Explain the superposition theorem and also explain Thévenin's and Norton's theorems.

Q: Question 2 Find the average value of the voltage in the figure "inn SV ov+ O 1.59 V O 63.7 V 6.37 V…

A: Given data, Waveform is given as,

Q: 4.26 The resistances in the series network of problem 4.1 are measured at 30°C. Their resistive…

A:

Q: How much electric energy in Kwh is delivered to an electric motor during an 8 hour period when…

A: Given: V=230 V, I1=34 A, t1=2 hrs, I2=38 A, t2=1.5 hrs, I3=26 A, t3=4 hrs, I4=12 A, t4=0.5 hr.…

Q: For the op-amp shown in the following figure, if R1 = 100 and Rf = 1 k2, the overall voltage gain is…

A: We need to find out the gain of given non inverting amplifier .

Q: +10V +3V +10 V 2.7k2 100k2 ㅐㅂ -390 k2 2.2k2 (b) The BJTs in the two circuits have B=100 and |VBE| =…

A:

Q: An analog signal xa (t) = sin(480nt) + 3 sin(720 nt) is sampled 600 times per second. Determine the…

A: The minimum sampling rate is twice of the maximum frequency component in signal. It is known as…

Q: 13.For an active low RS FLIP FLOP with a HIGH normal output, the value of its S and R inputs,…

A: The Flip-Flop is a device that stores a bit of information. The Flip-Flop changes its state during…

Q: Example 14.52. An inductor of resistance 10 and inductance 100 mH is in parallel with a 10 nF…

A: Given: An inductor coil of Resistance : R=10 ohm  and L=100 mH=0.1 H is in parallel with a 10nF…

Q: ? The volume of the shperical is dv = R Sine drde O Ødv=R^2 Sine ded Ødv = R Sine drded O Ødy R^2…

A:

Q: 1. Two resistors (R1, R2) are connect in parallel, prove that R₁ = R₁ R2 R₁ + R₂

A:

Q: In decreasing order of experience, the four categories of electrical workers recognized by the…

A: An ACT to protect people and property, establish an electrical administrative board, to license and…

Q: Complement of the expression A'B + CD' is. O a. (A' +B)(C' + D) O b. (A + B)(C' + D) O c. (A+B)(C' +…

A: Given, The expression is, Y=A'B+CD'

Q: 8A + Vo61=45 R₂= SS ↓ SA Рђе 20л

A: We need to find out the current for given circuit , we will find out the node voltage then we will…

Q: An analog signal is to be coded by an ADC.  The signal contains significant frequencies up to 6MHz.…

A: We need to find out number of bits per sample, first we will find out the number of level then we…

Q: 10. Calculate the currents in the following circuit. 15V 100Ω 10002 T HL 9V 1₂ R₂ 100Ω

A: Solution !!

Q: Determine the power dissipated by the element of an electric fire of resistance 20 ohm when a…

A: We need to find out power as energy and cost of energy for given current and time and resistance .

Q: 6. Find the Vo using superposition.

A: It is given that:

Q: Make a ladder diagram for the ff. Interlocking Circuit (2 – way Interlock) Automatic Priority…

A: According to the question, we need to make a ladder diagram for the flip flop, Interlocking Circuit…

Q: Computed (Show complete solutions.) 1. Using the value of the DC power supply as the theoretical…

A: Given  DC Power Supply(Vs) = 20 V R1 = 10 ohms R2 = 25 ohms R3 = 125 ohms All the resistors are…

Q: Perform the following computation (3.7 -1.2j) +2e/4 and show the result in rectangular form. Script…

A: Given, Computation is  n3= (3.7-1.2j)+2ejπ/4 Answer in rectangular form using MATLAB?

Q: 1. The total inductance for this circuit is mh. 4h 2h 3h 1h

A: Given data, L1=4HL2=2HL3=3HL4=1H

Q: 3. Determine l₁ and l₂ using current division. 20A (1 and then for these 1003 200

A: In this question,  We need to determine the current I1  and I2  using the current division method.…

Q: Determine the power dissipated by the element of an electric fire of resistance 20 ohm when a…

A: We need to find out the power and energy and cost of electricity for given problem .

