fm Q5: A carrier signal of frequency 91 MHz is frequency modulated by a sine signal of amplitude 10 V and 15 KHz. The frequency modulation constant is 3 KHz/volt. Determine the bandwidth of FM signal. Assuming that the amplitude of modulation signal is doubled then determine the bandwidth. Assuming that the frequency of the modulation signal is doubled then determine the bandwidth.

fm Q5: A carrier signal of frequency 91 MHz is frequency modulated by a sine signal of amplitude 10 V and 15 KHz. The frequency modulation constant is 3 KHz/volt. Determine the bandwidth of FM signal. Assuming that the amplitude of modulation signal is doubled then determine the bandwidth. Assuming that the frequency of the modulation signal is doubled then determine the bandwidth.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2 (AM) A 10 V amplitude sinusoidal signal is used as a modulating signal to generate an AM signal with modulation index 0.8. What is the amplitude of the carrier? What is the power of the side bands? What is the efficiency of the modulated signal?
An AM carrier wave of frequency f = 1MHz with pack voltage of 20V used to modulated a signal of frequency 1kHz with pack voltage of 10v. Determine i. Modulation index (μ) ii. Frequencies of modulated wave? iii. Bandwidth
Briefly explain what it is Single Sideband Modulation
What is the purpose of balanced ring modulator in single-sideband transmission? Describe its operation.
fi(t) is instantaneous frequency. a) Find fc, fm, kf, β ? b)Write the basic euqation of modulated FM signal?
If the amplitude of the modulation signal voltage was given to be -4v and +4v and carrier amplitude also given to be -22v and +22v, by suitable waveform diagram determine the Am modulated output. Remember to provide all necessary wave forms in practical terms.
Describe the general characteristics of the equivalent circuits that apply to the low frequency,midband,and high frequency ranges.
With the aid of diagrams, show and explain how phase locking is used to: demodulate a frequency-modulated (FM) signal. generate a range of frequencies from a single stable frequency source. synchronise an undersampled signal to the carrier frequency.
Calculate the frequency deviation and the carrier swing of a frequency- modulated wave which was produced by modulating a 50.4 MHz carrier. The highest frequency reached by the FM wave is 50.415 MHz. Then calculate the lowest frequency reached by the FM wave. If the frequency of the modulating signal is 5 KHz, what is the bandwidth of the FM wave?
A 93.2 MHz carrier is frequency modulated by a 5-KHz sine wave. The resultant FM signal has a frequency deviation of 40 KHz. (a) Find the carrier swing of the FM signal. (b) Determine the highest and lowest frequencies attained by the modulated signal. (c) What is the modulation index of the FM wave (d) Calculate the percent modulation? (e) Determine the bandwidth using approximation method.
please find enclosed spot of our general expression in our frequency modulation. And in this frequency modulation instantaneous frequency is given as: fi(t)=fc+400cos(2π100t) a)Here carrier frequency is fc, message signal is fm,so please calculate kf ,β(modulation indicator) ve maximum frequency deviation ∆f ? b)Write the simplest form of the FM modular signal by writing the parameters instead. c)Calculate the average power that the FM modulated signal will create on a 1 ohm resistor.
Discuss how the circuit produces a Frequency Modulated Signal