the power dissipated in the 9-ohm resistor. 3 27V 6A +

A: The power dissipated in a resistor (P) is given by: Where, The current in resistor is “I”, The…

Q: Using the measured values, calculate the following: - a. power supplied by the power supply, Pin b.…

A: Power is the time rate of change of energy. Its SI unit is watt. It is the product of voltage and…

Q: * Wattmeter-XW. 302.082 mW R1 V1 Power Factor: 0 602 1200 Voltage Current 10 Vrm: 1kHz 0° C1 1pF

A: The detailed solution is attached with.

Q: Calculate (a) Power indicated by wattmeter 2 (b) Input power (c) Line current (d) Output power in…

A: Given data: VL=2250   VPF= 0.7 (Lag)F= 60 HzW1=300 kW%η=90 % Here, cos(ϕ)=0.7ϕ=cos-1(0.7)=45.57° -We…

Q: 20 ohm 40 ohm +ラ ら? 120V

A: According to the question we  have to calculate the value of V1.

Q: Given :- 385 Gea 4s 25 12

A: Let's solve for the equivalent Geq by using the network reduction techniques. Care must be taken so…

Q: 14. A 220-volt electrical heater is used to warm 6Li/hr of water from 250C to 930C. Assume heat…

A:

Q: Load 28 VAC 2390 tums 710 turrs 350 2

A:

Q: What is the total cost of using all of the following at P50.00 per kWhr? a. A 1200w toaster for…

A: Given, The total cost of using all of the following at P50.00 per kWhr a. A 1200w toaster for 30min…

Q: H. W 25.2 ?? 50V 5H PL to

A: Given :   Note :  In the given question that did not mentioned for which time instant they want…

Q: 40 Ohms 60 Ohms 40 Ohms 230 V What is the Voltdrop across the 600 resistor? a. 230 V . b. 172.5 V c.…

A:

Q: (1 + j3) 2 ww V, 100 4 20° volts V 80 30° volts 5+j10 Find I in the given circuit.

A: KVL (Kirchhoff's Voltage Law) states that the algebraic sum of all voltage in a closed loop is zero.…

Q: Q1: Refer to the table below, find the connected load (note that; 18 lights are used and 8 sockets…

A: The solution can be achieved as follows.

Q: In the shown figure the circulation of A= pa, is on 7. 2. 60° 30° 2. Windows bu

A: Circulation of vector A is the line integration of the A along path.  i.e. ∮ A.dl We will calculate…

Q: The voltage drop across a resistor of 150 ohm is 10 volts. The wattage of the resistor must be 1 W.…

A:

Q: It is required to provide illumination of 150 meter- candle in a factory hall 45 m x 15 m. . Assume…

A:

Q: 36 A 96 SOK vzi=8.6V 38V v22=11.2v S100K

A:

Q: 4. Complete the table below. Show all calculations. 7900 22 ka R. 8.6 ka 32 V 630 2 ww

A: As the table is not given, i am finding all the voltages, currents and powers at all the given…

Q: Kirchhoffs's Law, calculate the voltage across 2 ohms resistor.

A:

Q: A hydro station generate 255000 kwh for one day. The water discharge of the station is 43 cubic…

A: Above given question is based on Hydro power station. A hydro power plant uses the kinetic energy of…

Q: What is the current flowing on the 9-ohm resistor if the source voltage is placed at 20 volts? Note:…

A: In this question we will find current flowing in 9 ohm resistor....

Q: A 470 ohm resistor has 9.4 volts across it according to the multimeter. What is the current flowing…

A:

Q: The expected value of the voltage across a resistor is 80 V, and the measured value is 79 V. What is…

A: Given: Expected value or True value of voltage, VT=80 V Measured value of voltage, Vm=79 V

Q: Calculate the total electrical energy consumed for a load usage of 6 fans (82 W each) for 4 hours a…

A:

Q: What is the voltage drop across the 5 ohm resistance in the given circuit below? 20 40 12 V 10 (A)…

A:

Q: What is the value of R (in ohms) and the power supplied by the 240V source.    Please show all…

A:

Q: A 110V d.c. generator supplies a lighting load of forty 100W bulbs, a heating load of 10kW and other…

A: we need to find out power output of the generator.

Q: Find 12 in Amperes if Is = 4.4 A and R = 6.6 Ohms. Give answer in 2 decimal places. No need for…

A:

Q: 102 ww i, 102 20 V 50 2 A ww

A: Applying the nodal analysis at node A:

Q: In a pumped hydro system 325 MWh of electric energy was drawn from the grid to störe water with an…

A: In this question we need to find a turnaround efficiency of pumped hydro system.

Q: Refer to the circuit below. The current i, is equal to: 222 ww Si, 54 V

A:

Q: Determine the power consumed by the 42- resistor (in watts). 40 21x 20 10V 60 12V DC DC

A: Given :

Q: A hydro station generate 255000 kwh for one day. The water discharge of the station is 43 cubic…

A: Given: For a hydroelectric power station, η=70% Energy generated in one day, E=255000 kWh Water…

Q: If the current through a 220kohm resistor is 20mA, what is the power absorbed by the resistor? (Give…

A:

Q: An 11 kV system, with a base value of 11 kV, has a voltage of 1.2 pu. What is the voltage in units…

A: Given, An 11 kV system with Base voltage, VB=11 kV Per unit voltage, Vpu=1.2 pu

Q: What is the voltage drop across the 5 ohm resistance in the given circuit below? 20 40 12 V 50 10…

A: Option A.  2.86 volts Using KCL will give results fast and easy

Q: + 12 V + ww 852 DA. 0.44 Amps ww + 9 V ww 20 Ω 13

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.