Answered: For the given power transfer, a star…

For the given power transfer, a star system is associated with larger line currents and a delta system is associated with a larger line voltage. Select one: O True O False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.15MCQ

See similar textbooks

Related questions

Q: A single phase overhead transmission line delivers 1100 kW at 30 kV at 0.8 p.f. lagging. The total…

Q: The primary constants of a uniform line 67.19 meters long, have the following values at 171.31 MHz:…

Q: Q- A transmission line has characteristic impedance is 50 and length I = A/8. If load Z₁ = (R+j30),…

Q: A short transmission line has sending end voltage (13815+250j) and the receiving end voltage 13kV.…

A: Given: Receiving end Voltage= 13000+0j V Sending End Voltage=13815+250j

Q: If a transmission line has Zc =200 0 and the line voltage3D400 kV, then its SIL in MW is: Answer:

Q: A medium length transmission line has the line impedance of 5.2 +j 32.6 N. Shunt admittance is -4…

A: If the impedance of the transmission line Z And admittance given , find the D parameter of the…

Q: The bus admittance matrix of a power system is given as 1 1[-j 50 + j 10 2 +j 10 - j 30 +j 10 3 +j5…

Q: Identify the company or private distributor of electricity involved in primary power distribution in…

A: The company that provides power distribution in the PHILIPPINES is Manila Electric Company is…

Q: A 3 phase, 60 hz, 138 kv transmission line is 250 miles long and delivers power to a 50 mw load at…

A: Given:r=0.175ohm/mile=43.75ohmL=0.302mH/mileXL=jWL=j28.46ohmC=0.0245μf/mileY=j2.30×10-3cosϕ=0.92lagP…

Q: If a transmission line of a characteristics impedance 50 Q is terminated with a load impedance of…

Q: j0.2 2 j0.1 3 j0.5 j0.2 j0.4 In the above network, the marked parameters are per unit impedances.…

A: Given network:

Q: The shunt admittance and series impedance of a long transmission line are given with respect to…

A: A Long transmission line's Characteristic Impedance is given by root of ratio of series impedance…

Q: Q3: In the transmission line shown, the impedance Zin (in ohms) between node A and the ground is Z,…

A: Given, Line is of length l=0.5λZin1=Z0=ZL+jZ0tanβlZ0+jZltanβlfor λ2 line βl=2πλ×λ2=π

Q: A three-phase, 50 Hz power transmission line is 220 km long. It has a total series impedance of…

Q: Three phase transmission line requires the larger cross section area than single phase transmission…

Q: The line impedance and half line charging admittance between buses 1 an 2 is 0.05+j0.15 and j0.02…

A: According to question:…

Q: 4. A 300 m transmission line has following constants for total length: 4.5kn, 0.15mH, 60mS, 12 nF.…

A: Given length of the transmission line is l=300 m Calculate all parameters per meter R=4.5 kΩR=15…

Q: The total series impedance of a 350 km long transmission line is 14 + j105 ohms. The total shunt…

Q: If the shunt admittance is equally divided into two part in an equivalent circuit of transmission…

Q: A 132 kV, 60 Hz transmission line has the following generalized constants: A=0.9696 20.49° B=52.88…

Q: If a transmission line of characteristic impedance 50 N is terminated with a load impedance of 150…

A: Given information: The characteristic impedance of the transmission line is Z0=50 Ω The load…

Q: For the given 3-phase power transfer, a star system is associated with a greater insulation.…

A: The insulation for 3 phase does not depend connection.

Q: If the maximum and minimum voltages on a transmission line are 4 V and 2 V, respectively, for a…

A: Given, Maximum voltage on a transmission line is Vmax = 4 volts Minimum voltage on a transmission…

Q: 10.25: For the following electric circuit, find Z and Y parameters? Also, compute input and…

A: Here we discuss about Z & Y parameters.

Q: Calculate the equivalent impedance of the circuit shown

Q: A medium transmission line has a total series impedance of Z = (4 + j12) Ω and a shunt admittance…

Q: A single-phase overhead transmission line delivers 200 kW at 20 kV at 0.8 p.f. lagging. The total…

A: In the question, A single phase overhead Transmission line have resistance R= 20ohm Inductive…

Q: Q- A transmission line has characteristic impedance is 50 and length 1 = A/8. If load Z₁ = (R +…

A: Given- Impedance=50ΩLength L=λ/8Load ZL=R+j30ΩTo Find-The value of R.

