Answered: Given: V= 5 volts and Ɵ = 30 deg.…

Engineering

Electrical Engineering

Given: V= 5 volts and Ɵ = 30 deg. Calculate Vm.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter21: Special-purpose Outlets—food Waste Disposer, Dishwasher

Section21.1: Food Waste Disposer Circuit

Problem 11R

See similar textbooks

Related questions

Q: A dimmer that is marked 1200 watts @ 120 volts is capable of safely carrying 50 amperes of current.…

A: Given:-Power Rating=1200W,Voltage=120V

Q: A homeowner is installing a swimming pool. You have been asked to install a circuit to operate a…

A: Need to find Can we use 20 A circuit to supply devices

Q: in short Explain any two protective devices in the substation

Q: 19. Which of the following conductors can you install when using the pressure terminals on a…

A: Answer 19. There is no necessary for a receptacle to have something plugged into it for it to cause…

Q: What is the number of basic nodes in the circuit given below?

A: In this question we need to find a number of basic nodes of the given circuit.

Q: Answer and write the solution. The substation bus bar is made up of 1.5 inches round copper bars 30…

Q: find the current

Q: Question 36 What size TW copper conductor should be used for the branch circuit? (Show all of your…

A: The term "ampacity" is a portmanteau for "ampere capacity," which is prescribed by national…

Q: Q1: Refer to the table below, find the connected load (note that; 18 lights are used and 8 sockets…

A: The connected load of the system is nothing but the sum of the individual load demand

Q: resistor

A: Note- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Show that the two systems shown in Figure (1) are equivalent. Depend on your study, what is this…

A: Given:

Q: Hello. Where is the solution? There is no solution attached in step 1? thank you

Q: 1. Why do two switches connect to the paddle fan? One for Light/One for Fan Slow/Fast Speeds 2. How…

A: The floor plan for the main floor of the home is seen in the figure as locating the service entrance…

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A: First we will find out total resistance then total current

Q: You are an electrician. You have been asked by a homeowner to install a lighted mirror in a…

Q: What color code designates a 12, 10% resistor? What color code designates a 1k Q, 5% resistor? What…

Q: Which of the following resistors, if connected across a 10 volt battery, dissipated the most power?"…

A: We will first calculate the current across the each resistor. The calculation is shown below: The…

Q: A dining area measuring 4x4m is planned for its lighting lay-out. The owner wishes to install…

Q: Questions A: 1. What happen if you only touch one test probe of the voltmeter to one end of a…

A: According to the question we have to discuss 1. What happens if you only touch one test probe of…

Q: RL 470A Vs 12 V

A: Since n-type is connected to diode's negative side and p-type is connected to positive side. And…

Q: Explain the following in one or two paragraph only. 1. Open circuit 2. Short Circuit

A: According to question, We have to explain the open circuit and short circuit.

Q: 3. It takes 293 Kilo-Joules of energy to bring a certain amount of cold water to boil. If the water…

Q: Show your solution and box the final Answer.

Q: Part 2- Problems Show formulas and substitution. 1. How much power is consumed by a 12-ohm toaster…

A: As per our policy, i have attempted 1 question Given V=120 voltsR=12 ohm Calculating power…

Q: 2. In power distribution systems, conductor from which tappings are taken for supply to the…

A: 2)In a distribution system when the distribution line of 66 or 33kv or 21kv comes to the…

Q: 31. A 50-ohm resistor is in parallel with a 100-ohm resistor. The current in 50 Q resistor is 7.2 A.…

A: voltage across the parallel resistor is same and current is sum of the individual resistors .…

Q: 7. A circuit contains a 1.5-volt battery and a bulb with a resistance of 3 ohms. Calculate the…

Q: 1. Determine the current flow in a circuit with a resistance of 5 Ohms on a 120 and 240 Volts…

A: 1.Given

Q: Five dry cells having emfs of 2.30, 2.40, 2.35, 2.60, 2.25 Volts and resistances of 0.40, 0.20,…

A: Given Data: E1 = 2.3 V E2 = 2.4 V E3 = 2.35 V E4 = 2.6 V E5 = 2.25 V R1 = 0.4 ohm R2 = 0.2 ohm R3 =…

Q: 5. If the resistor is doubled in the circuit on item number 4, what is the load current?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Explain any 2 types of Battery?

