For a dipole antenna of length 1 = 32/2, (a) Determine the directions of maximum radiation. (b) Obtain an expression for Smax (c) Sketch the dipole antenna and label the physical size for a communication link operating at 110 MHz.

Q: For the figure given, the output current i(t) at t<0 is equal to zero amperes. What is the output…

A:

Q: Determine i(t) 12V + χ 0 = 1 Μ 6Ω Μ 6Ω 6Ω 8 Η i(t)

A:

Q: system has a damping ratio of 0.5, a natural frequency of 100 rad/s, and a dc gain of 1. Find the…

A:

Q: Question 4 The operating principle of an electric motor is based on the permanent magnet, capable of…

A: option B: Magnetic flux is the number of magnetic field of lines crossing the surface normally. If…

Q: Set up the non-inverting amplifier circuit shown in the diagram using 741 Op-Amp. VING R₂ 10 ΚΩ ww…

A: Given data A non-inverting amplifier is given in the question. Input voltage, Vin=20 mV Resistance,…

Q: 2. What is load frequency control? Which involves?

A: Answer

Q: i (1) What is the equation for io(t) for t> 0 in the circuit below? 2 ΚΩ · 4 ΚΩ 2 ΚΩ 100 με 1 ΚΩ Ο…

A:

Q: Convert the following (Show work!) a) 37₁0 Binary -> →→ b) 1110₂-> Dec c) EA₁ --> Binary 16 d) 4158…

A: Converting any number into decimal number system . Sum of invidual digits with product of respective…

Q: Reduce the following circuit to its simplest form: L₁ LA voo 0.56 H L2 1.2 H R www voo voo 1.8 H L3=…

A:

Q: Use mesh analysis to determine the two mesh currents labeled in circuit shown.orm of bei

A: The mesh equation can be obtained by applying kirchhoff's voltage law to the meshes and then by…

Q: 19H.W. D Determine I, and I₂ for the network 1. 2 12 V 12V 3, 382 356.2 network 1

A: Given: Circuit diagram :

Q: A 3-phase semi converter feeds power to a resistive load of 10Ω .for a firing angle relay of 300,…

A: Given: In this question, the given details are, A 3-phase semi converter feeds power to a resistive…

Q: A 1-port device has an output resistance of -5 + j25 N. Using this part, design a 1-port oscillator…

A: Given: In this question, the given details are, A 1-port device has an output resistance of -5+j25.…

Q: For the circuit shown below, assume V₁ = 40sin500t V, V₂ = 60cos(250t + 7.125°) V. 22 Find…

A: The given problem is from superposition theorem of circuit .  The detailed solution is given in the…

Q: Calculate V₂ Be sure to include units and 2 decimal places. (Assume the circuit is STIFF) www…

A:

Q: 13. Find 'z' in the following PID controller, Ge[s], to locate the closed-loop poles at SA = -2±j2…

A:

Q: 5. Find vo in the circuit below. V10- R2 R₁ R₁ ww V₂2 R₂ Vo

A: Given diagram,   V0 = ?

Q: A 100MVA, 33KV generator has positive, negative and zero sequence reactance of 0.25p.u.,0.45p.u. and…

A:

Q: A coil has an ac voltage of 120 V. The current through the coil is 10 -85 A What is the inductive…

A: Given data: Coil has AC voltage = 120V Current through the coil is : I=10∠-850

Q: 1. For each signal below, determine the largest sampling interval T, such that aliasing does not…

A: Signal A signal is the fundamental quantity used in electrical engineering to represent some…

Q: 2. Find the impedance in Fig- ure 17-66, and express it in polar form. Figure 17-66 S 420° V R www…

A:

Q: 19. For the given system, find the value of K₁ in the full-state feedback gain matrix that will…

A:

Q: Q1. Find current I₁, I₂, I3, and Iy (using 24 V 352 I Basic Laws and Circuit Reduction) 1₂ 8 Ω 252…

A: In this question We need to determine the currents in the given circuit.  We are solving this…

Q: Question 6 A wire of diameter 2 mm and conductivity 5 x 107 S/m has 1029 free electrons per cubic…

A: Given data, Diameter d = 2 mm. Conductivity σ=5×107 S/m. Number of free electron n=1029 per cubic…

Q: Diode current and temperature. At normal operating conditions, the current-voltage relation for a…

A:

Q: Explain the importance of residual voltage in a dc generator. Note: Figures and sketches are…

A: Given: Explain the importance of residual voltage in the DC generator.

