Hello Sir. Good Evening. I have a question in my home work related Control System Lesson. The following below is my question. Please advise, Thank you so much. "Give a control mechanical system and show how to get a transfer function of the system"

Hello Sir. Good Evening. I have a question in my home work related Control System Lesson. The following below is my question. Please advise, Thank you so much. "Give a control mechanical system and show how to get a transfer function of the system"

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter1: General Principles Of Electric Motor Control

Section: Chapter Questions

Problem 12SQ

See similar textbooks

Related questions

Q: Exampic Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from…

A: We need to find out the number of bits per sample for given pcm signal . First we will find out step…

Q: For an n-channel JFET, VGs(om=-8V and Ipss=7 mA. Determine the value of VGs required to set up ID of…

A: Use drain current equation of jet to determine value of VGS.

Q: Prior to the formation of the depletion region, electrons were injected to the P type silicon from…

Q: A 500, V, 10-pole d.c. shunt generator runs at 750 rpm, supplyung a load at rated voltage. The…

Q: B) An FM signal e(t)FM = 20 сos (2л10't + 6 sin 2л10³t) exist over 500 resistive load, determine: 1.…

Q: In Boolean Logic, there are only two answers: True and False True False

A: Asking about Boolean logic output

Q: The voltage Vo in the circuit shown equals 10Α 20Ω ΣΤ 0 5A 200 ЗА

A: Given data, Circuit diagram is given as,

Q: 9. Design the simplest circuit that implements the function Σm (0,1,2,4,5,6) using NAND gates. f(x₁,…

Q: 3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is…

A: Transient analysis:

Q: In Boolean Logic, there are only two answers: True and False True False

A: In Boolean logic outputs

Q: Your turn: Determine V3 employing voltage division 6 Volt + 5 102 202 + V3 +51 402 202 www + Sª V₂

A: We need to find out the voltage for given circuit by using of voltage division rule

Q: operates at co = 50 rad/s. Zin 2 mF 3 Ω 0.2 Η m 10 mF 8 Ω

A: Here basic properties are used to solve it.

Q: e) The phaser form of v=123cos(50t-30)= 123/-30

Q: A system is used to transmit base3 PCM signal of 256 level steps, the input signal works in the…

A: Given number of levels L = 256 frequency of input signal ranges ⇒ ( 50 to 90 kHz) Formula to be used…

Q: If the current i flowing in the straight conducting wire as shown in the figure decreases, find out…

A: Solution !! Solution From right hand rule, the magnetic field by the straight wire is directed into…

Q: A 50-ohm lossless transmission line has series inductance of 250 nH/m and shunt capacitance of 100…

Q: A resistance of the coil is 500 and the number of turns 200 turns, connecting in a row with a…

Q: 1. Determine the spectral components of the FM signal below. VFM 100 [sin (204.6mx106) t+…

A: According to the question, we need to analyze the equation of the FM signal.

Q: What would be the barrier potential of a silicon diode when the junction temperature is at 50°C?…

Q: Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from -3.8V…

A: We need to find out the number of bits per sample for given signal to noise ratio and given signal…

Q: Problem 2: Find ¡LOAD through RLOAD using Thevenin's theorem 12 V α we kw Μ 3Ω 6Ω 3 Ω b 50 5Ω www…

A: Solution !!

Q: series motor runs at 800 rev/min when the voltage is 400V and the current is 25A. The armature…

Q: 2. Determine the current I in each of the circuits given in Figure B. 1.5 V 7A (a) 3 A (b) Figure B.…

A: We need to find out current for given circuit .

Q: 6. A 8 bit ADC has generated a digital representation of 11001100 using the successive approximation…

A: Given : Input digital bit : 11001100 Vref=VFS=10Vn=8

Q: 1) DRAW A SCHEMATIC DIAGRAM FOR AUTOMATIC FORWARD & REVERSE MOTOR CONTROL USING LIMIT SWITCH, RELAY…

A: It is asked to draw a schematic diagram for an automatic forward and reverse motor control. We need…

Q: A 160 resistor, an 830 inductive reactance, and a 20 capacitive reactance are in series. A 120V 60Hz…

A: In this question, We need to determine the current in the circuit. We know As per ohms law,…

Q: Determine the Thevenin equivalent circuit seen by the inductor on the circuit below. 101A + IL 300…

Q: Q- A digital-to-analog converter with a full-scale output voltage of 3.5V has a resolution close to…

A: Given data- Full scale output voltage- Vfo=3.5 V, Resolution=14 mV, To Find- The bit size (n).

Q: For a pulse-amplitude modulated (PAM) transmission of voice signal having maximum frequency equal to…

Q: Find the amplitude and frequency of the following waves: 2.1. 15 sin 377t

A: In this question, We need to determine the amplitude and frequency of the given signal We know…

Q: Determine the total amount of power in the series circuit in Fig.

