Explain the procedures for assessing the starting system and its components of an automobile. Describe tools & test procedures for checking the battery, wiring, starter motor parts etc.

Q: Make a circuit for representing starting system of vehicle.

A: The starting system is one of the engine's systems, which provides an engine start. To make it, the…

Q: What are the suggestions to prevent the occurrence of failures in car clutch?

A: Suggestion to prevent the occurrence of failure in car clutch: 1. Unnecessarily do not press the…

Q: While discussing secondary voltage: Technician A says that the normal required secondary voltage is…

A: Solution:

Q: Describe the 4 distinct modes the vehicle should be operated in during a road test when diagnosing…

A: Four distinct modes the vehicle should be operated in during a road test when diagnosing final…

Q: Who is correct?

A: 1. As par Faraday's Law Of Induction "The megnitude of emf induced into the conducting loop is…

Q: Among the following, which drive transmits exact velocity ratio during power transmission. Gear…

A: Gear drive

Q: What three functions are performed by the clutch safety switch when the car has an electronic engine…

A:

Q: Risk Assessment: State the impact it can have on the Rover and other (if applicable) and how…

A: A risk assessment is a method of identifying prospective dangers and determining what could…

Q: three types of clutch linkages used in modem vehicles

A: The clutch linkage are used for the connection of clutch pedal and clutch fork  In modern vechiles…

Q: Guide Questions: 1. Do you think that motors can run without electricity? Why do you think so? 2. Do…

A:

Q: 2. Technician A says that load-carrying ball joints should always have some play in them. Techni-…

A: The ball joints basically serve as the pivot point between the tyre and the suspension in an…

Q: Explain with a neat sketch of Electronic Ignition System.

A: Electronic mechanism is that the style of mechanism that uses electronic circuit, usually by…

Q: What type of electromagnetic clutch is used in late model vehicles

A: Electro magnetic clutches also known as electro - mechanical clutches. Because these clutches…

Q: An engine cranks slowly: Technician A says that a possible cause of the problem is poor starter…

A: Given that  An engine cranks slowly: Technician A says that a possible cause of the problem is poor…

Q: 2. How many types of air handling units are there? explain 3. What are the components of an air…

A: Air Handling Unit

Q: Which of the following is true about fluid power? Select all that apply. Group of answer choices A…

A:

Q: Technician A says that throttle position is an important input in most electronic shift control…

A: In electronically controlled automatic transmission, the most appropriate gear ratio for the power…

Q: Design an ignition system used for modern cars.

A:

Q: Among the following, which drive is least reliable in power transmission. O Gear drive O Rope drive

A: The transfer of energy from its place of generation to a place where it is used to do useful work is…

Q: in an automotive environment, what would be the effect of installing the same coil spring into…

A:

Q: What is the primary difference between an automatic traction control system and a stability control…

A: Traction control  system in an automobile is designed to prevent the driving wheel from loosing the…

Q: Design various lubrication systems used for cars and bikes. Does a motorcycle clutch need…

A: Lubrication systems are paramount to the operation of modern day engines. They serve various…

Q: From the following identify the true statement. O In general safety precaution, the operator should…

A: In general safety precaution main motto is to stay safe and stay alive.. Operator should know how to…

Q: Q1.With a neat diagram ,explain about the working of Flash Type  ADC

A: Flash Type ADC is based on the principle of comparing analog input voltage with a set of…

Q: Identify examples of motors used in a new automobile. For example, a motor is used to run the fan…

A: Motor Using in the Automobile:- The Motor is used to the transmitting the power from electric power…

Q: Question: What controls the instroke of a Single-Acting Cylinder? Note: -NO PLAGIARISM PLEASE. -200…

A: Valves controls the instroke of a Single-Acting Cylinder.

Q: Question 1: (answer must be handwritten) What is special about timing belts compared to classic flat…

A:

Q: What are the accessories(and each of its function) attached to the charging system of the internal…

A:

Q: Explain the trip and drive cycle in an OBD II system.

A: On-board diagnostics (OBD) is an automotive term referring to a vehicle's self-diagnostic and…

Q: differentiate b/w overdamped, under damped , criticaly damped, undAmped system

A: The decay of oscillations in a system following a disturbance is described by the dimensionless…

Q: Choose correct answer: In the pneumatic double acting cylinder circuit experiment ,The only port…

A: Solution:

Q: In V-belt drive, why should the upper wrap angle of small pulley be checked to make it greater than…

A: In V - belt drives , power is transferred between at least two pulley per belt. One pulley drive…

Q: replace the mechanical and electrical components of motor vehicles, such as gaskets, belts, hoses,…

A:

Q: Technician A says that a faulty radiator fan relay can cause an engine to overheat. Technician B…

A: The radiator in an automobile is used to take away the excess heat of the engine and sending it out…

Q: Explain about any two types of belt drives with a neat diagram

A: Belt drives are used to transfer power within the short distance between the prime mover and the…

Q: The clutch is a mechanism commonly used within a vehicle which connects rotating shafts and…

A:

Q: Select which one of the following is a gas charged accumulator? a. all of the mentioned b. bladder…

A: Select which one of the following is a gas charged accumulator? Answer: b) bladder type

Q: How do most electronic ignition systems differ?   number of spark plugs   the use of CMP and…

A:

Q: When the starter spins but does not crank the engine,which of the following may be true?a. Defective…

A: Given Starting problem To find Identify the main problem

Q: List three types of clutch linkages used in modem vehicles

A: three types of clutch linkages used in modem vehicles-  The clutch linkage are used for the…

Q: A starter cranks, but cranks slowly. The shop performs a voltage drop on the ground and power side…

A: A starter is a mechanical device which is used to rotate the crank of an internal combustion engine.…

Q: Mobility of a mechanism represents the number of required to run the mechanism. OLinks All of these…

A: Mobility is the number of inputs required to define the motion of mechanism.

Q: List some purposes for controlling the speed or direction of an air motor

A: The air pressure can be changed, the air volume can be changed, or the air pressure and air…

Q: 4. Igniter in engine system as device to ignite the supply , a) Draw the igniter circuit and explain…

A: Operation : When the key is inserted and the car is started the power from battery will flow towards…

Q: Discuss briefly the various types of belts used for the transmission of power.

A: Solution: