Dilutions From a 2.0 M Stock Solution 39 SEP Interpret Data The table shows the volume (Vstock) of a 2.0M M9SO4 stock solution needed to make several different 1 L dilutions at the molarities (Mdilute) shown. Complete the table by determining how much stock solution you should measure out to make 1 L of Dilution 3. Mailute (mol/L) МxV Vstock (L) Valute Dilution (mol) (L) 0.5 1 Dilution 1 0.375 0.75 0.75 Dilution 2 1 0.5 Dilution 3 1

Dilutions From a 2.0 M Stock Solution 39 SEP Interpret Data The table shows the volume (Vstock) of a 2.0M M9SO4 stock solution needed to make several different 1 L dilutions at the molarities (Mdilute) shown. Complete the table by determining how much stock solution you should measure out to make 1 L of Dilution 3. Mailute (mol/L) МxV Vstock (L) Valute Dilution (mol) (L) 0.5 1 Dilution 1 0.375 0.75 0.75 Dilution 2 1 0.5 Dilution 3 1

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter1: Matter, Measurements, And Calculations

Section: Chapter Questions

Problem 1.126E

See similar textbooks

Similar questions

Specifications for lactated Ringers solution, which is used for intravenous (IV) injections, are as follows to reach 100. mL of solution: 285315 mg Na+ 14.117.3 mg K+ 4.9Q.O mg Ca2+ 368408 mg Cl 231261 mg lactate, C3H5O3 a. Specify the amount of NaCl, KCl, CaCl2 2H2O, and NaC3H5O3 needed to prepare 100. mL lactated Ringers solution. b. What is the range of the osmotic pressure of the solution at 37C, given the preceding specifications?
Consider two solutions at a certain temperature. Solution X has a nonelectrolyte as a solute and an osmotic pressure of 1.8 atm. Solution Y also has a nonelectrolyte as a solute and an osmotic pressure of 4.2 atm. What is the osmotic pressure of a solution made up of equal volumes of solutions X and Y at the same temperature? Assume that the volumes are additive.
You have two aqueous solutions separated by a semipermeable membrane. One contains 5.85 g of NaCl dissolved in 100. mL of solution, and the other contains 8.88 g of KNO3 dissolved in 100. mL of solution. In which direction will solvent flow: from the NaCl solution to the KNO3 solution, or from KNO3 to NaCl? Explain briefly.
The Henry's law constant for the solubility of radon in water at is 9.57106 M/mm Hg. Radon is present with other gases in a sample taken from an aquifer at 30C. Radon has a mole fraction of 2.7106 in the gaseous mixture. The gaseous mixture is shaken with water at a total pressure of 28 atm. Calculate the concentration of radon in the water. Express your answers using the following concentration units. (a) molarity (b) ppm (Assume that the water sample has a density of 1.00 g/mL.)
You have read that adding a solute to a solvent can both increase the boiling point and decrease the freezing point. A friend of yours explains it to you like this: The solute and solvent can be like salt in water. The salt gets in the way of freezing in that it blocks the water molecules from joining together. The salt acts like a strong bond holding the water molecules together so that it is harder to boil. What do you say to your friend?
The Henry's law constant for the solubility of argon gas in water is 1.0103M/atm at 30C. (a) Express the constant in M/mm Hg. (b) If the partial pressure of argon gas at 30C is 693 mm Hg, what is the concentration (in M) of the dissolved argon gas at 30C? (c) How many grams of argon gas can be dissolved in 29 L of water at 693 mm Hg and 30C? (Ignore the partial pressure of water.)
Calculate the percent by mass of solute in each of the following solutions. 5.00 g of calcium chloride dissolved in 95.0 g of water 1.00 g of calcium chloride dissolved in 19.0 g of water 15.0 g of calcium chloride dissolved in 285 g of water 2.00 mg of calcium chloride dissolved in 0.0380 g of water
Beaker A has 1.00 mol of chloroform, CHCl3, at 27C. Beaker B has 1.00 mol of carbon tetrachloride, CCl4, also at 27C. Equal masses of a nonvolatile, nonreactive solute are added to both beakers. In answering the questions below, the following data may be helpful. Write , =, or more information needed in the blanks provided. (a) Vapor pressure of solvent over beaker B vapor pressure of solvent over beaker A. (b) Boiling point of solution in beaker A boiling point of solution in beaker B. (c) Vapor pressure of pure CHCl3 vapor pressure of solvent over beaker A. (d) Vapor pressure lowering of solvent in beaker A vapor pressure lowering of solvent in beaker B. (e) Mole fraction of solute in beaker A mole fraction of solute in beaker B.
A 12-oz (355-mL) Pepsi contains 38.9 mg caffeine (molar mass = 194.2 g/mol). Assume that the Pepsi, mainly water, has a density of 1.01 g/mL. For such a Pepsi, calculate: (a) its caffeine concentration in ppm; (b) its molarity of caffeine; and (c) the molality of caffeine.