Fractional distillation is commonly used in the oil industry to? A. Separate the different types of gasoline based on reactivity B. Separate the different types of gasoline based on water solubility C. Separate the different types of gasoline based on pH D. Separate the different types of gasoline based on boiling point

Q: A solution is prepared by dissolving 10 g HNO3 (strong acid) in pure water to make a total of 1 L.…

A:

Q: Q5. Calculate the molar mass of the acid when 0.625 g sample of H₂X acid is completely neutralized…

A:

Q: 9- A buffer system is set up with 3[HA]-[A] If pK a=5.5, what is the pH of the buffer? a. 5.2 b. 3.5…

A:

Q: 3. Look through Table 1.8. Although you should NOT memorize the information in the table at this…

A: According to Bronsted Lowry concept- Acids are those substances which donates hydrogen ion [H+] into…

Q: 2NOCI(g) = 2NO(g) + Cl₂(g) K = 1.6 x 10-5 @ 35°C K= [NO]²[C1₂] = [NOCI]2 Calculate the equilibrium…

A: Recall the given reaction,                            2 NOCl g  ↔  2 NO g  +  Cl2 gK = 1.6 × 10-5…

Q: What is the purpose of adding saturated NaCl during extraction of caffeine A. To remove the organic…

A:

Q: The calcium (AW= 40.08 g/mol) from a sample of limestone weighing 607.4 mg was precipitated as…

A: From the question, The mass of the limestone sample is given =  607.4 mg The given limestone sample…

Q: H-C=C-H nted In how many sigma bonds does the highlighted atom participate? In how many pi bonds…

A:

Q: The carbon skeleton for 2-methylpropane is shown below. How many hydrogens are present? c-c-c 1) 10…

A: First we draw the structure of 2-methylpropane------ So, in this structure three methyl groups and…

Q: Methanol CH3OH is a potential source of fuel. An experiment was conducted to determine the enthalpy…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An oxidizing agent, X+, reacts with a reducing agent, Z, to give X and Z3+. What is the equilibrium…

A: The detailed solution to the above question is given below step

Q: Calculate the radius of a copper atom. Copper has a face centered cubic (FCC) crystal structure…

A:

Q: a dilution is needed to prepare a standard of 10 mg Zn/L from 0.5g Zn/L. To carry out the dilution…

A: a) Concentration of stock solution, C1 = 0.5 g Zn/l Concentration of standard solution, C2 = 10 mg…

Q: 8-. What is the pH of 0.060 M NH4Cl? (NH3 Kb=3.98 x10-10) b) 5.12 a) 5.06 c) 5.18 d) 5.24 e) 5.35…

A:

Q: CO(g) + H₂O(g) = H₂(g) + CO₂(g) K= 7.3 @ 823 K A closed 5.0 L container initially holds 3.0 moles CO…

A: It is based on the concept of equilibrium  Here we are required to find the equilibrium…

Q: Draw the products formed when hex-1-yne is treated with each reagent. a. HCI (2 equiv) b. HBr (2…

A: The detailed solution to the above questions has given below step

Q: Please help me name this organic compound. C4H7CON(CH3)2 and C3H5NH(CH2CH3)

A: This question belong to Nomenclature of organic compounds. First we will find Degree of Unsaturation…

Q: Answer the questions in the table below about the shape of the sulfur tetrafluoride (SF4) molecule.…

A: VSEPR theory: The structure of a molecule can be determined by using the VSEPR theory. According to…

Q: 27. These are three forms of the pH indicator dye phenolphthalein. One of them is responsible for…

A: Given structures

Q: In a balanced equation, how many atoms of mercury are there on each side of the reaction? Balance…

A: Steps for balance of an equation :  A. At first we need to balance the main atom.  B. Then we need…

Q: 12. The following reaction was performed in the lab: 8.0 g of solid baking soda (NaHCO3) was placed…

A:

Q: Consider the two ceramic atomic packing arrangements shown in the Figure. The radius of the anion is…

A: The correct answer and explaination is given in below steps

Q: A sample of hydrogen gas occupies a volume of 6.47 L at  4.58 atm and 9.96 °C. How many moles of the…

A: Given :  Volume = 6.47L Pressure = 4.58 atm Temperature = 9.96°C Universal gas constant = 0.08206…

Q: Calculate the heat of reaction AH for the following reaction: 2 NH3(g) N₂(g) + 3 H₂(g) You can find…

A:

Q: What can be used to determine the purity of aspirin product? A. TLC B. Melting point determination…

A:

