Find the necessary volume V of a CSTR for the following problem dm³ min C V = 10 CAO V = ? Ca = 0.1 - CAO The reaction is first order (-TA = KCA) with a rate constant of k = 0.23 min-¹

Q: 2. An oil of SG of 0.8 is flowing through a venturimeter having inlet diameter of 20 cm and throat…

A: given = SG = 0.8 d1 = 20 cm = 0.2 m d2 = 10 cm = 0.1 m x = 25 cm of Hg = 0.25 m of Hg

Q: Can you prove this sta 9log2=log512

A:

Q: For the process given below: with G₂ (s) = 12.8e-s 16.7s +1 Gm (S)=1 Gr(s)=1 Calculate PI controller…

A:

Q: Analyze the following images. Identify the type(s) of corrosion. Clearly state your assumptions.…

A: By seeing this image, we can infer that this is an image of a switchboard and by the use of screws…

Q: A _____________ reactor approaches a _____________ reactor at infinite recycle Fill in the blanks…

A: When a product stream from a plug flow reactor is divided and one part of it is sent to the reactor…

Q: The intrinsic viscosity of a sample of poly(methyl methacrylate) is 22.04 cm3g-1 in toluene at 25°C…

A: Given Intrinsic viscosity of a sample of poly(methyl methacrylate),η= 22.04 cm3g-1 in toluene at…

Q: Q2/A) A tank having a time constant of (1 min) and a resistance of ((1/9) ft/cfm) is operating at…

A:

Q: For the product solution, H₁ = 2.178 kJ/mol r= (44,400 mol H₂O)/(5480 mol HCI) = 8.10 HCl(g. 25°C)…

A: We have to find change in enthalpy of HCl when r = 8.1 From given table for HCl at r = 5, ∆H =…

Q: How do chemical engineers contribute to the development of clean water and wastewater treatment…

A: a )Chemical engineers create and improve treatment systems, such as sedimentation tanks, filtration…

Q: Q2: Air flows isentropically from a reservoir through a nozzle; PR = 60 psia, and TR= 100 F. At some…

A: The heat capacity ratio, K = 1.4 The molecular weight of air, MW = 29 g/mol The pressure at inlet,…

Q: A chromatography column is used to separate four amino acids: glutamic acid, serine, alanine, and…

A: Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: R16.12 For a system in which the gas-phase reaction N₂ + 3H₂ → 2NH3 is occurring, the slope of a…

A: Rate of reaction is proportional to change of moles of any species "i" with respect to time

Q: 27.12 We are interested in the diffusion of CO₂ gas out of a randomly porous adsorbent material slab…

A: Let, the carbon dioxide (CO2) and air be denoted by species A and B respectively. the unaccomplished…

Q: A binary mixture of n-heptane and n-octane at its boiling point containing 70% (mol percent) of…

A: A mixture of n-heptane and n-pentane is separated into distillate and bottom product in a continuous…

Q: Discuss the need for a purge gas in TGA

A: TGA stands for thermogravimetric analysis. By TGA , we can characterise the given sample of mixture…

Q: A distillation column contains a mixture of 60% benzene and 40% toluene, by mass, at 1 atm pressure.…

A: Mole fraction of benzene in feed, XF,B = 0.6 Mole fraction of toluene in feed, XF,T = 0.4 Feed rate,…

Q: Cpol (g/dL) Time (s) 0,40 743,3 0,35 711,3 0,30 673,3 0,25 620 0,20 583 0,15 542,2 0,10 466,4 0,05…

A: η=kρt , where k= viscometer constant                            ρ=density of solution…

Q: 2. Ethanol (C₂H5OH) melts at -114°C and boils at 78 °C. The enthalpy of fusion of ethanol is 5.02…

A: Initially, ethanol is at 35℃ it will first go to 78℃ then it will vaporize. hence we will calculate…

Q: How to derive these 3 equations for an adiabatic system? Please help also mention variable name.

A: Adiabatic index, also called heat capacity ratio, can be expressed as the ratio of heat capacity at…

Q: 6.26. A vessel of 0.15-m³ volume containing saturated-vapor steam at 150°C is cooled to 30°C.…

A: The volume of the vessel, V = 0.15 m3 The initial temperature of saturated vapor, T1 = 150 °C The…

Q: Find the minimum amount of air required for burning a fuel oil with a composition of 85.2% carbon,…

A: Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: distillation column contains a mixture of 60% benzene and 40% toluene, by mass, at 1 atm pressure.…

A: Benzene is more volatile compare to toluene thus benzene is separated at top and toluene at bottom.…

Q: The answer is 164 mmHg for the pressure.  Demonstrate how to obtain this number by using the Antoine…

A: The pressure of the feed stream is to be calculated.

Q: Estimate the mass feed rate (g/min) of HOCl and of NH3 to achieve a monochloramine residual of 1.8…

A: Volumetric flow rate = 38,000 m3/day Concentration of monochloroamine = 1.8 mg/L

Q: Hydrogen gas can be produced by heating methane gas CH4 and water vapor with a nickel catalyst to a…

A:

Q: How was 146 degrees Celcius obtained?  I know how the 5250 mmhg was obtained.

