Glycerin is being heated by flowing between two parallel 1-m-wide and 10-m-long plates with 12.5-mm spacing. The glycerin enters the parallel plates with a temperature of 25°C and a mass flow rate of 0.7 kg/s. The plates have a constant surface temperature of 40°C. Determine the outlet mean temperature of the glycerin and the total rate of heat transfer. Evaluate the properties for glycerin at 30°C. Is this a good assumption?

Q: Hot air at atmospheric pressure and 85°C enters a 10-m-long uninsulated square duct of cross section…

A: The properties of air at bulk mean temperature of 75 oC, The characteristic length of the duct is…

Q: Q) Water at 22'C flows in a 40-cm-diameter pipe and 25-m-long at an average velocity of 0.15 m/s.…

A:

Q: What is natural convection? How does it differ from forced convection? What force causes natural…

A: Heat transfer can take place in three different modes namely conduction, convection and radiation.…

Q: For laminar forced convection over a flat plate, if the free stream velocity increases by a factor…

A:

Q: What happens to the heat transfer coefficient in convection heat transfer if the viscosity of the…

A: Viscosity: The resistance to flow of any fluid is known as viscosity. The viscosity of any fluid is…

Q: Carbonmonoxide (CO2) gas flows at a speed of 2 m/s in a rectangular cross-section channel with a…

A: The chemicals name is (CO2) which is carbon dioxide. In the question the name is given as carbon…

Q: Liquid glycerin is flowing through a 25-mm-diameter and 10-m-long tube. The liquid glycerin enters…

A: Internal flow with constant surface temperature   We know that q = mCp ( Tmo - Tmi )      Newtons…

Q: Air at 30 oC flowing over a flat plate 0.5 m long and 0.6 m wide, is to be maintained at 70 oC .…

A: This question is solved with the help of the convection heat transfer coefficient equation. As shown…

Q: It has a density of 5900 kg/m3 and a specific heat of 590J/kg.°C with a diameter of 15 cm. A…

A:

Q: Consider a 25-mm-diameter and 15-m-long smooth tube that is used for heating fluids. The wall is…

A: Given data as per question Diameter = 25 mm Length = 15 m Mass flow rate = 0.01 kg/s.

Q: Combustion gases passing through a 3-cminternal- diameter circular tube are used to vaporize waste…

A: Assumption  steady state Given data Diameter of circular pipe D = 3 cm =0.03 m Inlet and Exit…

Q: What is the Reynolds number and flow regime at the beginning and at the end of the pipe? If the…

A: It is given that Diameter of pipe (d)= 50 cm = 0.50 m length of pipe (L)= 10 m mass flow rate m.=…

Q: The components of an electronic system are located in a 1.8-m-long horizontal duct whose cross…

A: Given:- k=0.02717W/m.k Ts=65Tf=30 To find:- Total power rating of the electronic devices that can be…

Q: The components of an electronic system are located in a 1.5-m-long horizontal duct whose cross…

A: given data Length of the pipe L = 1.5m Cross section area of the duct = 0.2*0.2 m2  Temperature of…

Q: Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220°C flow is…

A:

Q: How does velocity affect the types of fluid flow?

A: Velocity directly affect the types of fluid flow . Because on increasing velocity flow transformed…

Q: Consider a 10-m-long smooth rectangular tube, with a = 50 mm and b = 25 mm, that is maintained at a…

A: Nusselt number signifies the Convective resistance over the conductive resistance It is used to…

Q: Consider a 25-mm-diameter and 15-m-long smooth tube that is maintained at a constant surface…

A: Write the given information. Write the expression of the average temperature.

