Each graph below represents a titration involving solutions of two of the following substances: HCl, HNO₂, KOH and NH OH. PH A pH Vbase B V base PH Which graph best represents HCl being titrated using KOH? -- Which graph best represents HNO, being titrated using KOH? -- Which graph best represents HCl being titrated using NH OH? Which graph best represents HNO, being titrated using NH OH? Which graph has the highest pH at the equivalence point? Which graph has the equivalence point pH that is equal to 7? -- -- + C - > Vbase PH D anks by selectin each menu Vbase

Each graph below represents a titration involving solutions of two of the following substances: HCl, HNO₂, KOH and NH OH. PH A pH Vbase B V base PH Which graph best represents HCl being titrated using KOH? -- Which graph best represents HNO, being titrated using KOH? -- Which graph best represents HCl being titrated using NH OH? Which graph best represents HNO, being titrated using NH OH? Which graph has the highest pH at the equivalence point? Which graph has the equivalence point pH that is equal to 7? -- -- + C - > Vbase PH D anks by selectin each menu Vbase

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter15: Additional Aqueous Equilibria

Section: Chapter Questions

Problem 111QRT: Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong...

See similar textbooks

Similar questions

Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong acid HA with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: (a) After a very small volume of titrant has been added to the initial HA solution? (b) Halfway to the equivalence point? (c) When enough titrant has been added to take the solution just past the equivalence point? (d) At the equivalence point? Nanoscale representations for Question 111.
Sketch the titration curve for a weak acid titrated by a strong base. When performing calculations concerning weak acidstrong base titrations, the general two-slep procedure is to solve a stoichiometry problem first, then to solve an equilibrium problem to determine the pH. What reaction takes place in the stoichiometry part of the problem? What is assumed about this reaction? At the various points in your titration curve, list the major species present after the strong base (NaOH, for example) reacts to completion with the weak acid, HA. What equilibrium problem would you solve at the various points in your titration curve to calculate the pH? Why is pH 7.0 at the equivalence point of a weak acid-strong base titration? Does the pH at the halfway point to equivalence have to be less than 7.0? What does the pH at the halfway point equal? Compare and contrast the titration curves for a strong acidstrong base titration and a weak acidstrong base titration.
Follow the directions of Question 64. Consider two beakers: Beaker A has a weak acid(K a=1105). Beaker B has HCI. The volume and molarity of each acid in the beakers are the same. Both acids are to be titrated with a 0.1 M solution of NaOH. (a) Before titration starts (at zero time), the pH of the solution in Beaker A is the pH of the solution in Beaker B. (b) At half-neutralization (halfway to the equivalence point), the pH of the solution in Beaker A the pH of the solution in Beaker B. (c) When each solution has reached its equivalence point, the pH of the solution in Beaker A the pH of the solution in Beaker B. (d) At the equivalence point, the volume of NaOH used to titrate HCI in Beaker B the volume of NaOH used to titrate the weak acid in Beaker A.
A buffer is prepared in which the ratio [ H2PO4 ]/[ HPO42 ]is 3.0. (a) What is the pH of this buffer? (b) Enough strong acid is added to convert 15% of HPO42- to H2PO4-. What is the pH of the resulting solution? (c) Enough strong base is added to make the pH 7.00. What is the ratio of [H2PO4-] to [HPO42-] at this point?
Another way to treat data from a pH titration is to graph the absolute value of the change in pH per change in milliliters added versus milliliters added (pH/mL versus mL added). Make this graph using your results from Exercise 61. What advantage might this method have over the traditional method for treating titration data?
A monoprotic organic acid that has a molar mass of 176.1 g/mol is synthesized. Unfortunately, the acid produced is not completely pure. In addition, it is not soluble in water. A chemist weighs a 1.8451-g sample of the impure acid and adds it to 100.0 mL of 0.1050 M NaOH. The acid is soluble in the NaOH solution and reacts to consume most of the NaOH. The amount of excess NaOH is determined by titration: It takes 3.28 mL of 0.0970 M HCl to neutralize the excess NaOH. What is the purity of the original acid, in percent?
The titration of Na2CO3 with HCl bas the following qualitative profile: a. Identify the major species in solution at points AF. b. Calculate the pH at the halfway points to equivalence, B and D. (Hint: Refer to Exercise 113.)
Consider the nanoscale-level representations for Question 110 of the titration of the aqueous weak acid HX with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: After a very small volume of titrant has been added to the initial HX solution? When enough titrant has been added to take the solution just past the equivalence point? Halfway to the equivalence point? At the equivalence point? Nanoscale representations for Question 110.
What is an acidbase indicator? Define the equivalence (stoichiometric) point and the end point of a titration. Why should you choose an indicator so that the two points coincide? Do the pH values of the two points have to be within 0.01 pH unit of each other? Explain.
Define a buffer solution. What makes up a buffer solution? How do buffers absorb added H+ or OH with little pH change? Is it necessary that the concentrations of the weak acid and the weak base in a buffered solution be equal? Explain. What is the pH of a buffer when the weak acid and conjugate base concentrations are equal? A buffer generally contains a weak acid and its weak conjugate base, or a weak base and its weak conjugate acid, in water. You can solve for the pH by setting up the equilibrium problem using the K.a reaction of the weak acid or the Kb reaction of the conjugate base. Both reactions give the same answer for the pH of the solution. Explain. A third method that can be used to solve for the pH of a buffet solution is the HendersonHasselbalch equation. What is the HendersonHasselbalch equation? What assumptions are made when using this equation?
A diprotic acid, H2B(MM=126g/moL), is determined to be a hydrate, H2B xH2O. A 10.00-g sample of this hydrate is dissolved in enough water to make 150.0 mL of solution. Twenty-five milliliters of this solution requires 48.5 mL of 0.425 M NaOH to reach the equivalence point. What is x?
When a diprotic acid. H2A. is titrated with NaOH, the protons on the diprotic acid are generally removed one at a time, resulting in a pH curve that has the following generic shape: a. Notice that the plot has essentially two titration curves. If the first equivalence point occurs at 100.0 mL NaOH added, what volume of NaOH added corresponds to the second equivalence point? b. For the following volumes of NaOH added, list the major species present after the OH reacts completely. i. 0 mL NaOH added ii. between 0 and 100.0 mL NaOH added iii. 100.0 mL NaOH added iv. between 100.0 and 200.0 mL NaOH added v. 200.0 mL NaOH added vi. after 200.0 mL NaOH added c. If die pH at 50.0 mL NaOH added is 4.0 and the pH at 150.0 mL NaOH added is 8.0, determine the values Ka and Ka. for the diprotic acid. d.