Define these properties and explain the relationship of IMF strength to each property. (a) Boiling point (b) Melting point (c) Surface tension (d) Viscosity

Q: What is the difference between a network solid and anionic solid?

A: Solution-  Ionic solids—formed by positive and negative ions and electrostatic attractions and held…

Q: Suppose you shade a square of side 1.0 cm with a pencil that leaves a layer of graphite 315 nm…

A: The square of side 1.0 cm is shaded with pencil. The thickness of graphite layer is 315 nm.

Q: The viscosities of five liquids at 25°C are given in the following table. Explain the observed…

A: Following factors affects the viscousity of a liquid .

Q: 5 if the viscosity of Nacl = 664.256 mpa.s viscosity of NaOH= 1.00979 cp viscosity of water= 0.6531…

A: We have to calculate the viscosity of the entire mixture. The given data is:\ Viscosity of NaCl=…

Q: Justify that Glass is an insulating material.

A: Conducting material : The materials which conduct electricity when electricity is passed through it,…

Q: In terms of their bulk properties, how do liquid and solid differs? How are they similiar?

A: There are mainly three physical states in which matter exist- solids, liquid, and gases. A substance…

Q: Illustrate the Origin of surface tension ?

A: Surface tension is the property of a liquid that tends to occupy the smallest surface area. Like…

Q: The reciprocal of conductivity is Turbidity .a O None of the mentioned .b O Viscosity .c O…

A: Answer -  The reciprocal of conductivity is d) Resistivity.

Q: What type of defect can arise when a solid is heated?

A: All matter can exist in different physical states; solid, liquid and gases. Solid is well known…

Q: Which one below is not true for mechanical properties of ceramics? The fracture strength increases…

A: The statement not correct is (a)  As the fracture strength does not increase with decrease in…

Q: Discuss the physical examination of materials in material science

A:

Q: (i) Write the type of magnetism observed when the magnetic moments are aligned in parallel and…

A: Magnetism is due to the movement of electric charge.

Q: cular weight ases the vapor pressure of a compo molecular forces ecular weight D.Lower meltin…

A: 17) Boiling point of a compound is depends upon intermolecular interactions. Higher the…

Q: How can we describe a single-phase material?

A: Single phase material is the material contains only one phase .

Q: The presence of __________ in motor oils allows them to have temperature-dependent viscosities.

A: Dry lubricante such as graphite, molybdenum disulfide and tungsten disulfide allow them to have…

Q: - Camper between Sorption and Surface tension

A:

Q: What is the density of nitrobenzene at 30 degree centigrade and How can you describe the viscosity…

A:

Q: Explain (i) The basis of similarities and differences between metallic and ionic crystals.

A: From given,  The basis of similarities and differences between metallic and ionic crystals is…

Q: What is the chemical reason (ie. molecular property) for biodiesel having more desirable viscosity…

A:

Q: Can you draw a graph of molar conductivity using the data?

A: According to Debye-Huckel-Onsager theory the molar conductivity is related to the concentration for…

Q: Saturatad uater vapour at 60c°has iti pressure decrease to ncrease the volume by 10 % Keeping the…

A:

Q: Suppose you are measuring the surface tensions of water and mercury separately by capillary-rise…

A: The phenomenon where a liquid due to attractive forces minimizes its surface area is called as…

Q: In Purification by Sublimation, what improvement can suggest to increase the amount of crystals that…

A: Sublimation refers to when a substance in a solid-state and changes into vapours without going into…

Q: ?A definition of viscosity is

A: Viscosity is the measure of resistance of the movement of fluids. Fluids include liquids and gases.…

Q: In the process of doping a semiconductor, certain impuri-ties are added to increase its electrical…

A: In semiconductors, the gap between the valence band (VB), and the conduction band (CB), is small.…

Q: Q/ Briefly explain how these factors affect wettability 1-the pore size 2- the surface roughness…

A: Wettability: it is an ability of a liquid to stay in contact with a solid surface.

Q: All compounds in a chemical series have the same commonality of structure, therefore the same…

A: Intermolecular forces are forces of attraction oflr repulsion acting between neighbouring particles.…

Q: Determine the liquidus temperature, soli- dus temperature, and freezing range for the following…

A: Solution - According to the question - Given -

Q: 4. List types of crystal imperfections, give their dimensionality and examples.

A: The crystalline nature of the substances acquires their constituent particles/atoms in the proper…

Q: what is Formality and for which types of solids it is mainly used?

A: Solution stoichiometry is mainly based on the calculation of moles and volumes. These two values are…

Q: 3.5 kJ/mol is required to change the state if a material from solid to liquid, and its heat of…

A:

Q: What determines the type and strength of intermolecular attraction between particles?

A: The differences in the properties of a solid, liquid, or gas determine the strengths of the…

Q: Liquid rises to a height of 0.45 mm inside the capillary above the surface of liquid. The height of…

A: The surface tension of liquid is to be calculated

Q: Estimate the density of calcium oxide (rock salt structure), knowing that the ion rays are 100 pm…

A: Radius of Ca2+ = 100 pm Radius of O2- = 140 pm CaO has rock salt structure, i.e. Z =4 Calculation of…

Q: Which point defect in ionic crystal does not alter the density of the relevant solid?

A: The missing of atoms or ions in an ideal or imaginary crystal structure or lattice and the…

Q: 1. What are the principal natural processes that affect the petrophysical properties of sedimentary…

A: The main petro-physical properties of sedimentary rocks are thermal diffusivity, conductivity,…

Q: Non-crystalline ceramics deform by -

A: Noncrystalline ceramics(Amorphous ceramics) being glasses are usually formed through melting.

Q: Rank vapor pressure from highest (1) to lowest (3) Rank viscosity from highest (1) to lowest (3)…

A: We have to rank given compounds on basis of given properties

Q: In their study of X-ray diffraction, William and LawrenceBragg determined that the relationship…

A: According to Bragg’s Law of diffraction, nl = 2dsinu d is the distance is the interplanar distance…

Q: State two molecular characteristics of substances that typ-ically form liquid crystals. How is each…

A: Given: To determine the two molecular characteristics of substances that typically form liquid…

Q: 10) Assume that boron is used to dope silicon. If boron dopant concentration uniform and has a value…

A:

Q: Which of the following forms of viscosity does not vary with concentration?  a. relative b.…

A: The intrinsic viscosity of the polymer solution depends on the type of polymer and the solvent and…

Q: As the temperature increases, do you expect the surface tension ofa liquid to increase, decrease, or…

A: The temperature is inversely proportional to the surface tension.

Q: Give mathematical explanation for the effect of temperature on viscosity.

A: The property of the liquids which determines their resistance to flow is called viscosity.…