Figure (a) shows, in cross section, two long, parallel wires carrying current and separated by distance L. The ratio iliz of their currents is 4.40; the directions of the currents are not indicated. Figure (b) shows the y component B, of their net magnetic field along the x axis to the right of wire 2. The vertical scale is set by Bys - 6.5 nT, and the horizontal scale is set by x, - 23.0 cm. (a) At what value of x> 0 is 8, maximum? (b) If - 3.19 mA, what is the value of that maximum? What is the direction (into or out of the page) of (c) and (d) 2? * (cm) (a) (6) (a) NumbetT35.622 Units om (b) Number 0.00205 UnitsuT (c) out v (dinto

Figure (a) shows, in cross section, two long, parallel wires carrying current and separated by distance L. The ratio iliz of their currents is 4.40; the directions of the currents are not indicated. Figure (b) shows the y component B, of their net magnetic field along the x axis to the right of wire 2. The vertical scale is set by Bys - 6.5 nT, and the horizontal scale is set by x, - 23.0 cm. (a) At what value of x> 0 is 8, maximum? (b) If - 3.19 mA, what is the value of that maximum? What is the direction (into or out of the page) of (c) and (d) 2? * (cm) (a) (6) (a) NumbetT35.622 Units om (b) Number 0.00205 UnitsuT (c) out v (dinto

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a filamentary wire is bent to form a square loop of side 3 m lying in the x -y plane as shown in the figure. If the current flowing in the wire is I = 1A, calculate the magnetic flux density at the center of the loop will be
Problem 10: An infinitely long wire carries a current of I = 150 A. Randomized VariablesI = 150 A Part (a) Consider a circle with a radius r and centered on the wire. Determine the magnitude of the magnetic field B at points along the circle in terms of I and r.
The width of the rectangular ring shown in the figure is l=80 cm. Conductive rod, multion long conductor rails and through a static magnetic field B=z10x u = 1 m/sis moving fast. The rod moves from the point z=0 at time t = 0 s.starts. How many volts is the emf induced between terminals 1 and 2 at t = 5 s?
Consider a conducting ring of radius a and resistance R. part a Case I We first place the ring in a constant magnetic field B = B0 pointing into the page asshown in Figure 9. part b Case II Next, we place the ring from part a in a time-varying magnetic field given byB = B0(1 −t/T)0 < t ≤ T a) Calculate the induced emf in the loop.b) Calculate the magnitude of the induced current in the ring.c) State the direction of the induced current in the ring. Sketch the current and justify youranswer.
Consider the arrangement shown in the figure. Assume that R = 6Ω, l = 1.20 m, and a uniform magnetic field of 2.50 T directed down the page. How quickly must the rod move to produce a current of 0.500 A in the resistor?
. Consider two wires of length 1m carrying currents i1 = 2A and i2 = 4A with directionindicated in the following figure. So answer what is asked.(a) What is the resultant magnetic field strength at point P in the figure?(b) Determine the distance d for the current cable i1 from a point Q where the field strengthresulting magnetic field is zero.(c) What would happen to the magnetic field strength if the current i1 were 4A?
A current flows through a long straight conductor. If the magnetic field strength at a distance of 5 cm from the conductor is 8 mT, calculate the current flowing through the conductor.
The two conductive bars slide over the two fixed rails as shown in the figure. If the magnetic field is b=0.2 less Wb / m2, which of the following is the induced EMC on the cycle? Please select one: A. -1.2 V B. 3.6 V C. -2.4 V D. 4.8 V
Below is the magnetic circuit with two windings and two air gaps. The cross-sectional area is constant in the parts of the air gaps and within the whole core and is shown with Ac. g1 = 1 mm, g2 = 0.5 mm, Ac = 200 mm2, i1 = 5 A, i2 = 3 A, N1 = 100, N2 = 50. Also, the magnetic permeability of the core can be accepted as μr = ∞. According to this information, a) Magnetic flux density in the air gaps,a) Self inductance of the windings, b) Calculate the mutual inductances between the windings.
A current of I = 2 A flows in the +z direction through an infinitely long conductor wire placed along the z-axis. What is the magnetic field strength 3cm from the wire? It is A/m.
What would be the magnetic flux density (B) value in a 50 cm radius toroid wound on a ferromagnetic core with 100 turns, relative magnetic permeability of μr=1000, carrying 250 Ampere current? (μ0=4π10^−7(H/m))
An infinitely long straight wire carrying current I = 2A as shown in figure. What will be the total magnetic flux crossing through the rectangular loop ?