Q: Predict the IUPAC name for the following structure using Chemdraw software a.…

A: The IUPAC Nomenclature of the given structure by using chemdraw is given below:

Q: Consider a chromatography experiment in which a mixture of two components, Y (k' = 1.4) and Z (k' =…

A: The selectivity factor of column (α) with two component A and B is given as (if A is eluted first…

Q: N₂ has molecular orbitals rather similar to those of CO, as shown in Figure 13.12. Would you expect…

A: In general, both N2 and CO have triple bonds. The molecular orbitals of N2 is given as follows: N2:…

Q: The following reaction occurs readily at 425 °C: 2 NO(g) + Cl2(g) 2NOCI(g) The equilibrium constant,…

A:

Q: Imagine that we have a closed system containing pure isobutane that is in a state of vapor-liquid…

A: The correct answer and explaination is given below steps

Q: Predict the IUPAC name for the following structure using Chemdraw software a.…

A: Since you have asked multiple type questions, we will solve only first  questions for you. If you…

Q: Heptane has several isomers. Which of the following condensed formulas is NOT an isomer of heptane?…

A:

Q: 44,000 - 56,000 56,000 -68,000 68,000 -80,000 0.28 0.18 Clear musheiss 0.10 0.29 0.03 0.23…

A: Given Table of  MW range

Q: H- Falcarinol a natural

A:

Q: No Plagiarism Please 10. Use the pHet simulation found on page 2 in lesson 4 of unit 2 to create a…

A: There could be two stable isotopes of Carbon C12 and C13: (i) C12 Number of protons = 6 Number of…

Q: If the value of ml for an electron atom is -4, what is the smallest value of l that the electron…

A: Since, For representation of electron in an orbital we use four type of quantum number-- 1)Principle…

Q: Two methods were used to measure fluorescence lifetime of a dye. The average result for Method 1 is…

A: To check if there is a difference between the two methods, test whether Fcalculated>Ftabulated.…

Q: The bond between which of the following pairs of atoms would be the least polar (lowest percent…

A: The lowest percent ionic character can be calculated as  % Ionic character = 16 (XA -XB) +3.5(XA…

Q: Zn Zn2+(1.0M) Cu2+ (1.00M) Cu Ecell meausremet 1.029 Ecell, reaction quotient, Eºcell

A: Given cell Zn/ Zn2+// Cu2+/Cu, Ecell = 1.029 V Here cathode is Cu2+/Cu electrode (right electrode)…

Q: Total number of stereoisomers possible for the following compounds is OH a. 3 b. 16 C. 8 d. 6 e. 4…

A: Chiral center : An atom in a molecule is said te be chiral center if it has four different atoms or…

Q: Which of the following are incorrect regarding the crystallinity and mechanical behavior of…

A: The correct answer and explaination is given in below steps

Q: 23. Which structure(s) is/are most likely possible for this compound with the following information?…

A: 23. Given, the unknown compound has a strong IR peak at 1700 cm-1 and m/z = 72.

Q: What is the major and minor product? D2 Pt

A:

Q: A metal has a radius of 0.153 nm, and a planar density of 7.5516551453132 nm-2 in the (110) plane.…

A:

Q: 7 Fe|Fe²+ (1.0 M)|| Cu²+(1.0 M)|Cu Fe|Fe²+ (1.0 M)|| Cu²+ (0.10 M)| Cu 8

A:

Q: is the reaction that involves the addition of H₂ in the presence of a metal catalyst. Hydrogenation…

A:

Q: 2.0 M Br2, 2.0 M Cl2 and 3.0 M BrCl are added to a sealed container at 300 K and react according to…

A: Given : 2.0 M Br2 2.0 M Cl2 3.0 M BrCl    And the balanced chemical equation  Br2(g) + Cl2(g)…

Q: Draw the following structure using Chemdraw software and predict the % C from the Elemental…

A: Chemical formula of the given molecule is C15H6Cl2F6N2O2

Q: What is/are the product(s) of the following acid-base mechanism? A, B, C, D, or E?

A:

Q: 2.- Describe the reaction mechanism for the following reaction. Key reaction steps: mixed anhydride,…

A: In presence of Base , acid- base reaction is carried out that attacks acetic anhydride in…

Alkanes and Cycloalkanes

Alkanes are saturated organic compounds which are made up of C and H atoms. Alkanes have the general formula of CnH2n+2. Alkane contains sp3 hybridized carbon atoms with four sigmas (σ) bonds & every hydrogen atom is connected with one of the carbon atoms. The size of the alkane could be determined by the number of carbon atoms located in it.