Design a sanitary sewer for a City “A”, using the following data: - Population of the city = (11000) persons - Average water consumption, Qavg-water = (110) Lpcd - Industrial area, Aind = (11000) m2 - Area for commercial activities, Acom = (50) ha - Use Manning’s roughness co-efficient, n = 0.013 Diameter (m) of the sewer =? Slope of sewer = 1 in ? Note: Write the answer in each part in word format

Design a sanitary sewer for a City “A”, using the following data: - Population of the city = (11000) persons - Average water consumption, Qavg-water = (110) Lpcd - Industrial area, Aind = (11000) m2 - Area for commercial activities, Acom = (50) ha - Use Manning’s roughness co-efficient, n = 0.013 Diameter (m) of the sewer =? Slope of sewer = 1 in ? Note: Write the answer in each part in word format

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter11: Hydroelectric Energy

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

Q#1: Design a sanitary sewer for a City “A”, using the following data: - Population of the city = (18300) persons - Average water consumption, Qavg-water = (18300/100) Lpcd - Industrial area, Aind = (18300) m2 - Area for commercial activities, Acom = (18300/200) ha - Use Manning’s roughness co-efficient, n = 0.013
Calculate net wastewater generation from the following data: Total Population = 1000 Water consumption rate = 200 L/cap.day Infiltration rate = 15% Evaporation rate = 5% . Express the net wastewater generation in m3/day and L/sec.
Using the ASCE and Griff methods, estimate the average, peak, and low rates of flow in the sewer system of the city of Columbia with a population of 132000. Additionally, use the peaking factor method (ten-states) to estimate the peak flow. Assume the national public water consumption average of 120gpcd. Assume a spent water to freshwater ratio of %60.
A wastewater treatment plant discharges of effluent into a stream. Just upstream from the discharge point, the stream has an ultimate BOD of 5 mg/L.Assuming a cross-sectional area for the stream equal to 100 m2, what ultimate BOD (in mg/L) would you expect to find at a point of 15,000 m downstream? Wastewater Flow: 1 m3/secBOD (ultimate): 40 mg/LRiver Flow: 10 m3/secDeoxygeneation constant kd: 0.22 day-1
20 cm diameter sewer with invert slope of 1 in 500 is running full. Calculate the rate of flow in the sewer Compare the velocity with self-cleansing velocity. Assume Manning's n = 0.012. Assume, average size of solids to be 1 mm.
Q1.Design a trickling filter for treating 5 million litres of sewage per day. The B.O.D. of sewage is 144 ppm. Q2.Determine the ultimate B.O.D. for a sewage having 5-day B.O.D. at 20°C as 200 p.p.m. Assume R20 = 0.1 per day. Q3. Given the following data, calculate the 5-day B.O.D. of the unseeded sample of sewage: Initial DO…………….. 10 mg/1 Final DO…………… 4 mg/1 Bottle volume ………….300 ml Sample volume………….6 ml.
Irrigation and drainage, i need solutions in 15 minutes please. MCQ/Using Dupuit formula find the drain spacing for the following data 1- Coefficient of permeability = 0.3 m/day 2- Recharge required to be removed per unit area q = 0.84 cm per day 3- Impermeable layer depth below ground surface = 5 m 4-Distance from ground surface to the centerline of the drain = 1.5 m 5-The water table should be 0.6 m below the ground level. The answer is * A-22.50 m B-34.20 m C-31.90 m D-44.70 m
The average design flow at a wastewater treatment plant facility is 1.5 m3/s. The bar rack is mechanically cleaned with an average clear spacing of 2.5 cm. Estimate the average quantity of screenings that will be collected at each day.
A circular shaped clarifier is used to treat waste water at a rate of 5000 m3/day. Determine the diameter of the clarifier if the overflow rate of the clarifier is 35 m3/m2/day.
A community normally levies a sewer charge of 20 cents/m3 ($0.20/m3). For discharges in which the BOD > 250 mg/L and suspended solids (SS) > 300 mg/L, an additional $0.50/kg BOD and $1.00/kg SS are levied. A chicken processing plant uses 2000 m3 water per day and discharges wastewater with BOD = 480 mg/L and SS = 1530 mg/L. What is the plant’s daily wastewater disposal bill?
b.) Estimate the peak runoff flow rate observed in the combined sewer system in cfs generated only from storm water.
in simple terms, explain how to use a lagoon and evapotranspiration in wastewater processing and disposal.