Question
Find
in e rut
3 2
12A
T.F
Expand
Transcribed Image Text

Find in e rut 3 2 12A T.F

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: imu omplete SY%

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: SO dependent youpe sunce Tx o.S 22V 54

A: Consider the Two nodes V1 and V2 as shown;

Q: A single phase overhead transmission line delivers 4000 kW at 11 kV at 0·8 p.f. lagging. If resistan...

A: The equivalent circuit diagram is as follows:

Q: A 230-kV, three-phase transmission line has a per phase series impedance of .... (please see attache...

A: We only answer the first three parts of a question on this platform, unless specified otherwise. Sin...

Q: Finel)inefollo Can ollomh -0 et 2v2 ols) Lo

A: When t < 0, the switch is open and there is no independent source connected to the circuit.So, at...

Q: Find the charge q(t) flowing through an device if the current is:(c) i(t)= 20 cos(10t + π/6)10^-6A, ...

A: Charge is defined as integral of current over a certain interval of time. The mathematical expressio...

Q: 12- Find i(t) and v(t) in the following circuit. You may employ any method you wish. 24"φ

A: When t < 0, the inductor acts as a short circuit.So, at time t=0, we will get :

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.25

A:  First, find out the canonical form from the given transfer function    and after that design a cont...

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive- a...

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and f...

Q: Nt

A: To find the thevenin resistance or equivalent resistance:Thevenin resistance is determined by open  ...

Q: The circuit in the attached image has voltage gain |VL|/|Vi|=170 What is the voltage gain |VL|/|Vi| ...

A: The voltage gain for given circuit needs to be determined.

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.18

A: (a). Numerator part of the gain:b(s) = b1sn-1 + b2sn-2 + …………+ bn…………………… (1)Denominator part of the...

Q: 2Ω 4Ω 1H3%(t)に0 - 2A

A: When t < 0, the inductor acts as a short circuit. Let us say that current through the inductor is...

Q: Draw an impedance diagram for the electric power system shown in the figure attached, showing all im...

A: We can obtain the impedance diagram by using below steps: -The base voltage VBG1 on the LV side of T...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: please help with question 45. thank you

A: The values of Z0, Z1, Z2 and Z3 as a function of A, B, C and D should be obtained by the following s...

Q: Use linearity and the assumption that Vo = 1 V to find the actual value of Vo in the following circu...

A: A linear circuit is one whose output is linearly related or in other words which is directly proport...

Q: At t=1ms is the i=12(a estimated number)/1=12A or is it i=30/2=15A.

A: From the definition of current i(t), it can be expressed as the time derivative of charge q(t). The ...

Q: Please see the attached photo to view my question. Thank you.

A: Refer to the given Figure, the initial voltage v(0) is zero for t < 0.

Q: Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diamet...

A: The capacitance of each conductor to neutral per 100 km of the line should be calculated as: -

Q: 93uF 7 L 301 3302 5 Pa ssband ain190 vj İVJ I got the exact ftsl98.0549Hz- vil is the Voltage gan Va...

A: Write the expression to find exact value of lower cutoff frequency for the given circuit as follows:

Q: A 200 km, 3-phase transmission line has its conductors placed at the corners of an equilateral trian...

A: (i)  The line to neutral capacitanceGiven values: -The radius of each conductor is given as r = 1 cm...

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

Q: Find the steady state response for i0(t) in the circuit in fig 9.29 if Vs=100sin50t mV

A: Steady state response for the current needs to be calculated using the below given data and figure:

Q: i Gu Pevse use Modol or mesn 10 A 2 Thearen 2Ω 12 10

A: Let us apply supernode at nodes 1 and 2:

Q: When you are converting an instantaneous current to a phasor, how does the phase angle being positiv...

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form o...

Q: Problem 1: derive an expression for the amplitude of the output voltage as a function of R1, R2, c, ...

A: Problem:1 Since this an Amplifier and its amplification factor is infinite. So, voltage at positive ...

Q: A (medium) single phase transmission line 100 km long has the following constants: Resistance/km/pha...

A: As per the norms, we answer three parts of a question. Since your question contains four parts, we s...

Q: Can someone help me with question 2 please? Derive  Vout(t) expression for the circuit in figure 1 a...

A: Part (A) (For circuit in Figure 1):Notice that, the value of resistance and input frequency are chan...

Q: une nodal amolipis to Soue the euit omol vo bupe loop ondly sij ho sohe hme ardu and iud Vo S Vo Sl ...

A: This problem will be solved by the application of Kirchoff's Voltage Law and current law. According ...

Q: 2. Assuming ideal diode models, find status of diodes Di and D2 (on or off) D2 + 15V 10% +

A: First, assume both diodes are on,

Q: help me with ques 8A

A: Consider the four inputs namely A, B, C, and D and its respective outputs are mentioned as X1, X2, X...

Q: 3. Find the current in the Silicon diode in the following circuit. Diode's I-V curve is given below....

A: For the below circuit and Diode’s, I-V curve, to calculate the current in the Silicon diode: -

Q: The initial voltage across a 7.5F capacitor is 4.5V after 0.5 seconds. If the current is described a...

A: Initial voltage Vo=4.5 VC=7.5FAt 0.5s current is given as:

Q: 3.31 Find the node voltages for the circuit in Fig. 3.80. C, ML 1S2 4lo 2v V1 V2 11o 4 92 4Ω 1S2 ÷) ...

A: Nodal analysis primarily depends on the application of Kirchoff\'s Current Law (KCL) to various esse...

Q: In the following circuit calculate 1, and Vo. Name the method you are using. 21

A: Applying KVL in Loop 1 we get:

Q: How to convert the following decimal number to numbers with metric prefixes in following below?29) 5...

A: We need to convert the given numbers to numbers with metric prefixes.

Q: A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end i...

A: It is given that:

Q: From this equation: How was this equation derived? Then from that derivation, how was this equation ...

A: The below equation should be derived from the given equation.

Q: 3.45 Find current i in the circuit of Fig. 3.91. ML 492 8 92 4 A 2Ω 6Ω ts 30 V (+ ΙΩ Figure 3.91

A: There is a current source in the given circuit. So , we are applying nodal analysis.

Q: Convert the following numbers to scientific notation.Following these Question and answer.29) 5000 KΩ...

A: We need to convert the numbers given below into scientific notations.

Q: 1012 112 100 V Figure 4.20 System diagram for Problem 4.2a 1 2 10 2 100 V Figure 4.21 System diagram...

A: a) For calculating the pick up current here we have to calculate the line to line current for bus A ...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...

Q: Hoq do current transformers differ from voltage transformers?

A: Current Transformer is used to measure current while, Voltage transformer is used to measure voltage...

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

Q: please help me with the question 8M

A: We can start with the truth table for input. The ASCII code corresponding to each letter from A to J...

Q: The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and ...

A: The conductors of 3 phase line are arranged in horizontal plane.

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.