Question

Find out causal inverse Laplace transform of the following:::

 

X(s)=4s/s(s-4)

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Draw the magnetic field lines for a solenoid (current flowing through many loops of wire wrapped aro...

A: The following figure shows magnetic field lines due to a solenoid. Note: As shown in the above figu...

Q: Express a signum function sgn(t) in terms of unit step function u(t).

A: Signum function sgn(t) is a very important singularity function which is used in signal processing. ...

Q: Determine the branch currents, using KVL andloop analysis in the circuit of Figure P3.35.VS2 = VS3 =...

A: Draw the currents in both the loops.

Q: The current through a 0.5-H inductor is given byiL = 2 cos(377t + π/6).Write the expression for thev...

A: The values of current and inductance are:

Q: Part a & b only.

A: DTFT of a discrete signal x[n] is given as

Q: I'm stuck filling in the values

A: Part a: Calculate the equivalent resistance of the circuit, Apply Ohm’s law and calculate the curre...

Q: Assume the channel bandwidth is 3100 Hz and the maximum data rate is 35 kb/s. To improve the maximum...

A: Click to see the answer

Q: Vs 3k2 ZRL Soke The circuit is connected to a load resistor RL. Suppose we want to select Vs so that...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Determine the unknown voltage Vị and Va from the following circuit: Given: Vs1=12 V, Vsz=-4 V, V2=2 ...

A: According to Kirchhoff's voltage law (KVL), the total voltage drop across any closed loop is zero. I...