Q: A 20 mm * 20 mm silicon chip is mounted such that the edges are flush in a substrate. The substrate…

A: Write the properties of air at 25°C. Write the expression of the characteristic length of the…

Q: Determine the inside diameter of a tube that could be used in a high temperature, short  time…

A:

Q: Example 1: The components of an electronic system are located in a 1.5-m-long horizontal duct whose…

A:

Q: Q) Water at 12°C flows in a 2.5-cm-diameter pipe and 10-m-long at an average velocity of 0.1 m/s.…

A: Given: The temperature of water, T = 12°C The diameter of pipe, d = 40 cm = 0.025 m The length of…

Q: What is the physical significance of the Reynolds number? How is it defined for external flow over a…

A: Given: Plate with length L To find; Significance of Reynolds number Reynolds number for external…

Q: ir is to be heated by passing it over a bank of 4-m-long tubes inside which steam is condensing at…

A: Given:- l=4m Ts=100°C Ti=20°C V=5.2 m/s D=0.016m SL = ST = 0.03 m k = 0.02625 W/m·K  ρ = 1.145 kg/m3…

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air at this…

A:

Q: Consider a 10-m-long smooth rectangular tube, with a= 50 mm and b= 25 mm, that is maintained at a…

A:

Q: Consider the flow of oil at 20°C in a 30-cm-diameter pipeline at an average velocity of 2 m/s. A…

A: Understand that the exit temperature of oil is not given, hence the bulk mean temperature cannot be…

Q: Air at a pressure of 1 atm. abs. and 50°C flows parallel to the top surface of a rectangular plate,…

A:

Q: How is the Reynolds number related to Darcy-Weisbach?

A: Reynolds number is used to determine the nature of the fluid, Laminar or turbulent fluid.

Q: Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220oC flows in…

A:

Q: In a manufacturing plant that produces cosmetic products, glycerin is being heated by flowing…

A: Write the given information.  Write the properties of glycerin at 30°C.

Q: Air (1 atm) entered into a 5-mm-diameter circular tube at an average velocity of 5 m/s. The tube…

A: Given data, The length of the tube, L = 10 cm The diameter of the tube, d = 5 mm The velocity of…

Q: The components of an electronic system are located in a 1.8-m-long horizontal duct whose cross…

A: Given:- Ts=65 T∞=30 k=0.02717W/m.k v=1.744*10-5m2/s Pr=0.72345 V=200m/min D=20cm To Find:- The total…

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air at this…

A: The elevation of Denver, H = 1610 m The pressure in Denver, P = 83.4 kPa The atmospheric temperature…

Q: Consider a 10-m-long smooth rectangular tube, with a = 50 mm and b = 25 mm, that is maintained at a…

A: Write the given information. Write the expression of the mean temperature. Write the properties of…

Q: What does the Grashof number represent? How does the Grashof number differ from the Reynolds number?

A: Grashof number is a dimension less number. Which we use in heat transfer and fluid mechanics.

Q: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air at this…

A: (a) The average temperature is written as, The properties of air at this temperature are given as,…

Q: Liquid sodium is to be heated from 500 K to 600 K by passing it at a flow rate of 5.0 kg/s through a…

A: Given Data Inlet temperature is :T1=500 K Outlet temperature is : T2=600 K Mass flow rate is :…

Q: Q) Water at 22°C flows in a 40-cm-diameter pipe and 25-m-long at an average velocity of 0.15 m/s.…

A:

Q: What fluid property is responsible for the development of the velocity boundary layer? For what…

A: The viscosity is the property which is responsible for the development of the velocity boundary…

Q: Consider turbulent forced convection in a circular tube. Will the heat flux be higher near the inlet…

A: When a fluid is forced through a plane surface or a tube by means of external force such as fan is…

Q: Air is heated in a 4cm×4cm sheet metal duct with a uniform surface heat flux of 590 W/m2. The mean…

A:

Q: Liquid water flows at a mass flow rate of 0.7 kg/s through a concentric annulus tube with the inlet…

A: Average tempearture of water,Tavg=Te+Ti2where,Te=Exit mean tempearture=80οCTi=Inlet mean…

Q: Determine the pressure drop across the tube bank

A: