Answered: Determine the Thevenin equivalent…

Engineering

Electrical Engineering

Determine the Thevenin equivalent circuit seen by the inductor on the circuit below. 10/A IL 300 mH 4 100 Ω m 60 Ω m IA

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 5PP: In an RLC parallel circuit, the resistor has resistance of 24 k , the inductor has a reactance of 36...

See similar textbooks

Related questions

Q: Shown below is the voltage waveform applied to a pure capacitor of 100 uF. Solve for the RMS value…

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Torque = 12π flux ×number of armature conductors ×number of poles number of parallel paths…

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Introduction - The internet of things, is a networked system of interconnected computing devices,…

Q: The voltage Vo in the circuit shown equals 10Α 5A 200 €r: 2 Ο 200 3 ЗА

A: Given data, Circuit diagram is given as,

Q: 1. For all questions, assume T = 300K unless specified, VT = kT/q = 0.026V, q= 1.6x10-19, ni =…

Q: A transformer having 1000 primary turns is connected to a 250 V a.c. supply for a secon- dary…

A: Given a transformer with, Primary turns, N1=1000. Primary supply voltage, V1=250 V. Secondary supply…

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the ine curent? * 1=…

A: Given, VL=220 V cosϕ= 0.71 lag P= 21437 W I = ?

Q: Simplify the following expression by applying one of the theorems. State the theorem use (d) (UV' +…

Q: 1. Using one of the relationships for resistors connected in parallel, solve for the total…

Q: 1) A dc-dc buck converter has a 48 V input. This converter is connected to a dc motor that spins at…

A: Given Buck converter input voltage Vin=48 V Buck converter output voltage =24 V @ 2000 rpm…

Q: Determine the bit rate and quantization step of the ADC in the sampling of analog signal with x[n]…

A: We need to find out the data rate and step size for given ADC , we also need to find outnumber of…

Q: Q.3: A- Consider the circuit in Fig.1, all the transistors are identical, where Rc = 10 K2, ß is…

A: The circuit diagram is shown below, In the above circuit, all the transistors are idenical.Rc=10…

Q: Write a function using the block diagram shown below: a b' a D D

A: This is a basic problem of logic gate function. The solution is given in the next step.

Q: WHAT OBSERVATION CAN BE SEEN IN THE CHART? PLEASE EXPLAIN THE CHART.

A: The chart given in the question is This is the plot of the Armature voltage vs load current.

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at @= 50…

A: Given: A network with various elements. To find: Input impedance, Zin Note: We'll use series and…

Q: PLEASE ANSWER IT NOW, I NEED THE ANSWER Find the total external armature current of a dc machine…

A: Specification of DC machine is given as No. of Armature slot = 120,ConductorSlot=6,Diameter of…

Q: load is connected to a 210 V, 50 Hz supply. If it has resistance of 300 and a capacitor of 0.25 mF,…

A: Given, V=210 V f=50 Hz R=30 Ohm C = 0.25 mF

Q: RF carrier 10 kV at 1 MHz is a amplitude modulated and modulation index is 0.6. peak cvoltage of the…

A: The effective voltage in terms of voltage is different from the peak voltage in that it relates to…

Q: Use only DeMorgan's relationships and Involution to find the complement of the following function:…

Q: Question 6 Determine 11 in mA.

A: We need to find out the current for given circuit , first we will find out voltage then we will find…

Q: The collector current is 1.5 mA. If the current gain is 50, the base current is

A: Given, Collector current, IC=1.5 mA. Current gain, β=50.

Q: Given the discrete signal below, determine the value of x(1) x(n) = n-0.5, -3 <n≤ 4 0, otherwise…

A: In this question, We need to determine the value of x(n) at different different value. We are…

Q: Solve for VDS round off your answer with 1 decimal value. VG=0V www lp 5 mA +1₁ RG 10 ΜΩ VDD +15 V Q…

A: Apply KVL in drain source loop to find drain to source voltage . According to kvl sum of the voltage…

Q: Calculate the current through the resistance R3 of the measurement circuit of the experiment, using…

Q: discuss the basics of DSB-SC signal and where it is applied.

A: A form of amplitude modulation is DSB. Double side band is referred to as DSB. On either side of the…

Q: P4.7-15 Determine the values of the mesh currents i₁ and i₂ for the circuit shown in Figure P4.7-…

A: Node is a point of connection between two branch element. Closed path formed in the circuit when no…

Q: An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz.…

A: We need to find out the number binary digits per sample for given quantization error for given ADC .

