Given the van der Waals constants for ethane gas as a = 5.562L2bar/mol2, b = 0.06380L/mol, for 10.0 mol of ethane at 300 K and under 30 bar i.Calculate the second virial coefficient B at this temperature. ii.What does this imply about the nature of the interactions between the molecules at this temperature? iii.Calculate the compression factor (Z) from the first two terms of the virial equation of state. iv. Estimate the molar volume from Z.

Q: The pressure of the gas inside an aerosol can is 1.2 bar at a temperature of 25 oC. Will the aerosol…

A: Given data: Initial pressure = 1.2 bar Initial temperature = 25°C Final temperature = 600°C

Q: Determine the absolute pressure in torr exerted on an object submerged 1000 m below the surface of…

A:

Q: Two moles of nitrogen gas, which can be regarded as ideal with C, 28.6 J Kmol- (independent of…

A: The ideal gas equation is: PV=nRT······(1) Here, P is the pressure, V is the volume, T is the…

Q: An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed…

A: Given initial condition are volume = V1 at absolute temperature = T1   Pressure increased from Pa…

Q: Silicon tetrachloride(SiCl4)and trichlorohydrosilicon(SiHCl3) are both starting material of…

A:

Q: the variation of AG with variation in (i) temperature and pressure (ii) pressure

A: In the question we have to discussion the variation ∆G with variation in temperature pressure and…

Q: 8. Estimate the critical constants of a gas with the van der Waals constants: a = 0.761 bar dm mol?…

A: Since you have asked multiple questions, so we will solve the first question for you. If you want…

Q: (c) Estimate the percentage difference between the van der Waals and perfect gas calculations for…

A:

Q: Develop all calculations in detail. An answer without justification will not be considered.…

A: SOLUTION for a  As the expansion had proceeded to completion and it is not infinitesimally slow…

Q: An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed…

A:

Q: Use the Maxwell-Boltzmann distribution of speeds to estimate the fraction of CH4 molecules at 298.15…

A:

Q: 1. Given the van der Waals constants for ethane gas as a=5.562 L2 bar/mof, b 0.06380 L/mol, for 10.0…

A:

Q: (9) At 300 K, the second virial coefficient (B) for N2 is –4.2 cm3 • mol-1, while for CH4 it is – 15…

A: virial equation of state for 1 mol of any gas  is        PV=RT + BVRT Where V= v/n  Where P =…

Q: Estimate the critical constants of a gas with the van der Waals constants: a = 0.761 bar dm3 mol -2…

A: Critical volume of a gas is the volume occupied by a gas under critical pressure and temperature.…

Q: The mass density of water vapour at 327.6 atm and 776.4 K is 133.2 kg m−3. Given that for water a =…

A: a.

Q: which of the following gases should the correction for the molecular volume be largest HF, H2S, Br2,…

A: The following gases should the correction for the molecular volume be largest HF, H2S, Br2, Xe will…

Q: n general, the compressibility factor Z tends to be smaller than 1 at moderate pressures (around 150…

A: The constants a and b are called van der Waals constants. They have positive values and are…

Q: At high temperatures, one of the van der Waals constants

A:

Q: Compare the density values of O2 at 480 K and 280 bar using the ideal gas and the van der Waals…

A: To determine relative error.,

Q: Imagine that you have a 5.00 L gas tank and a 2.00 L gas tank. You need to fill one tank with oxygen…

A: Ideal gases are hypothetical gases which do have real existence. A gas can behave ideally at low…

Q: A 160 L kiln is used for vitrifying ceramics. It is currently operating at 1325 °C , and the…

A: The ideal gas equation is given by,                                            PV = nRT Where, P is…

Q: Is there a set of conditions (Vm,T) at which the compression factor Z of a van der Waals gas passes…

A: The compression factor = Z

Q: a) The second virial coefficient of ammonia at 298.15K is -261 cm³ mol Calculate the molar volume…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate the pressure exerted by 1.0 mol C2H6 behaving as a van der Waals gas when it is confined…

A:

Q: In general, the compressibility factor Z tends to be larger than 1 at very high pressures (greater…

A: The compressibility factor Z represents the deviation of the real gases from the ideal gases. It is…

Q: What is the partial pressure of oxygen in air at atmospheric pressure (101 kPa)? Assume ideal…

A: Given: Atmospheric pressure = 101 KPa.

Q: Express the van der Waals equation of state as a virial expansion in powers of 1/Vm and obtain…

A: Vander wall equation for real gases is given as,(P+aVm2)(Vm-b)=RT.........1st.Re arranging the above…

Q: The van der Waals equation of state for a real gas is n'a Р + V- nb]=nRT v2 In this equation, the…

A:

Q: Could 25 g of argon gas in a vessel of volume 1.5 dm3 exert a pressure of 2 bar at 30 oC it is…

A: (a) Given data: Mass of Argon = 25 g, Pressure = 2 bar = 1.973846 atm (1 bar = 0.986923 atm), Volume…

Q: than that calculated from the perfect gas law. Calculate (i) the compression factor under these…

A: The compressibility factor is defined as ,…

Q: Imagine that you have a 6.50 L gas tank and a 2.50 L gas tank. You need to fill one tank with oxygen…

A:

Q: An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed…

A: #1: Considering the Temperature (T1) is constant inside the closed headspace, the pressure(P1) due…

Q: True or false? At 298K, N2 molecules have a mean speed of 475 m/s. As a consequence, the…

A: Mean speed is the average speed of all the molecules with different velocities.  Some molecules may…

Q: (6) Calculate the molar volume of carbon dioxide at 400 K and 30 atm, given that the second virial…

A: Conclusion...molar volume of CO2 calculated with ideal gas law is 1.09 is greater than virial…

Q: Compression factor of a gas with van der waals constants of a= 2,272 dm6*bar*mol-2, b = 0,0432…

A:

Q: An experiment is conducted in which a quantity of H2(g) is chemically generated in a closed…

A:

Q: The ideal gas law also represents the behaviour of mixtures of gases at low pressures. The molar…

A:

Q: Find the molar mass of a gaseous compound that has density p = 5.3186 g L1 at T = 293.9 K and P =…

A: An ideal gas follows a theoretical concept in which there is no interparticle interaction between…

Q: (b) The critical constants of Pc, T. and Vme of ethane, C₂He, were given as 48.2 atm, 305.4 K and…

A: Molar mass of ethane is 30 g/mol. Given value of Pc ,Vc and Tc are respectively 48.2 atm, 148…

Q: Because of their different molar masses, H₂ and D₂ effuse at different rates . (a) If it takes 16.5…

A: (a) Given data contains, Moles of H2 is 0.10 mol. Time taken for effusion of H2 is 16.5 min. Moles…

Q: A sample of 2.544 g of a gas with molecular formula XF4 is introduced in a 2.345 L vessel at…

A: Given that : Mass of sample(m) = 2.544 g Volume(V) = 2.345 L Temperature(T) = 296.25 K Pressure(P) =…

Q: the compression factor of a van der waals gas at 100 degrees celsius and 100 atm given that a=1.345…

A:

Q: What pressure would 4.56 g of nitrogen gas in a vessel of volume 2.25 dm3 exert at 273 K if it…

A: Given that: Mass of nitrogen gas = 4.56g Molar mass of nitrogen gas =28g/mol Volume = 2.25 dm3 =…

Q: A gas behaves ideally has a density of 1.952 g dm‑3 at 122 kPa and 298K. What is the molar mass…

A:

Q: Given the van der Waals constants for ethane gas as a = 5.562 L 2 bar/mol2 , b = 0.06380 L/mol, for…

A: