Start your trial now! First week only $4.99!*arrow_forward*

Question

for this problem voltage gain is 120

I think V(out)= gain x V(in) is this correct formula?

I got VH is 37.5 x 10^-3V from previous problem.

is VH same as V(in) ??

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: The current at the terminals of the two capacitors shown is 240e −10tμA for t≥0. The initial values ...

A: Current, i = 240 e-10t µA. Capacitance, C1 = 2 µF. Capacitance, C2 = 8 µF. Initial voltage across C1...

Q: 1) For the circuit shown in Figure (1): Find the supply voltage (V) a) 750V b) 700V c) 730V d) 710V

A: Click to see the answer

Q: State whether the network inside the box is absorbing or supplyingmagnetizing vars.

A: Here, entering terminal of the given network is positive and current direction towards the network s...

Q: The op amp in the circuit shown is ideal. What op amp circuit configuration is this?

A: The Op Amp can be classified based on the input given to the terminal as: Inverting Op amp Non-inve...

Q: The operational amplifier in the circuit is ideal. 1. a) Find the numerical expression for the tran...

A: Click to see the answer

Q: 1 0 0 1 Cin Cout Cin Cout Cin Cout Cin Cout Cout Cin S4 S3 S2 S1 so 110110 O 011011 O 010010

A: Click to see the answer

Q: * For the figure shown, the closed-loop voltage gain (Av) is

A: Click to see the answer

Q: Please do D, E, and F

A: Click to see the answer

Q: Draw structural formulas for the three tertiary (3°) amines with the molecular formula C5H13N.

A: The three tertiary amines are as follows:

Q: An electric load consists of 10 Ωresistance, 20 Ω capacitive reactance, and 60 Ω inductive reactance...

A: Given data: The value of resistance is: 10 Ω The value of capacitive reactance is: 20 Ω The value of...

Q: The voltage and current were measured at the terminals of thedevice shown in (a). The results are ta...

A: 1) Calculating resistance At it = 0 A, vt = 50 V Open source voltage

Q: Determine the ms value of the current waveform in Fig. 11.14. If the current is passed through a 2-2...

A: Given current waveform is -

Q: solve these this circuit problems knowing that Vrms = .707* Vp and that Vp-p = 2* Vp.

A: As this is a resistive circuit calculation is done by RMS value of voltage source only,

Q: For the pole-zero plot shown in figure Q2, answer the following a- Find the time response (y(t)) for...

A: Click to see the answer

Q: Find a state space model for the following electrical network. Let the output of the system be y(1)....

A: The current in the capacitor, C1 is determined by using Ohm’s law as given below,

Q: In signal analysis, any continuous signal can be represented as the sum of *.product of an impulse f...

A: Click to see the answer

Q: Can you solve this with steps?

A: (a) H(s) can be computed as,

Q: (a) Plot the load line and ﬁnd the Q-point for the diode circuit as shown in P3.53 if V = 10 V and R...

A: Part (a): The current flowing through the diode is determined as:

Q: When Ikf alfa(t)| <« 1, the equation of WBFM can be approximated to NBFM by neglecting the terms wit...

A: Click to see the answer

Q: (2) Ja If open-loop differential voltage gain (Aol) = 3500 and the common-mode * gain (Acm) = 0.35, ...

A: Click to see the answer

Q: Answer all the parts of the question

A: Part (a): The following table represents the truth table for the multiplexer.

Q: Power Losses Are Less for High-Voltage Transmission What percentage of the power is lost in the tran...

A: The losses largely depend upon that the types of operations of the transmission line. The losses whi...

Q: One 12 V battery supplies 100 mA to a boom box. How muchenergy does the battery supply in 4 h?

A: Given data, The value of voltage is v = 12 V. The value of current is I = 100 mA. The value of time...

Q: Find the approximate location of fZ for the op amp as shown using the values from the previous exerc...

A: Expression of transconductance gm=2(Kn)(ID) Calculating frequency of zero fZ=12πgmCCfZ=12π2KnIDCCfZ=...

Q: For the parallel adder in Figure below, determine the complete sum result * 1 1 0 0 1 1 1 0 0 1 Cin ...