Q: 1) Given: VIN (peak)- 5.00 V, R₁-250 k2, L-75.0 mH, C-130.0 nF (nano-10%), If R₁ 0.0 2, find the…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A load is connected to a 210 V, 50 Hz supply. If it has resistance of 300 and a capacitor of 0.25…

Q: - 22 1011 - 1012 +3812 812 12 13 - 413 + 141 3 24 -0

Q: Solve for ID in IMG 18 V 2kQ 1100 mA. round off your answer with 1 decimal value V-1.7 V 0.51 k

A: FET are voltage controlled device. BJT is current controlled device JFET is stand for Junction field…

Q: Based on the signals below, find the Fourier transform of x(t) for (a)-(e). -2 x(t) n 2 (a) -2 -1…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: How many bits are approximately required in PCM for a SNqR of 72 dB? 16 08 12 24

A: Given: A PCM has SNqR of 72 dB.

Q: 4. Find the Total Resistance below. R₁ 15 Ω Γαλλί V₁: 100 V R₂ 30 Ω w R₂ 10 Ω = = A Μ B (a) R₁ 4 Ω R…

Q: The zero drift of a voltmeter is-2.5V. The same meter is used for a measurement system and it…

A: Given data, Zero drift Zr=-2.5 V. Measured value Vm=100 V.

Q: In Boolean Logic, there are only two answers: True and False True False

A: Asking about Boolean logic output

Q: 4.20 A 25-KVA, 2200/220-V, single-phase transformer has an equivalent series impedance of Zel = 3.5+…

Q: Sketch the following signals: (a) x₁(t) = t(u(t + 2) - u(t− 2)) (b) x₂(t) = x₁(t - 6k) Σ=-1 (c)…

Q: Example 2.9 The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the…

A: Solution !! a. The temperature rise is degrees Celsius and the resistance increases 0.393% forevery…

Q: d. The peak voltage across the capacitor at resonance, fo e. The peak voltage across the capacitor…

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Using torque equation of DC motor calculate armature current. Torque of DC motor =12π×∅×Z×Ia×PA.…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

Q: The figure below shows a mobility Nyquist plot representing the response of a single mode. The three…

A: The given Nyquist plot represents the response of a single mode. Now, as per the data given in the…

Q: 100V Ο b 1302 24ΩΣ 30Ω 30Ω Μ 10Ω 150Ω

Q: For the trapezoidal current wave-form, determine the effective value. I (A) 1.22^2* peak current I B…

Q: О N в 9 р.су, О) -> Y

Q: b) The reactance X of capacitance =jwc O True O False

A: reactance of capacitor X = 1j2πfc ohms . where , f is frequency . and c is capacitance in Farads .

Q: 402 www 10 V Figure 6.5 Select one: A. 4 V B. 10 V w C. 6 V D. 8 V 120 Mw 622 See Figure 6.5. What…

A: Given circuit,

Q: a. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

Q: A 3-phase 3-wire supply feeds a load consisting of three equal resistors connected in star. If one…

A: Given - 3-phase 3-wire supply , Three equal resistors connected in stars , To find- Percentage…

Question

Determine the Thevenin equivalent circuit seen by the inductor on the circuit below.
101A
ell
IL
300 mH
100 Ω
60 Ω

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
In an RLC parallel circuit, the resistor has a resistance of 60 , the inductor has a reactance of 180 , and the capacitor has a reactance of 80 . Find the circuit power factor.
An RLC parallel circuit has an apparent power of 400 VA. The inductor has a reactive power of 450 VARs, and the capacitor has a reactive power of 200 VARs. Find the true power or watts.
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
In an RLC parallel circuit, the resistor has resistance of 24 k , the inductor has a reactance of 36 k , and the capacitor has a reactance of 14 k . Find Z.
Find the current in the RLC-circuit when inductance is 0.1 H; resistance is 20 ohms, C = 0.0002 farad and E(t) is 110 sin(415 t) V at 66 Hz.
2. The voltage of the circuit below is v(t) = 120e−400t cos(300t) + 80e−400t sin(300t) V. The capacitor is200mF. Find (a) L (b) R (c) V0 initial capacitor voltage (d) I0 initial inductor current and (e) iL(t).
The input to the circuit shown in the figure below is the voltage V(t) = 4e-20 t V for t > 0 The output is the current i(t) = -1.2e-20t V for t > 0 The initial inductor current is iL(0) = -3.5 A. Find the values of inductance L and resistance R. Please answer in typing format solution please