A: It is given that:

Q: 2. A four-pole shunt generator has a wave connected armature with 728 conductors. The flux per pole…

A: for generator , generated emf = terminal voltage + voltage drop in armature resistance . and…

Q: * The voltage Vout in the circuit shown is

A: In this question, We need to determine the voltage Vo as shown the circuit. We are solving this…

Q: Q9/C ompute the discrete-time Fourier transform of the sequence x(n). Plot DTFT magnitude and angle…

A: Given: A discrete time sequence, x[n]=n(0.9)n[u(n)-u(n-21)] To do: Compute the DTFT of x(n). Plot…

Q: Please answer this question ASAP! Thanks!

Q: In the network shown in the figure, each of the resistance is equal to 20. The resistance between…

A: Delta to star conversion- Ra=RabRacRab+Rbc+RacRb=RabRbcRab+Rbc+RacRc=RbcRacRab+Rbc+Rac

Q: Explain the characteristics of the series and compound DC generator under no-load to loaded…

Q: 40 m 10 V Figure 6.5 1202 Select one: A. 4 V B. 10 V C. 6 V D. 8 V + V₂ See Figure 6.5. What is the…

A: We need to find out the open circuit voltage for given circuit

Q: What benefits do digital systems have over analog ones?

A: here we have to write the benefits of digital systems have over analog ones.

Q: 1. Use Linearity property where Vo = 1 V is assumed to find the actual value of Vo. 2 ΚΩ 2 ΚΩ 2 ΚΩ…

Q: A 160 resistor, an 830 inductive reactance, and a 20 capacitive reactance are in series. A 120V 60Hz…

A: We need to find out the current for given circuit .

Q: A 3-phase 3-wire supply feeds a load consisting of three equal resistors connected in star. If one…

A: The given circuit is a 3 phase with 3 wire star connected load. If one of the resistor is removed…

Q: 1. Given the Circuit below, find branch currents 11, 12 and 13. 1₂. 50 15V i1 602 10Ω 10V 12 www 4Ω

Q: A 8-pole dC generator running at 1,200 rpm, and with a flux of 25 m Wb per pole generates 440 V.…

A: emf generated in dc machine = ∅NZ60×PA. where ∅ is the flux per pole . N is the speed in…

Q: 4.33 Three single-phase, 10-kVA, 2400/120-V, 60-Hz transformers are connected to form a three-phase,…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2. Minimize the following Boolean functions into product-of-sums form using a K-map a) F(a, b, c) =…

A: We need to find out the simplified product of sum expression for given Boolean function

Q: IN 7 THE Cурсист в егоw THE RESISTOR VALUES ARE UNKNOWN, BUT THE 2V SOURCE IS KNOWN TO BE SUPPLYING…

A: Given:

Q: Problem 4: Find I, using Thevenin's or Norton's theorem 3Ω 4Ω ΖΩ 10 V (+1) Μ 6A 3Ω· (+1) 8V(+ 6Ω b…

A: Solution !!

Q: Obtain the Fourier transform of the "switched-on" exponential function shown in Fig f(t) 1 0 e-ot

A: Fourier Transform convert time domain signal in to frequency domain. Spectra of function have…

Q: Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from -3.8V…

A: We need to find out the number bits per sample for given pcm signal

Question

100%

Hello Sir.
Good Evening.

I have a question in my home work related Control System Lesson. The following below is my question.
Please advise, Thank you so much.

"Give a control mechanical system and show how to get a transfer function of the system"

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Hello Sir.Good Evening. I have a question in my home work related Control System Lesson. The following below is my question.Please advise, Thank you so much.
Department of Control and Automation Subject: Control systems Principles Hello dear, I now have a very important test, and I need to answer in a short time, less than an hour And if you give me the answer within the specified time, I will like you on your answer and invite my colleagues also and thank you
Hello Sir.Good Evening. I have a question in my home work related Control System Lesson. The following below is my question.Please advise dan please advise reference too.Thank you so much.
Hello Sir.Good Night. I have a question in my home work related Control System Lesson. The following below is my question.Please advise, Thank you so much.
Hello, Please help me about this Control Theory question. Thank you.
- State the five fundamental differences between the classical control, and the intelligent control. - State the main difference between the (Fuzzy Control, Neural Net, GA).
can you help me draw an elementary line diagram of the control circuit below
(electronics) Hello dear, I now have a very important test, and I need to answer in a short time, less than an hour And if you give me the answer within the specified time, I will like you on your answer and invite my colleagues also and thank you
For the model defined in Question , is the system controllable? a.Yes b.No For the model defined in Question , is the system observable? a.Yes b.No
control systems question, step by step please.
Is Microwave Oven an open loop or closed loop system? Write the reason for your answer. For the Microwave Oven system, draw a simple block diagram with the name of input, output and control system used
Q about Control Systems. Looking for only SECOND question's answer