Question

How many orbitals in an atom can have the designation of 3px?

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Science
Chemistry

Related Chemistry Q&A

Find answers to questions asked by students like you.

Q: The energy required to remove the 3s electron from a sodium atom in its ground state is about 5 eV. ...

A: Electronic configuration of sodium is:

Q: 12. While each molecule below has more protons (H-atoms) than being shown, just focus on the protons...

A: More acidic protons can be identified as,

Q: A). The density of osmium is reported by one source to be 22,610kg/m3. What is the density in g/cm3?...

A: A.) The density of osmium is reported by one source to be 22,610kg/m3. This is to be converted into ...

Q: The maximum wavelength of light that a certain silicon photocell can detect is 1.11 μm. (a) What is ...

A: The energy difference between the top valence band and bottom of conduction band in terms of wavelen...

Q: What are the important diagnostic peaks in this IR spectra? Fingerprint region <1500cm^-1 is not ...

A: The important diagnostic peaks in given IR spectra is given in step two.

Q: Question 6 The rate at which a certain drug is eliminated by the body follows first-order kinetics, ...

A: The rate constant (k) for the elimination of drug follows first order kinetics which can be calculat...

Q: Use the electron configurations of Si and O to explain why these atoms combine chemically in a one-t...

A: The electron configuration of Si and O atoms are given below.

Q: 16. Determine if the protons are on or off at a pH = 6.0 and then draw the predominant form. pKa = 9...

A: Every amino acid has a carbonyl group and an amino group, and each group can exist in an acidic form...

Q: Fe(II) can be precipitated from a slightly basic aqueous solution by bubbling oxygen through the sol...

A: Click to see the answer

Q: How are parts by mass and parts by volume used in calculations?

A: Parts by mass and volume in calculations:Parts by mass and parts by volume are units of expressing s...

Q: how do you convert 3.8 Km/s to m/year     step by step. please and thank you!

A: Click to see the answer

Q: How do I show my work for (4 x 103) / (2 x 106)?

A: Given,

Q: Write the balanced molecular and net ionic equations for the reaction between aluminum metal and sil...

A: Click to see the answer

Q: What is the effect of a nonvolatile solute on the vapor pressure of a liquid? Why is the vapor press...

A: While adding the non-volatile solute into the solvent, the tendency of solvent molecule to evaporate...

Q: During exercise when the body lacks an adequate supply of oxygen to support energy production, the p...

A: Given,

Q: Find the pH of a 0.600 M solution of methylamine CH3NH2. Kb = 4.4 x 10-4. %3D

A: Given,Concentration of methylamine = 0.600M.Kb = 4.4*10-4. 

Q: Select the choice in which atomic number, mass number, number of neutrons, and number of protons lis...

A: Option (b):Mass number of phosphorous= 32.Atomic number of phosphorous= 15.Number of protons of phos...

Q: A chemist prepares a solution of barium chloride (BaCl2) by measuring out 40.g of barium chloride in...

A: Given,Mass of barium chloride = 40g.Volume of water = 350mL.The moles of barium chloride can be calc...

Q: When a solution containing 8.00 g of NaOHNaOH in 50.0 g of water at 25.0 ∘C is added to a solution o...

A: The heat released by the reaction can be calculated as follows:

Q: What is the best way to increase the solubility of a gas in a solvent in which the gas does not reac...

A: Solubility of gas is defined as the the amount of gas that gets dissolved in solvent. 

Q: I need help solving the problem. For 2) what value do I  use for a? 4) am I to use the tables labele...

A: Any value of ‘a’ can be taken to calculate ψ because the value of x is in terms of ‘a’, so the term ...

Q: A sample of an unknown compound contains 0.21 mol of zinc, 0.14 mol of phosphorus, and 0.56 mol of o...

A: Given,Moles of zinc = 0.21mol.Moles of phosphorus = 0.14mol.Moles of oxygen = 0.56mol.

Q: Carbohydrates serve as a vital source of chemical energy to the human body. Carbohydrates are broken...

A: Given,Energy = 187kJ.

Q: Instant hot packs contain a solid and a pouch of water. When the pack is squeezed, the pouch breaks ...

A: The reaction is given below.LiCl (s)  -->  Li+(aq) + Cl−(aq)         ΔH=  −36.9kJHeat of reaction...

Q: I don't know where to start.

