The osmosis rate in these set-ups will slow down over time. Why? Diffusion Time Vs. Column Height10203040506070Time (in mins)-30% Sucrose-60% SucroseColumn Height (in cm)

Osmosis is the process of diffusion (movement of particles or molecules) of water across a…

Answered: Diffusion Time Vs. Column Height 10 20…

Science

Chemistry

Diffusion Time Vs. Column Height 10 20 30 40 50 60 70 Time (in mins) -30% Sucrose -60% Sucrose Column Height (in cm)

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter21: Surface Characterization By Spectroscopy And Microscopy

Section: Chapter Questions

Problem 21.10QAP

See similar textbooks

Related questions

Q: sely proportional to the column efficiency irectly proportional to the selectivity factor not…

A: B option is correct. Inversely proportional to column efficiency. Band-broadening is a general term…

Q: 1. What is drying to a constant weight? 2. Aside from sieving, what other methods are used to…

A: The detailed solution is shown below.

Q: What other method besides conductivity can be used to determine CMC (critical micelle…

A: Critical micelle concentration (CMC) can be determined by conductometric titration.

Q: 3. The working charge of a four foot adsorption bed is 32.0%. The MTZ and heel were determined to be…

Q: 9. (a) Derive an expression for Langmuir adsorption isotherm for surface reactions with and without…

A: The answers are given below:

Q: For PM Removal using Activated Carbon (AC), is the mechanism only limited to adsorption? Or does it…

A: For PM Removal using Activated Carbon(AC), is the mechanism only limited to adsorption ? Or does it…

Q: What are the physical states of dispersed phase and dispersion medium in foam rubber.

A: A phase is the state of a system. Phase can be solid, liquid and gas. When the solution forms…

Q: A) Continuing from a pre-deposition of dopants to a substrate with a bulk concentration of 1016/cm³,…

Q: A layer of 10 g of iodine is spread uniformly over a surface of area 10 cm? and covered in hexane to…

A: Given: Mass of iodine= 10g Area = 10cm3 Depth = 10 cm Diffusion coefficient = 4.04 * 10-9 m2/s To…

Q: What are the advantages and disadvantages of liquid-liquid extraction method?

A: Principal of liquid-liquid extraction method :

Q: A 4.6 mm X 25-cm column that contains 5 um packing L7. The value 5 um represents; O a. length of the…

A: Dimension of the column, 4.6 mm x 25 cm

Q: list at least 10 scientific journals of chemical analysis of a certain analyte using a specific…

Q: You are centrifuging a test tube of spherical cells in a buffer solution. The buffer viscosity and…

A: Given: Viscosity of buffer=0.02 Pa.s Diameter of cell=4.5 μm Density of cell=1.2 g/cm3 Density of…

Q: A compound microscope has an ocular micrometer calibrated to 12μm for each observable division in…

A: A high-resolution microscope that employs two sets of lenses to provide a two-dimensional image of…

Q: In a microemulsion, effectively all of the surfactant resides at the interface between the phases…

A: Introduction Emulsion: Those liquids that are not miscible to each other are called emulsions. They…

Q: The function of the catalyst or catalyst is to prepare a surface on which the reactants are adsorbed…

A: We know that any substance that increases the rate of a reaction without itself being consumed is…

Q: A thin film of Co was deposited on the end of a long cylinder of Fe3O4. Afterwards, the cylinder was…

A: Diffusion coefficient can be manipulated by using the Fick’s law .The equation for diffusion…

Q: The solvent in a collodial system is also known as the [?] phase. dispersion dispersed particle…

A: Colloidal system is heterogeneous and contains two phases : dispersed phase and dispersion medium.

Q: Standard Tubes Volume of 0.1 Hydroxamate standard Tubes Optical Density (OD) Concentration 0.061…

A: Interpretation: To write the conclusion of the result given.

Q: Select whether the factor will either SHORTEN or LENGTHEN the characteristic of the dosage form.…

A: The answer are as follows:

Q: Sedimentation and Decantation

A: These methods are used for separation of mixture in solution. In sedimentation , the insoluble…

Q: Name the disadvantages of cloud point extraction technique.

A: A question based on analytical process that is to be accomplished.

Q: n simple words, describe the following steps in fabricating an IC: a- Crystal growth; b-…

A: Die preparation is one of the major concerns during semiconductor chip fabrication. Wafer mounting,…

Q: Molar absorptivity is a constant dependent on the following except: a. wavelength. b. solvent. c.…

Q: ist FOUR kinetic variables that affect column efficiency and explain how each variab

A: Band broadening reflects the the loss of column efficiency

Q: 4. determine the amount in mg of the amount of Ag present from ICP mass digested: 1.0821g/L dilution…

A: Inductively coupled plasma mass spectrometry, commonly known as ICP-MS, is one type of spectrometry…

Q: If initial and equilibrium concentration of acetic acid before and after the adsorption is 1…

A: When the molecules of a substance are attracted and adhered to the surface of a solid, the…

Q: Choose the appropriate techniques for degassing the mobile phase of HPLC. I. Ultrasonic II. Boiling…

Q: In a sample of MgO held at 1500°C grains of MgO grew from 1um diameter to 10 um diameter in 1 hour.…

A: Answer: In given data: T = 15000C, diameter= 1 to 10 um. time = 1.0 hrs. Diffusion energy = 250…

