How do you realize a subtractor using full adder?What is a ripple Adder? What are its disadvantages?

as per the guidelines we need to solve only first question. we need to design full subtractor using…

Answered: How do you realize a subtractor using…

Engineering

Electrical Engineering

How do you realize a subtractor using full adder?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.2P: An ideal transformer with N1=1000andN2=250 is connected with an impedance Z22 across winding 2. If...

See similar textbooks

Related questions

Q: APPSKIYchhop's Law's do the creuit shown în figure below then Iind the braneh cuVents: 152 302 A…

Q: 2. Utilities may use the Open-Wye/Open-Delta connection for three-phase transformers when…

A: a) Determine the voltages, here it is tapped at 12: Van=-VAN×240120×12=-12.47 kV (negative sign due…

Q: Determine the Branch Currents using Kirchhoff’s Laws: a.) Branch bd b.) Branch cd c.) Branch ca

A: Assigning current to the three different loops as shown in the figure- Applying KVL to each loop,…

Q: A linear transformer reflects, Select one: O a. The conjugate of the mutual impedance of the…

A: The linear transformer reflects the conjugate of the self-impedance of the secondary circuit into…

Q: Mason's rule.

Q: Obtain the Clased Loop traaster fuachion Ris) by using Mason's larmula fy th splam belouws -H

Q: Q10. In a transformer modeling, the value of the impedance referred to primary side is N/N2 P* Z2…

Q: (2). Let Xle) be a broadly statronary process with the autocorelatron functron Rx (C). Show that of…

A: We need to prove the given statement. We know the formula for auto correlation function.

Q: 100Vp-p 1:1 www. V1 一「 V2 I

Q: Draw the architecture of SAP1 & SAP2 and write down the difference between them.

A: The architecture of SAP-1 Architecture of SAP-2

Q: An ideal transformer with a 500 turns primary and 125 turns secondary windings delivers 400W to a…

Q: using the transformation ratio equations find the currents I1 and I2 of each of the transformers.…

Q: H.wlsवे The minium Mu Multy plexers using to design 128 to 1 multy plexer are. ?

A: Given: 128×1 MUX MUX: MUX is also known as multiplexer. Multiplexer combining multiple inputs into a…

Q: What the value of i6 ?

A: Given that Electrical network as follows

Q: Suppose that we need to cause a 25 Ω load resistance to appear as a 100 Ω resistance to the source.…

A: The expression for the total load is given as, The expression for power is given as, The 25 Ω is…

Q: In source transformation theorem, what kind of sources that can be transformed ? O a. Independant…

A: Source transformation is an method in which if there is an current source with parallel resistor…

Q: In the transformer circuit below, determine the value of Vp and Ip to maintain a voltage of 230V…

Q: With V,- 2= sinzt, find the value that of C will cause the maximum Powed in the load vesistence.…

Q: Cite practical applications of Kirchhoff’s Laws and Divider Rules.

A: Kirchhoff's laws: 1) Kirchhoff's current law: According to this law, the sum of total incoming and…

Q: find the gener al solution of the se c on d order n on - homo qgeneous ineor differential equaAion…

Q: Find diz = Is/I, in the figure Shour %3D 2Ta 2227 エ( 1/2 222

Q: C2 (i). Draw the transfer characteristics and explain the working of differential transformer and…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: 3. An ideal transformer with a 500 turns primary and 125 turns secondary windings delivers 400W to a…

Q: Describe briefly, with the aid of suitable diagrams the cascade arrangement of transformers to…

Q: Find the equivalent resistance and total current using delta-wye or wye-delta transformations.

Q: what are the methods of generation AM-SSB

Q: how to solve current l3,l4, and l5.Assume l1=3A using kirchhoffs law and ohms law.

A: The current-voltage relationship of a resistor is given by Ohm's Law. The law states that the…

Q: For the figure shown below find I and V in the secondary side. Necessary information's are shown in…

A: Let the number of turns on primary and secondary sides be N1 and N2

Q: I need help finding the Phasor Voltage Values of Vs, V1, and VL for this step down transformer.

Q: For the circuit shown in figure, derive a-Z1 and Zo b-Ay and A1 c-Vo.

Q: For load flow solution the quantities specified at a load bus are: P and | V| P and ŏ. P and Q Q and…

A: The explanation is as follows.

Q: A real transformer has Np-500, Ns=100, Rp=3.52, Rs-22, Xp%-D202, and Xs-82. A 65V RMS source and a…

Q: 2. Solve for the branch circuits using Kirchhoff's Laws

Q: "The purpose of the short circuit test of a transformer is to determine equivalent resistance,…

A: Short circuit test is conducted on high voltage side by short circuiting low voltage side.