Q: T5. A typical line has the following parameters: A = D = 0.96Z1.0° and B = 100 If the line supplies…

A: In this question choose the correct option Find the Voltage regulation if Load = 30MW at the 0.8…

Q: Which of the following parameter/s is represented as connected in shunt in the equivalent circuit…

A: Any transmission line is represented by four components namely Resistance, inductance capacitance…

Q: If the length of a transmission line is 270 km, then it can be classified as O Short transmission…

A: Long Transmission Line If the line is larger than 240 km, the model must consider parameters…

Q: Q3] The characteristic impedance of a uniform transmission line is 2039.5 ohm at equency of 800 HZ.…

A: Please refer the attached images for the complete answer..

Q: 1)The sending-end current and receiving-end current in a given transmission line are not equal b.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Question 1 A medium transmission line has a total series impedance of Z= (4 + j12) N and a shunt…

A: we need to find out A,B,C,D parameters.

Q: A 132 kV, 50 Hz, 3-phase transmission line delivers a load of 50 MW at 0-8 p.f. lagging at the…

Q: A transmission line of 50 m long as shown in the figure below has Zo = 40 +j70 2, Vg = 20 20 Vms,…

A: According to the question we have to calculate, (i) sending end voltage and current (ii) propagation…

Q: A 300 m transmission line has following constants for total length: 4.5kn, 0.15mH, 60mS, 12 nF. The…

Q: The ABCD constants of a three-phase, 345-kV transmission line are:A = D = 0.98182 + j0.0012447.B =…

A: Since, the given ABCD parameters for the 345 kV transmission lines are:A = D = 0.98182 + j0.0012447B…

Q: In a medium transmission line, the line charging current value is higher than a short transmission…

A: Given In a medium transmission line ,the line charge current value is higher than a short…

Q: The power obtained at the receiving end of a transmission line is generally less than the sending…

A: The power obtained at the receiving end of a transmission line is generally less than the sending

Q: A 220 kV three-phase transmission line is 90 km long. The resistance is 0.1 92/km and the inductance…

A: Given- Three-phase transmission line, VR=220 kV,D=90 km,R=0.1 Ω/km,L=1 mH/km. To Find- (i) voltage…

Q: The A, B, C, D constant of a 220 kV line are: = D = 0.85<1°, B = 130<73°, C = 0.001<90°. If the…

Q: Shunt capacitors are installed at the receiving end to improve the line performance of a…

A: Determine the receiving total real power when the sending end voltage is 220 kV.

Q: A single phase overhead transmission line delivers 1100 kW at 40 kV at 0.8 p.f. lagging. The total…

A: Given data Receiving voltage VR=40 KVReceiving end power PR=1100 kWReceiving power factor =cos…

Q: [Q9] A transmission line of 50 N characteristic impedance is terminated with a 2 resistance.…

Q: A 470 kV, three phase transmission line with a 350 km length. The series impedance Z = (0.078+j0.34)…

A: 470kV , 3 phase transmission line Series and admittance parameters are given. Find. The T and π…

Q: Calculate the power exponent where the received power at the first 100 m is 0 dBm and the received…

Q: 5. The propagation constant of a transmission line with impedance and admittance of 9 and 16…

Concept explainers

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.

Question

For the given power transfer, a star system is associated with larger line currents and a
delta system is associated with a larger line voltage.
Select one:
O True
O False
Jump to...

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit. Select one: True False
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance
In the medium-length power transmission line model given below, since the end-of-line voltage value of the nominal-T equivalent circuit is 154 kv, find the voltage regulation value for this line and draw the phasor diagram.
Compute the equivalent impedance looking back at terminals ? and ? ((???).
10/Explain in your own words and your own understanding (avoid plagiarism) why there's Capacitance in between Transmission Lines and in between Distribution Lines.
Derive the power angle equation for a power system network and draw the corresponding curve.
transmission line with an impedance of 35 Ω is connected to a load of impedance of 300 Ω, then the value of VSWR assuming that the line impedance is decreased by 30 % and load impedance is increased by 40%.
In which Transmission Line classification is Capacitance negligible in its Equivalent Circuit? A. Medium Transmission Line Only B. Short Transmission Line Only C. Long Transmission Line Only D. Both Medium and Long Transmission Line
Given a telephone transmission line of 100 mile long has Z,=685-j92Q, 0a=0.00497 neper/mile and f=0.0352 rad/mile work at 1000Hz. If Z=2000Q and Eg=10Vrms with Z:=700Q, find the sending end impedance, voltage, current, and power.
Q..transmission line,,
What root locus based compensator would be used to imporve the steady state error of a given plant?
With the system shown in figures, use 100MVA as system base, and 230 kV as base voltage along the transmission line. 1. Build the Y-bus matrix without the Load. What is the element Y12 in susceptance value? 2. If you are to convert the real power load to a shunt conductance, what is the value of the conductance in per unit?