A: Using the given data, graph can be drawn by plotting pressure against volume and is given below:

Q: Is this the correct synthesis of the proposed reaction?

A: Based on the given reaction, all the steps seems to be fine except the oxidation of methyl group to ...

Q: 5263 in2 to ft2

A: The given conversion is performed in step two.

Q: Calculate the mass (g) of MgCO3 precipitated by mixing 10.00 mL of a 0.200 M Na2CO3 solution with 5....

A: The chemical reaction between Na2CO3 and Mg(NO3)2 is shown below.

Q: Use the electron configurations of H and O to explain why these atoms combine chemically in a two-to...

A: Click to see the answer

Q: Which of the following will have the lowest boiling point? I.                     CH3(CH2)3 CH3 II. ...

A: The compound that will have the lowest boiling point is to be determined-CH3(CH2)3CH3CH3CH2CH3CH3CH2...

Q: Consider this molecular-level representation of a mixture of gases. If the partial pressure of the d...

A: The given figure has three types of particles, single blue, single orange and double green.The singl...

Q: Mass solute needed to prepare 0.500L of 0.2 M NaCO3

A: Click to see the answer

Q: What is the pH of a solution made by adding 23.5 g of KC2H3O2 to 400 mL of 0.80 M HC2H3O2? (Ka for a...

A: Molarity of KC2H3O2 is calculated as follows:

Q: A NaOH solution is labeled as 6.75 M, what is its molality? Density of the solution is measured at 1...

A: Given that the molarity of the solution is 6.75 M and the density of the solution is given as 1.04g/...

Q: A. From the graph, estimate the normal boiling point of substance X.  B. From the graph above, estim...

A: Boiling occur when vapor pressure become equal to atmospheric pressure. So, boiling point of each ca...

Q: The world record for the hundred meter (exact) dash is 9.58 s. At this speed, how long would it take...

A: The speed of the object is equal to the ratio of the distance covered by the object to the time take...

Q: Draw the product of the following reaction. PdL2 (CH;CH2)3N

A: Click to see the answer

Q: Rhodium has a density of 12.41g/cm^3 and crystallizes with the face-centered cubic unit cell. Calcul...

A: For an atom that crystallizes in a face centered cubic lattice, there will be 8 atoms on the corners...

Q: Is this the correct way that the mechanism works?

A: Structure of indole is given below.

Q: • 3. Two solutions are prepared using the same solute: Solution A: 0.14 g of the solute dissolves in...

A: When a non-volatile solute is added to a solvent, then occurs a decrease in the freezing point of so...

Q: What is the pH of a 0.22M NaH2PO4 solution?

A: NaH2PO4 is a weak.Ka for NaH2PO4 is 6.23×10-8.Calculate concentration of H3O+:

Q: Generally speaking, are fatty acid molecules polar or nonpolar or both? What type of forces hold the...

A: Fatty acids consist of long hydrocarbon chain attached to carboxyl group.  Fatty acids are the struc...

Q: or dodecane (C12H26)? 3. Which hydrocarbon would be more Explain your reasoning. viscous, heptane (C...

A: Viscosity depends on the strength of the intermolecular forces present in the molecules of the compo...

Q: + 4 Cl–   CoCl42–  + 6H2O (pink)     (blue)   When cobalt(II) chloride is added to pure wa...

A: The reaction is given below.

Q: A sample of solid NH4NO3 was placed in an evacuated container and then heated so that it decomposed ...

A: A sample of solid NH4NO3 was placed in an evacuated container and then heated so that it decomposed ...

Q: Fory Liters (40 L) of a gas were collected over water when the barometer read 622.0 mm Hg and the te...

A: 1 mm Hg = 133.322 PaTherefore 622 mm Hg = 622 x 133.322 Pa = 82926.2 PaVapor pressure of water at 20...

Q: The reactant concentration in a first-order reaction was 9.00×10−2 MM after 15.0 ss and 9.20×10−3 MM...

A: The equation for first order reaction is:

Q: What is the number formula units in a 9.99 mol sample of CaO

A: Relationship between number of moles and formula units is given below:

Q: Draw the ether formed when ethyl alcohol is heated in the presence of concentratedd sulfuric acid.

A: Ether is formed when ethyl alcohol is heated in presence of sulfuric acid.

Q: Determine the molarity of each of the following solutions from its osmotic pressure at 25°C. Include...

A: The molarity of the solution of urea can be calculated as