Figure 15-47 53 SSM ILW In the overhead view of Fig. 15- 48, a long uniform rod of mass 0.600 kg is free to Problem 52. rotate in a horizontal plane about a vertical axis through its center. A spring with force constant k = 1850 N/m is connected horizontally be- k Wall tween one end of the rod and a Rotation axis fixed wall. When the rod is in equi- librium, it is parallel to the wall. What is the period of the small os- cillations that result when the rod is rotated slightly and released? Figure 15-48 Problem 53.

Figure 15-47 53 SSM ILW In the overhead view of Fig. 15- 48, a long uniform rod of mass 0.600 kg is free to Problem 52. rotate in a horizontal plane about a vertical axis through its center. A spring with force constant k = 1850 N/m is connected horizontally be- k Wall tween one end of the rod and a Rotation axis fixed wall. When the rod is in equi- librium, it is parallel to the wall. What is the period of the small os- cillations that result when the rod is rotated slightly and released? Figure 15-48 Problem 53.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

a vertical uniform beam of length Lthat is hinged at its lower end.A horizontal force F is applied to the beam at distance y from the lower end. The beam remainsvertical because of a cable attached at the upper end, at angle uwith the horizontal. gives the tension T in the cableas a function of the position of the applied force given as a fractiony/L of the beam length.The scale of the T axis is set by Ts= 600 N.Figure 12-49c gives the magnitude Fh of the horizontal force on thebeam from the hinge, also as a function of y/L. Evaluate (a) angle uand (b) the magnitude of .
In Fig. 12-31 show that, if the ball is to swing completely around the fixed peg, then d > 3L/5. (Hint: The ball must be moving at the top of its swing; otherwise the string will collapse.)
A rigid bar of mass M is supported symmetrically by three wires each of length l. Those at each end are ofcopper and the middle one is of iron. The ratio of their diameter, if each is to have the same tension, is equal to (a)YcopperYiron(b) √YironY copper(c)Yiron2Ycopper2(d)YironYcopper
Problem 12-76 could you give the full solution, so that I can understand the calculation
A material of Poisson's ratio 0.5. If a uniform rod it suffers a longitudinal strain of 2*10 -3, what is the percentage increase in volume?
Find the elongation of a rod made of aluminum and copper under a tension of 5.8×103 N. The dimensions of the rod are R=0.5 cm, LAl=10.5 m, LCu=5.5 m (Young moduli are 7.0×1010 Pa for Al and 11×1010 Pa for Cu)
A 45 cm x 45 cm square plate ABCD of uniform thickness is supported by three vertical strings. The first string is located at B, the second is located 15 cm from A alongside AD and the third is at the point midway of side CD. What percent of the load is carried by the second support?
One end of a uniform l = 3.80 m long rod of weight supported by an angle of theta = 37 degrees with the rod. The other end rests against a wall, where held by friction (se ). coefficient of static friction between the wall and rod mu i =0.575 Determine the minimum distance from an additional welght (same the weight of the rod) can hung without causing the rod to point a.
The left-hand end of a uniform rod of mass 2.00 kgkg and length 1.10 mm is attached to a vertical wall by a frictionless hinge. The rod is held in a horizontal position by an aluminum wire that runs between the right-hand end of the rod and a point on the wall that is above the hinge. The cross-sectional radius of the wire is 2.50 mmmm, and the wire makes an angle of 30.0∘∘ with the rod. What is the length of the wire? Express your answer with the appropriate units. An object of mass 90.0 kgkg is suspended from the right-hand end of the rod. What is the increase in the length of the wire when this object is added? Express your answer with the appropriate units. In your analysis do you need to be concerned that the lengthening of the wire means that the rod is no longer horizontal?