Q: 9. The circular loop conductor shown in Fig. lies in the z =0 plane, has a radius of 0.10 m and a…

A:

Q: A center-fed Hertzian dipole is excited by a current Io = 20 A. If the dipole is λ/50 in length,…

A: Given: In this question, the given details are, A center-fed Hertzian dipole is excited by a current…

Q: Three with 1200/120 V, 7.2 kVA single-phase transformers with a leakage reactance of 10 ohms each…

A:

Q: A continuous-space signal se is given by Sc(x1, x2) = 100+20cos67x₁ + 40sin (107x1 + 67x2) for -00 ≤…

A:

Q: 3-phase, two-pole, Y-connected, 60 Hz, 10MVA, 13.8kV synchronous generator has a synchronous…

A: The synchronous generator can be solved as following.

Q: Given the below discrete points, calculate a Discrete Fourier Transform (DFT). Show all work. fk =…

A: Fourier transform is used to analyze the frequency response (Amplitude and Phase spectrum of a…

Q: A 75-hp, 460-V, 4-pole, 60-Hz, Y-connected induction motor develops its full-load induced torque at…

A: Given information about a three-phase, Y-connected induction motor is written below. Full load slip…

Q: A single phase full converter bridge is connected to RLE load. The source voltage is 230V, 50Hz. the…

A:

Q: ! Required information Consider the following values. Find the complex power, the average power, and…

A:

Q: Consider the circuit below with L = 1 µH, C = 10 nF and R = 10 22: R Vi 4 L - Vo C a) Find the…

A:

Q: Give some background on the causes of the delays in underwater cable upkeep.

A: Concept- Underwater cable- These cables are laid on the seabed and they provide the primary means of…

Q: Questions: - 1. For the circuit of Figure (1), the voltage gain from base to collector is…

A: Amplifier An amplifier is a type of electronic device that boosts the voltage, current, or power of…

Q: c) A fault occurs in the above system, such that Zab becomes an open circuit (infinite impedance).…

A:

Q: 14. Find the gain, K, in a PI controller, Ge[s], to locate a closed-loop pole at SA = -4 ± 10 for…

A:

Q: A 6600/440 V single-phase 600 kVA transformer has 1200 primary turns. Find the secondary turns.

A:

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A: Since you have posted multiple questions, we provide the solution for the first question only as per…

Q: and question 2?

A: Given: To do: we have to draw the above mentioned pulse.   Note: It is a rectangular pulse of width…

Q: Assume the following block diagram for the exam questions dealing with output feedback control…

A:

Q: Problem 6. A feedback loop has the three stages shown. Find the operating point and the open-loop…

A: From the given loop: y=2-x z=y√3 x=z2 From the above equations: (z/√3)= 2-z2 Solving this quadratic…

Q: [2] Delay the signal by say 32 samples and reduce its amplitude by factor of say α = 0.7, call this…

A: Given: To do: we have to generate this delayed pulse.

Q: Q.No. Question Q1. a) Describe with diagram any one biasing technique for BJT, giving its merits and…

A: Given:

Q: Q2. a). Find the voltage, Vs in the electric network shown in figure B, 4mA Vs R₁ = 3 kf2 V₁ Is ET…

A: Given data, Circuit diagram is given as,

Q: Typically a transistor is used as (More than one answer may apply.) 1. An amplifier 2. A power…

A: As we know that transistor is a semiconductor device. They are mainly  of two types- BJT and FET

Q: Find Io in the network using nodal analysis. owd out oninensjob of ieviens das sell 1 kn ww V₂ +…

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.