Q: 1. Determine the total resistance and the current along 3 ohms in downward direction. 50V + 65 M 85…

A:

Q: 3. A condenser vacuum gauge reads 715 mm Hg when the barometer stands at 757 mm Hg. What is the…

A: Given, A condenser vacuum gauge reading(hg) = 715mm Hg Barometer reading stands at (ha) = 767 mm Hg…

Q: EXAMPLE 3.1. Determine the transfer function of the given Block Diagram. 600607 G₂ R(s) + E(s) G₁ H₁…

A: We need to find out transfer function , we will find out it by using Mason's gain formula .

Q: 2. Design a clamper circuit to perform the function indicated. Vin 10 V -10 V + Vin DESIGN Si diodes…

A: The given circuit is shown below. Design a clamper circuit.

Q: 14 A circuit of resistance 402 dissipates a power of 16W. Calculate (a) the current flowing through…

A:

Q: A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is…

A: Given: A transmission line has, Reactance, X=1 pu. Sending end voltage, VS==1 pu. Receiving end…

Q: 9. The time constant of the circuit shown in the figure below is A. 25 sec. B. 0 sec. C. .025 sec.…

A: Given data, Circuit diagram is given as,

Q: A centre zero ammeter connected in the rotor circuit of a 6-pole 50 Hz induction motor makes 30…

A: Given- 6-pole 50 Hz induction motor, No. of poles p=6, frequency f=50 Hz, 30 oscillations in 1…

Q: R1 8kQ R2 5kQ R3 1kQ R4 1.5kQ V1 40 12 V R5 3kQ R6 6kQ R7 4.5kQ

A:

Q: Determine the difference and product of the signals below, n = 0, x1(n) — x2(n). What is y(4)? x1(n)…

A:

Q: The segment of a waveform below the zero reference line is the negative or the negative

A: Waveform- The term waveform is define as the graphical or diagrammatic representation of the…

Q: A 15 nC point charge is at the origin in free space. Calculate V1 if point P1 is located .at P1 (-2,…

A: Here the given option is not matching as per the solution. The detailed solution is given in the…

Q: The zero drift of a voltmeter is-2.5V. The same meter is used for a measurement system and it…

A: Given data, Zero drift Zr=-2.5 V. Measured value Vm=100 V.

Q: solution: VI 412 super mode. 2√2 www 30v V2 V3- V1 = 22 15 A V3 30 8.2 How did it become like that??…

A:

Q: Given the RC circuit with AC power supply, if the input voltage is 500 mV, find the frequency for…

A:

Q: S' R' A. From an Active Low SR Latch, Draw the normal and complemented output

A:

Q: From b / answer true or false (answer only five) 1- Electrons in a semiconductor move from the…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 4 subpart.

Q: Determine the total resistance at points a and b of the circuit shown below. a www 6Ω ww 3Ω www 292…

A:

Q: J-KL (K+LM) + (M+LM)

A: Given here a expression and asked to reduce the expression and drawing the circuit.

Q: frequency of 1.5 kHz the open circuit impedance of a length of transmission line is 800∠−50◦ and the…

A: We need to find out characteristics impedance for given transmission line for given open circuit and…

Q: At time t = 0, a sinusoidal voltage 10 sin ωt is applied to an L−R series circuit. Determine an…

A:

Q: Output data ratio of a 8-bit PCM-TDM system sampling 24 voice channels, comparing these using u-law…

A: A TDM PCM communication system consists of a number of user terminals, a switching network, and a…

Q: I fe-4t cos(nt) 8 (4t-1)dt -8

A:

Q: 3. Determine 1₁ and 12 using current division. 12 2010 ent from our this 152 2002

A: Given:    Required:  I1 and I2

Q: A generating station has a connected load of 43 MW and a maximum demand of 20 MW; the units…

A: Given Connected load = 43MW Maximum demand = 20MW Units Generated  = 61.5 x 106 kWh Demand factor =…

Q: Convolve the following continuous-time signals, assuming that Th=1 sec, and T =1.5 sec Plot the…

A:

Q: 2. Using source transformation, find ix. 100V (+ 52 M 105 M 12A dix 85 M 452 (64V

A:

Current Division Method

The generalized current divider formula is given by the following relation below,