A: Steel and a combination of zinc/manganese/potassium/graphite make up the majority of an alkaline…

Q: You are an electrician. You have been asked by a homeowner to install a lighted mirror in a…

Q: 12. A copper wire of diameter 1 cm had a resistance of 0.15 Q. It was drawn under pressure so that…

A: Resistance: It is a material that resists the flow of current and its unit is the ohm.

Q: 23. A coil of copper wire has resistance of 90 Q at 20°C and is connected to a 230 V supply. By how…

Q: Determine vah in the circuit below.

Q: Explain from where ; 1) operation 2) circuit diagram 3) neat diagram 4) applicaiton note : pls…

A: Operation: The Generator is a device, which converts any kind of energy into electricity. The…

Q: If you placed a load of 700 ohms on a circuit with a Thevenin resistance of 492 ohms and a Thevenin…

A: Given data, Thevenin's resistance, Rth=492 Ω Thevenin's voltage, Vth=14 V Load resistance, RL=700 Ω…

Q: Determine the total current flow in a lamp having 220 volt current supply, a fan of 240 volt supply…

Q: Draw a circuit diagram. Draw two ways to connect the bulb, battery, and wire so that the bulb does…

Q: without pipes, draw a simple diagram of a circuit containing an exhaust fan with on lamp both load…

A: without pipes, to draw a simple diagram of a circuit containing an exhaust fan with on lamp both…

Q: What is the total current in this circuit? Using the circuit in the question state what fuse…

A: Power (P)= Voltage(V) ×current (I)By…

Q: 37. A windmill-powered generator and a battery work together to supply DC power to a light bulb.…

Q: Determine Reg 1ks Reap

Q: ] One way of avoiding electric hazards is performing quick checks to make sure that the electric…

A: Statement first : One way of avoiding electric hazards is performing quick checks to make sure that…

Q: Complete the diagram by placing the connections in the circuit and determining the voltage out put

Q: (c) Rank the readings on the voltmeters in each of these circuits, from highest to lowest. Explain…

A: This question is an Interesting one. Here it is asked to rank the readings of Voltmeter for the…

Q: 3- Assume you are a health safety environment engineer and you are working in an oil field. Explain…

A: Fire and explosion Because of the ignition of vapors or gases which is flammable people in the oil…

Q: Lamp Lamp Lamp Series Circuit 4.(4) Location Voltage ΑΙΑ2 Double-click to hide white space BIB2 Lamp…

A: On observing the circuit diagram, the lamps are connected series

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

In your solution, follow the sequence: Given, unknown, solution, and final answer. BOX your final answers. thank you!

4. Given: V= 5 volts and Ɵ = 30 deg. Calculate Vm.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In problem 35, it is desired to keep the voltage drop to 3% maximum. What minimum size wire would be installed to accomplish this 3% maximum voltage drop? See 210.19(A), Informational Note No. 4 and 215.2(A)(1), Informational Note No. 2.
Please help me solve question 5 below. Please provide a clear and readable solution. Thanks in advance!!! The course subject is Electrical Machines 2. NOTE: The answers are given below. Please provide the solution. If the answer given below is wrong, please give the correct answer. The unit of total load is 200 ohms. Thanks a lot!!!
Please answer it with clean and step by step solution. Thank you and keep safe.
Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C what is the answer? VD?
Provide an explanation and determine if the diagram is correct or not, if not kindly provide the correct diagram. Kindly answer it ASAP, thanks. (Diagram) Series circuit with three lamps.
Determine the mesh current of the circuit below. solve the following and box the final answer preferred written thank you.
3 Two fixed type resistors, 5 ohms and 7,5 ohms are connected in series. If a 12 volt battery is supplied to the series connection, solve for the amount of power dissipated by the 5 ohm resistor.
Hi Please help me solve the following problems.Kindly draw the circuit diagram of each problem. Thank you very much, keep safe!
In the circuit shown above, find the value of io given that X = 10 Ohms and V = 128 Volts. direct answer need only
3- Assume you are a health safety environment engineer and you are working in an oil field. Explain the details about mechanical and electrical hazards in oil and gas field. Support your answer with an example of each.
Resistors, 10 ohms and 15 ohms, are connected in series. The power being consumed by the 10-ohm resistor is 22.5 watts. Determine the following: the value of the voltage source energizing the circuit; the power being dissipated by the 15-ohm resistor if the two resistors were to be connected in parallel using the same source; NOTE Use the appropriate unit of measurement; observe the best applicable engineering notation and Greek prefix. Wrong unit of measurement will make the final answer wrong. Box your final answers. Express your answers accurate to four decimal places.
POWER ASSOCIATED CIRCUIT ( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).