For a dilation with a scale factor not equal to 1, how do the angles and side lengths of the preimage relate to the angles and side lengths of the image? O A. Angles are congruent, side lengths are congruent. O B. Angles are congruent, side lengths are proportional. O C. Angles are proportional, side lengths are congruent. O D Angles are proportional; side lengths are proportional

For a dilation with a scale factor not equal to 1, how do the angles and side lengths of the preimage relate to the angles and side lengths of the image? O A. Angles are congruent, side lengths are congruent. O B. Angles are congruent, side lengths are proportional. O C. Angles are proportional, side lengths are congruent. O D Angles are proportional; side lengths are proportional

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter21: Direct And Inverse Proportions

Section: Chapter Questions

Problem 15A: Of two gears that mesh, the one that has the greater number of teeth is called the gear, and the one...

See similar textbooks

Similar questions

Sue and Daves semicircular driveway is to be resealed, and then flowers are to be planted on either side. Give approximate answers. aWhat is the number of square feet to be resealed? bIf Dave can reseal the driveway at a cost of 0.45 per square feet, what is the cost of resealing the driveway? cIf individual flowers are to be planted 1 foot from the edge of the driveway at intervals of approximately 1 foot on both sides of the driveway, how many flowers are needed?
For Exercises 23 through 34, round the answers to 1 decimal place. 28. All dimensions in Figure 39-18 are in inches. Find the length of belt on the pulleys. Length of belt = 2C=11D+11d7+(Dd)4C
Of two gears that mesh, the one that has the greater number of teeth is called the gear, and the one that has the fewer teeth is called the pinion (Figure 218). For each of the problems, set up a proportion, and determine the unknown value, x. Round the answers to 1 decimal place where necessary.
A piece shown by the shaded portion is to be cut from a square plate 128 millimeters on a side. a. Compute the area of the piece to be cut. Round the answer to the nearest square millimeter. b. After cutting the piece, determine the percentage of the plate that will be wasted.
Analyze each of the following problems to determine whether the problem is a direct or inverse proportion and solve. Round the answers to 3 decimal places where necessary. a. A reamer tapers 0.0975 inch along a 3.2625-inch length. What is the amount of taper along a 2.1250-inch length? b. A machine produces 2550 parts in 8.5 hours. How many parts are produced by the machine in 10 hours? c. Of two gears that mesh, one gear with 12 teeth revolves at 420 rpm. What is the revolutions per minute of the other gear, which has 16 teeth?