A: Click to see the answer

Q: 3) For the circuit shown in Figure (3), if the total resistance equals 1002. Calculate the value of ...

A: Circuit diagram is given,

Q: Solve for the node voltage shown in Figure P5.55.

A: Click to see the answer

Q: The eight bit gray code equivalent to the number 12 is * O 00001000 O 00001111 O 00001010 O 11111100

A: The 8 bit binary form of 12 can be written as:

Q: What is the minimum bandwidth of the MOS current mirror as shown if IS = 250 μA, Kn = 25 μA/V2, λ =...

A: Given: To determine the minimum bandwidth of the MOS current mirror as shown if IS = 250 μA, Kn = 25...

Q: Q5: A closed loop system is shown in Figure Q5: K U(s)- Y(s) s(s+2) 1+ as Figure Q5 1- Determine the...

A: Click to see the answer

Q: Solve all parts.

A: Since we only answer up to 3 subparts, we will answer first 3. Please resubmit the question and spec...

Q: 02: Three main types of permanent magnet materials have been used in industry. Discuss their Ferrite...

A: Click to see the answer

Q: Draw the circuit diagram of a first-order RC lowpass filter and give the expression for the half-pow...

A: A first order RC lowpass filter consists from source, resistance and capacitance, Half power freque...

Q: If F1(a,b,c,d)=m(1,2,3,6), F2(a,b,c,d)=Em(0,1,6,7), then the function Y(a,b,c,d)=F1.F2 is given by *...

A: In case of AND gate when both the inputs are one then the output will be one. So, Output will be:

Q: B) For the circuit shown in Fig.3, find the value of R using nodal analysis.

A: Modified circuit would be: Voltage across right most resistor is : Both 2 ohm resistor are in para...

Q: The current in a 50μH inductor is known to be iL=18te−10tAfor t≥0.Find the voltage across the induct...

A: Assuming passive sign convention the equivalent circuit of the inductor is given as,

Q: Electrical Engineering Question

A: Pulse Position Modulation (PPM) is an analog modulating scheme in which the amplitude and width of t...

Q: The following sets of values for v and i pertain to the circuit shown. For each set of ...

A: Given: v=100cos(ωt+50°) V i=10cos(ωt+15°) A 1. calculate active power, P=12IVcosϕP=12×10×100×cos50-1...

Q: Negative feedback occurs when a portion of the output voltage is * connected back to the noninvertin...

A: Negative feedback occurs when a portion of the output voltage is connected to the inverting terminal...

Q: Consider the circuit shown in Figure T4.3.a. Write the differential equation for i(t). b. Find the t...

A: Click to see the answer

Q: ?How many 1*2 Decoders are required to design 4*16 Decoder 10 5 15 O

A: Click to see the answer

Q: C) An armature has resistance of 0.22 at 15 °C and the armature Cu loss is to be limited to 600 watt...

A: Given: To find: Maximum value of current with given temperature rise.

Q: A transformer is needed that will cause an actual load resistance of 25 Ω to appear as 100 Ω to an a...

A: The circuit diagram is shown below: Transfer RL on primary side;

Q: The practical op-amp has infinite input impedance, zero output impedance, infinite open-loop voltage...

A: 1.The ideal Op-amp has infinite input impedance while practical Op-amp input impedance is in the ord...

Q: While measuring the resistance of a wire with an ohmmeter:technician A says that of low resistance i...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Consider a second-order unity feedback system with = 0.6 and a, = 5 rad/sec. Calculate the peak time...

A: Given data: The expression for the peak time is given as,

Q: The circuit as shown is a shunt-shunt feedback amplifier. Use feedback analysis to find the midband ...

A: The equivalent circuit diagram for the given shunt-shunt feedback amplifier is shown in the followin...

Q: Find the average power delivered to the 5 kΩ resistor in the circuit

A: find current in the primary side: i1rms=145∠0∘200i1rms=0.725 A find current on the secondary side, i...

Q: Find the current I in 50V voltage source, for the circuit in Fig.5 using Norton’s Theorem.

A: Click to see the answer

Q: Q3: An overhead transmission line conductor at river having two un same level towers, the height of ...

A: Click to see the answer