Determine the total resistance across the terminals from the figure below. RT 1 ohm 25 ohms 20 ohms Lw why 80 ohms 26 ohms 20 ohms 30 ohms 15 ohms 75 ohms 10 ohms 35 ohms

Q: PRELAB 1. Using one of the relationships for resistors connected in parallel, solve for the total…

A: In this question we need to find a equivalent resistance of the given circuit. As we see in given…

Q: The current in an inductive circuit is given by 0.3 sin (200t - 40°) A. Write the equation for the…

A: L = 40 × 10-3 H; i = 0.1 sin (200t – 40º) XL = ωL = 200 × 40 × 10-3 = 8 Ω Vm = Im XL = 0.3 × 8 = 2.4…

Q: a. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A: Given- Power rating of AC motor = 5 kW Power factor = 65% lagging Voltage of line= 200 V /50 Hz To…

Q: 5 A 7. Find i, in each of the circuits in Fig. 3.46. Ο ΣΗ ΣΑΣ IA

A: Given circuit:

Q: + v₁ (t) (~ - vo(t) 50Ω Circuit Load 2. Suppose vi(t)=0 for t0. Assume a cut-in voltage = 0.7V.…

A: We need to find out the output voltage for given circuit and given input , we will find out it when…

Q: 3. Find Req. A B REQ R₁ = 652 R3 = 40 www R4 = 852 R₂ = 80 m Rg=1002 R₁ = 42 Re=622 Rg=652 www R7 =…

A:

Q: Hand calculate the phasor voltage for VR1 and Vc₁ using the 50 2 source resistance. Compare the hand…

A: Given RC series circuit Source voltage Vs=Vin =2.5 V at f =500 Hz R =390 Ω C =1 μF Internal…

Q: For the op-amp shown in the following figure, if R1 = 100 and Rf = 1 k2, the overall voltage gain is…

A: We need to find out the gain of given non inverting amplifier .

Q: 5. The rod given in the figure is made up of two different materials. 25 cm 70 cm Both have square…

A:

Q: Which organization has authority over interstate and interna commerce in the communications field?…

A: 1)  ITU -T Stands for  The International Telecommunication Union (ITU) is the United Nations…

Q: for the following circuit fill in the blanks (answer in phasor form ): V = 5 sin 10t a) i=.........…

A:

Q: d. The peak voltage across the capacitor at resonance, fo e. The peak voltage across the capacitor…

A:

Q: 1. Find the current I through a resistor of resistance R= 20 if the voltage across the resistor is 6…

A: Given data, Resistance, R=2 Ω. Voltage across resistor, V=6 V.

Q: 4. Find the Total Resistance below.

A: It is given that:

Q: At time t = 0, a sinusoidal voltage 10 sin ωt is applied to an L−R series circuit. Determine an…

A:

Q: A rechargeable battery is capable of delivering 77 mA for about 13 hours. If the rechargeable…

A:

Q: PLEASE ANSWER IT IMMEDIATELY A 10 kW 220 V compound generator (Short Shunt) is operated at no load…

A: Given that: Output power, Pout=10 kW Terminal voltage, Vt=220 V Stray loss, Pstray=705 W Shunt…

Q: V Source R1 www 1.2kQ Branch A R2 1.2kQ Branch B R3 1.2kQ R4 1.2k0 Branch C R5 1.2kQ R61.2k0 R71.2K0…

A: As per Bartleby guideline we need to answer the first three questions only. Kindly repost the rest…

Q: 1. For all questions, assume T = 300K unless specified, VT = kT/q = 0.026V, q= 1.6x10-19, ni =…

A:

Q: Solve the following. Show complete solution, complete equation, resistor combination and circuit…

A: Apply Kvl in loop and using ohms law write  equation in terms of supply voltage and unknown voltage…

Q: Using one node in the network to hold all the application software done in client-server network O…

A:

Q: The angle between vector A (2i+3j+k) and ? vector B (i-2j+2k) is 1100 1000 100 2100

A:

Q: 1. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A:

Q: Determine the products of the signals below, (both signals started at n = 0). What is y(1)? x1(n) =…

A:

Q: Write a function using the block diagram shown below: X y X y' o I f

A:

Q: 5² +35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38. The…

A: We need to find out unknown value of k .we will use final value theorem to find out value of k .