Q: Find the equiralont resistonce of dhia ctt r2k ere connected to an AMMA K. ANM-

Q: 7 - segment dis pley digital Cincuit :- Truuth table Numben on A Displey A e 1 1 3 4 5 1. Booleam…

A: Demorgan' theorem: (A+B)'= A'.B' (A.B)'=A'+B'

Q: Which of the following statements is true about an ideal transformer? O It changes the magnitude of…

A: Ideal Transformer is an electrical device which is used in electrical system for the ome main…

Q: Find a non zero unit vecor ôî that is orthogonal to u1= (1,2,1) and u2= (2,5,4) in R³.

A: Find a non zero unit vector V that is orthogonal to u1(1,2,1) and u2 (2,5,4) in R3.

Q: Deduce the emf equation of a transformer. Prove that the emf induced in the windings of a…

Q: An ideal transformer with a 500 turns primary and 125 turns secondary windings delivers 400W to a 4Ω…

Q: Find out the equivalent inductance for the combination when 2 inductances L1 and L2 are connected in…

A: Note as there two different questions and we are asked to solve one question at a time. So repost…

Q: Discuss the importance of Energy Storage in Microgrids.

A: Energy storage means save the energy at the present time and used it for the future purpose whenever…

Q: Compute the value of the following twiddle factor: W4 16

A: In this case, the following twiddle factor is to be determined:

Q: The full-load copper loss of a transformer is 1600 W. At half-load, the copper loss will be Select…

A: Given information, At half load,

Q: In a transformer, fl/N1 is equal to f2/N2 where fl, and f2 are frequencies associated with the…

A: For transformer primary side frequency is same as secondary side frequency And V1/N1 is same as…

Q: Identify the correct junction and loop rules, the solve for the missing currents using Kirchhoff’s…

Q: Show complete solution. Using Kirchhoff's circuit laws, find a. l₁ b. 1₂ C. 13 d. 14 e. Is

A: Given:

Q: a) What is Routh Array2 b) How to find the number of roots on right side using the Routh Array?-

A: Need to find what is Routh array and how to find number of roots on right side using Routh array

Q: figure the S-parameters for an ideal transformer with turn ratio N = N1:N2 where N1 is the no. of…

A: S- parameters is a scattering parameter it describe the linear behaviour of electrical network .…

Q: Which of the following statements is true about an ideal transformer? O It changes the magnitude of…

A: Choose the correct option Which of the following Statments is true about an ideal transform.

Question

How do you realize a subtractor using full adder?
What is a ripple Adder? What are its disadvantages?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source whose voltage is e1(t)=100(1| t |)volts for 1t1ande1(t)=0 for | t |1 second. A2- farad capacitor is connected across winding 2. Sketch e1(t),e2(t),i1(t),andi2(t) versus time t.
An ac resistance is higher than a dc resistance. True False
An ideal transformer with N1=1000andN2=250 is connected with an impedance Z22 across winding 2. If V1=10000VandI1=530 A, determine V2,I2,Z2, and the impedance Z2, which is the value of Z2 referred to the primary side of the transformer.
Reconsider Problem 3.29. If Va,VbandVc are a negative-sequence set, how would the voltage and current relationships change? (a) If C1 is the complex positive-sequence voltage gain in Problem 3.29 and (b) if C2 is the negative sequence complex voltage gain, express the relationship between C1andC2
a. What is Vs?b. Solve for thew load impedence Z_L.c. What is the value of the load impedance when referred to the high-voltage side of the transformer?
figure the S-parameters for an ideal transformer with turn ratio N = N1:N2 where N1 is the no.of turns of the primary winding and N2 is the no. of turns of the secondary winding.
Write down the effect of ‘Load Tap Changer (LTC)’ on voltage stability and analyze it using P-U (nose) curve .
What are advantages of transfering parameter from 1 side of transformer to other side? Subject Electrical Machine
I need help finding the Phasor Voltage Values of Vs, V1, and VL for this step down transformer.
In a practical transformer, Identify, which component of no load current supplies eddy current loss? a. I0 b. IC c. IM d. None of these
A transformer is needed that will cause an actual load resistance of 25 Ω to appear as 100 Ω to an ac voltage source of 240 V rms. Draw the diagram of the circuit required. What turns ratio is required for the transformer? Find the current taken from the source, the current flowing through the load, and the load voltage.
using the Delta to Wye Conversion and Wye to Delta Conversion show all possible steps, please.