Q: Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve…

A: The van Deemter equation is a relationship between the height of the plate during the flow of mobile…

Q: Carbon nanotubes can be produced by ..method * chemical vapor deposition Sol-Gel physical vapor…

Q: TRUE OR FALSE Powders that have low density and high porosity are free flowing. Surface roughness…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 7.10 A simple cubic (a = 0.3 nm) substrate has been cut along the (100) at a 3° angle to create a…

A: Answer: Yes. Explanation: Diffusion length is calculated as follows: 'L = (Dt)1/2' D is the…

Q: The following data apply to a 1g sample of a granular powder Volume of the solid alone = 1 cm3/2g…

A: Given: Volume of the solid alone = volume of grain = 1 cm3/2g Volume of intraparticle pores = pore…

Q: How long is a microcentury, if a lecture period (50.0 min) is close to 1.00 microcentury?

Q: What is the dimension of a chlorine contact chamber if the CT value is 150 mg-min/L at the chlorine…

A: Given: CT value=150 mg-min/L Chlorine concentration=5 mg/L

Q: A researcher wants to calculate the flux of palm oil (PO) in a simulated body fluid (SBF). To…

A: Here this problem is the diffusion of Palm oil (PO) from the stock solution (10 g PO/ lit SBF) to…

Q: Leaching of Oil from Soybeans in a Single Stage. Repeat Example 12.9-1 for single-stage leaching of…

Q: Create a flowchart for the procedures in the determination of water hardness.

A: A question based on determining the hardness of water, which is to be accomplished.

Q: What factor(s) will affect the magnitude of hysteresis of sorption isotherm? I. The nature of food.…

A: factor(s) will affect the magnitude of hysteresis of sorption isotherm

Q: What roles do solvent, density and polarity play in liquid/liquid extraction

A: i. Solvent = In liquid - liquid extraction, the solvent which is needed to be extracted should not…

Q: 8. The diffusion coefficient, D, of tetracycline in a hydroxylethyl methacrylate membrane is 8.2 x…

Q: η helium = 1.88 x 10-5 Pa s at 0 C, calculate the diffusion coefficient and the thermal conductivity…

A: Diffusion Coefficient the quantity of a substance that in diffusing from one region to another…

Q: In a homogeneous isothermal liquid polymerization, 20% of the monomer disappears in 34 minutes for…

Q: A silver-30%gold alloy sample (cylindrical with 1 cm diameter and 0.3 cm height) is subjected to a…

A: The time can be calculated by Faraday's law, m = EitFm: mass of silveri: current (Ampere)F:…

Q: Standard Solutions for FENCS2* Ion Beer-Lambert Plot mL of 2.00 x 101 M Fe(NO,)3 in 0.10 M HNO, mL…

Question

The osmosis rate in these set-ups will slow down over time. Why?

Diffusion Time Vs. Column Height
10
20
30
40
50
60
70
Time (in mins)
-30% Sucrose
-60% Sucrose
Column Height (in cm)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Calculate the bulk density of a 110 cm3 soil sample that has a 25 percent water content (gravimetric or mass basis) and weighs 150 g.
An amino acid moves randomly through water with steps of about 3 angstroms (3 x 10^-8 cm) in length at a rate of 1 x 10^10 steps per second. This substance is passing through a reverse phase HPLC column which has a plate height of 0.010 cm. 1. Estimate the diffusion coefficient for the amino acid in water. 2. Calculate the width at the base of the elution zone after the amino acid has migrated 50 cm through the column
Chemistry Whats the definition of transfer and persistence in forensic science with historical and recentliterature references
TRUE OR FALSE Powders that have low density and high porosity are free flowing. Surface roughness leads to poor flow characteristics. Micromeritics affects the maximum penetration of inhalation aerosols based on particle size. The greater the number of particles per dose, the lower the variability between dosage units. Bulk volume is the volume of spaces. Laser light scattering technique enables the use of surfactants to determine the primary particle size. The bioavailability of poorly soluble drugs influenced by state of subdivision of the drug. Spatulation is the technique of choice when blending small amounts of powders. Bulkiness decreases with increase in particle size Powders require disintegration before the onset of action. The more asymmetric a particle, the greater the surface area per unit volume Packing is the ratio of the void volume to the bulk volume.
A supporting electrolyte is usually added to the analyte solution to minimize solution resistance.minimize solution conductivity.make the analyte less soluble in solution.increase the scan rate.
Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve look like if the multiple path term were 0? If longitudinal diffusion were 0? If the finite equilibration time were 0?
spectrofluorometry is potentially more sensitive and selective compared tospectrophotometry
Define the following terms used in HPLC: (d) sampling loops (e) bonded-phase packing (f) gel filtration
Explain the following: 1. Batch Adsorption 2. Contact time 3. Equilibrium 4. Point of zero charge
Column length: 25.0 cm Column diameter: 0.46 cm Stationary phase: C-18 Mobile phase: 80% methanol in water Flow rate: 1.0 mL/min Dead time: 5 min Peak width at base, WA = 20 Peak width at base, WB = 24
A typical split ratio is in ........ratio for .........quantity of sample?
Surface agents that prevent particle agglomeration are: A. Pathogens b. foaming C. ATP d. Emulsifiers