A: Temperature corresponds to the vapor pressure of the n-hexane is to be calculated.

Q: 2 When conducting an experiment on the adsorption of acetaldehyde on TiO₂ at 25 celsius degree…

A: The Langmuir equation is q = qmaxKC1+KCqqmax = KC1+KC1+KCKC = qmaxq1q = 1Kqmax1C + 1qmax…

Q: The raw water source to this new plant has a daily incoming natural alkalinity of 150 mg/L present…

A: Given reaction is- Al2(SO4)3 + 6H2O + 6HCO3- → 2Al(OH)3(S) + 6H2CO3 + 3SO42- Natural alkalinity of…

Q: calculate the values of AH°, ASO, AGO, AS environment, and AS universe (Answer: -1559.7 kJ, -310.3…

A:

Q: Consider the diffusion of some hypothetical metal Y into another hypothetical metal Z at 950°C;…

A: T  = 9500C = 1223 K t1= 10h = 36000 s t2= 17.5 h = 63000 s x1 = 0.5 mm = 0.0005 m D0= 4.3 x 10-4…

Q: 1. Calculate the apparent molar concentrations (m) of sodium chloride solutions by using density.…

A: Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: When conducting an experiment of Nadsorption on a sample of coal at 77 Cand in the absence of…

A: N2 gas is adsorbed in the surface of coal. The pressure versus specific volume data for the…

Q: A linear hydrophilic polymer was added to a suspension of nano-size particles with 20 nm radius in…

A: The addition of a linear hydrophilic polymer to a suspension of nano-sized particles in water causes…

Q: 2. Determine the heating value of nonane, a type of liquid fuel in Btu/lb. 2.1 If nonane's specific…

A: 2.1 To calculate the heating value of nonane when its specific gravity has been modified due to…

Q: 12.1- 1. Equilibrium Isotherm for Glucose Adsorption. Equilibrium isotherm data for adsorption of…

A: Glucose adsorption from an aqueous solution to activated alumina is given as   Find Which isotherm…

Q: 4. Using the isothermal transformation diagram for an iron-carbon alloy of eutectoid composition,…

A:

Q: A plant is burning limestone analyzing 47% CaCO3, 45% MgCO3 and 8% inerts. The kiln is fired with…

A: A sample of limestone is burnt in a kiln burner.

Q: 1.+Liquid-liquid extraction of acetic acid from water by isopropyl ether. Isopropyl ether (E) is…

A: a)  As per the given data, the feed and the solvent is represented by point F1 and S respectively.…

Q: A triple-effect backward-feed evaporator concentrates 5 kg/s of liquor from 10 per cent to 50 per…

A: To determine the area required in each effect and the economy of the unit, we need to perform some…

Q: Q1: A slab of high thermal conductivity at temperature T, at zero time receivers on one side a heat…

A: Heat is transferred to a solid slab through conduction at one side and other side is exposed to air.

Q: Gaz fazı reaksiyonu izotermal olarak aşağıdaki reaksiyondaki gibi gerçekleşmektedir. Molar besleme,…

A:

Q: Solid waste D The production of glass creates minimal waste. Waste is limited to packaging waste.…

A: The text describes the waste generated in the production process of glass in the glass industry. It…

Q: Fresh Hexane (liquid) Hexane (liquid) Extractor Condenser Filter Hexane (vapor) Evaporator Waste…

A: Waste oil is to be purified with the hep of series of operations.

Q: In terms of fugacities, comment on the distinction between the fugacity coefficient and and the…

A: A species "i" in a mixture, then what is the difference between  Fugacity coefficient(φi ) vs the…

Q: 4- 1. The flow of kerosenelis measured using a venturimeter. The diameter are 50 mm) and 25 mm…

A: Given that- Diameter of pipe=50 mm=0.05 m Diameter of throat=25 mm=0.025 m Diflection, h= 55 mm of…

Q: 2. Find the humidity and percentage humidity of the mixture when wet and dry bulb temperatures are:…

A: a) Tw = 50^c and Td = 120^c b) Tw = 20^c and Td = 60^c to find = humidity and % humidity

Q: The stoichiometry of dehydrogenation of ethane reaction is given as follows: C2H6C2H4 + H2 (A) (B)…

A:

Q: 29.2 Hydrogen sulfide (H₂S) is a common contaminant in natural gas. The dissolution of H₂S gas in…

A:

Q: A distillation column contains a mixture of 60% benzene and 40% toluene, by mass, at 1 atm pressure.…

A: Mole fraction of benzene in feed, XF,B = 0.6 Mole fraction of toluene in feed, XF,T = 0.4 Feed rate,…

Q: Consider an indoor environment inside which cigarette smoke containing harmful particulate matter is…

A: The governing equation that describes the time-series profile of particulate matter as a function of…