Design a voltage divider to provide the following approximate voltages with respect to ground using a 30 V source: 8.18 V, 14.7 V, and 24.6 V. The current drain on the source must be limited to no more than 1 mA. The number of resistors, their values, and their wattage ratings must be specified. A schematic showing the circuit arrangement and resistor placement must be provided

Design a voltage divider to provide the following approximate voltages with respect to ground using a 30 V source: 8.18 V, 14.7 V, and 24.6 V. The current drain on the source must be limited to no more than 1 mA. The number of resistors, their values, and their wattage ratings must be specified. A schematic showing the circuit arrangement and resistor placement must be provided

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter6: Series Circuits

Section: Chapter Questions

Problem 11RQ: A series circuit contains the following values of resistors: R1=510R2=680R3=390R4=750 Assume a...

See similar textbooks

Similar questions

A series circuit contains the following values of resistors: R1=510R2=680R3=390R4=750 Assume a source voltage of 48 V. Use the general voltage divider formula to calculate the voltage drop across each of the resistors. E1=VE2=VE3=VE4=V
Determine the resistance values for a voltage divider that must meet the following specifications: The current drawn from the source under unloaded condition is not to exceed 5 mA. The source voltage is to be 10 V, and the required outputs are to be 5 V and 2.5 V. Sketch the circuit.
Please show how to determine the voltage using current or voltage dividers (as opposed to mesh analysis) across the 10 k ohm and 5 k ohm resistors if these are 12 V and 1.33 V.
Using the voltage divider rule, determine the voltage Vab in the circuit below. Vab=Va-Vb
b) i) Discuss the effect of a series circuit as an unloaded voltage divider, when it is loaded ii) The condition on the voltage drop, after it has been loaded.
1. Two resistors in series are part of a voltage divider circuit with the smaller resistor receiving 30% of the total voltage. () What are the resistance values given that their equivalent resistance is 200 77 {b) If both resistors are rated as 2-W resistors, what is the minimurm total voltage that the voltage divider circuit can handle without exceeding the power rating for either resistor?
Two 3V batteries are connected in parallel to a 10 ohm resistor, where one of the batteries has double the internal resistance. Estimate the power delivered by each battery.
Design the right hand side Voltage Divider by solving for the simplified numerical value for RI and R2 using the voltage and current divider concepts to set VAB = 1.67 V.
in the following circuit, an ohmmeter is conntected to points a and b, what is the total resistance of the resistors?
Compute total resistance (series-parallel), total current (ohms law), voltage at R1 and R4 (using voltage divider) and current in R4 (using current divider).
Solve for voltage dividers Calculate Vab of the following circuit
Three 24 V batteries are connected in parallel and deliver current to a load resistance of 0.8 Ω. Battery circuit A has a resistance of 0.2 Ω, battery circuit B has a resistance of 0.25 Ω, and battery circuit C has a resistance of 0.3 Ω. Calculate the total load current.