Q: Determine io from the given circuit below. www 2.2 Ω ہے 500 V 200 io www 46 Q ww 50 Q www 30 Ω 9Q

A:

Q: VS 20 V * IT Perform node analysis in the circuit. N1 N2 R1 2k2 R4 3.3 k2 ww R3 1k2 R2 3.3 k2 N3 R5…

A:

Q: VS 20 V 햏 Perform mesh analysis and node analysis in the circuit. IT N1 N2 R1 2 ΚΩ R4 3.3 ΚΩ R3 1 ΚΩ…

A:

Q: Q4: (answer in phasor form) V = 10 cos 4t b) i=....... Your answer i 592 www 0.1 F +41

A: We need to find out the current for given circuit

Q: Find how many LEDs must be combined to give a total of 1.6 W of visible light output and with the…

A:

Q: contains three 60-watt lamps. The light fixture presently installed over the mirror contains four…

A: A homeowner has asked to install a lighted mirror in a bathroom. The mirror contains eight 40-watt…

Q: . Find the Laplace transforms of (b) 5e²t - 3e-t (a) 1+2t-t4

A:

Q: A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF capacitor and 50…

A: Solution !! L = 80 × 10-6H; C = 2000 × 10-12 F R = 50 Ω; fr = 400 × 103Hz

Q: :PAN is abbreviation of .Private Area Network .Personal Area Network .Public Area Network O .No one…

A: PAN stands for Personal Area Network It provides data transmission among devices such as computers…

Q: PLEASE ANSWER IT NOW, I NEED THE ANSWER Find the total external armature current of a dc machine…

A: Specification of DC machine is given as No. of Armature slot  = 120,ConductorSlot=6,Diameter of…

Q: Given the discrete signal below, determine the value of x(-3) x(n) = n-0.5, -3 <n≤ 4 0, otherwise…

A: We need to find out the value of given signal at given value of n

Q: a. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A:

Q: AC B REQ R₁ = 602 M R₂=802 R₂=402 ww R4 =802 M R₁ = 422 Rg=1002 M R₁ =622 R₂ = 62 www R7 = 802…

A:

Q: Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from -3.8V…

A: We need to find out the number of bits per sample for given signal to noise ratio and given signal…

Q: Calculate the average voltage 3.18 V B) 10 V 6.37 V 7.07 V What is the instantaneous voltage when…

A: We need to find out the average value , instantaneous Value and RMS value for given waveform .

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at co = 50…

A:

Q: 4...

A: Given: Consider the following Simulink diagram: To find: Determine the equation implemented by the…

Q: 1. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A:

Q: Explain the superposition theorem and also explain Thévenin's and Norton's theorems.

A: Explain: Super position Theorem  Thevenin Theorem  Norton Theorem

Q: 4.27 A 10-kVA, 4160/240-V, single-phase transformer has a per-unit resistance of 0.01 and a per-unit…

A:

Q: n a 4*4 Y bus matrix the number of non zero elements are 12. Find the sparsity of the system?

A: Given a 4×4 Y bus matrix. Total number of elements = 4×4=16. Total number of non zero elements = 12.…

Q: 3. Determine I and I2 using current division. 15 A ↑ 2052 W 8 41₁ | 1₂ 30 1₂ 6.2 € 627

A: The given circuit diagram is shown below:

Q: 128. A sine wave has a frequency of 50 Hz. Its angular frequency will be A. 50 radians/sec B. 50 n…

A: Given data, Frequency is given as, f=50 Hz.

Q: Multiply out and simplify to obtain a sum of products: (a) (A + B)(C+B)(D' +B)(ACD' + E)

A: Given: 1.  A+BC+BD'+BACD'+E   Find: Sum of product = ?

Current Division Method

The generalized current divider formula is given by the following relation below,